Effect of Real Power Loss Allocation on the Transfer Bus with Zero Injection Power

Author(s):  
Ganiyu Adedayo Ajenikoko ◽  
Olayinka Titilola T

Loss allocation in electrical power transmission system has a significant role to play in the restructuring of electricity market since generator and demands are connected to the same network. There is the need for an efficient loss allocation scheme that could fit all market structures in different locations. This paper presents the effect of real power loss allocation on the transfer bus with zero injection power. Three approaches- the postage stamp method (PS), proportional sharing principle (PSP) or flow tracing method and the Bus-wise loss allocation (BWLA) method were compared using appropriate mathematical notations for the development of a Hybridized real power loss allocation model. The average values of the losses with the three methods –PS, PSP and BWLA were computed to obtain the hybridized real power loss allocation model. The effect of real power loss allocation on the transfer bus with zero injection power is then established. The results of the work show that in PSB method, a loss of 3.0751MW was allocated to bus 1 as it contributes 142.608MW to other loads with the allocation of 1.8523MW to bus 2 with the contribution of 55MW to the other loads. In BWLA method a loss of 3.1412MW was allocated to bus 1 with its contribution of power flow to the other loads as 146.908MW while allocating a loss of 1.2381MW to bus 2 with its contribution of power flow to other loads as 58MW. In the PS method, the participants with more contributions get more benefits compared to participants with lesser contributions. Though, network is taken into consideration in PSB, customers have no reasonable benefits as compared to the BWLA method compared to the other two approaches. The total real power loss of 25.18MW for the 30 bus system was obtained by using PS. PSP and BWLA method. All the three methods, PS, PSB and BWLA allot zero loss to the transfer bus which has zero injection power. In PSB method, negative losses ( counter-flows) occur when number of buses increases and in BWLA  method, negative losses (counter flows) never occur even though there is an increase in the number of buses.

2013 ◽  
Vol 805-806 ◽  
pp. 747-750
Author(s):  
Xi Chao Zhou ◽  
Cai Liang ◽  
Wen Ying Liu ◽  
Jian Hua Zhang

This paper presents a new procedure for allocating transmission losses to generators and loads. Based on the superposition theorem, the paper proposes that electrical power flow in transmission line can be separated into a series of power component induced by each individual power supplies, and transmission line power losses can be separated into a series of power loss component induced by each individual power supplies. Thus, each power supplys contribution to the branch power loss is resolved. Based on the theory founded above, corresponding loss allocation model is established. Results illustrate the validity and rationality of the new allocation process with expected results.


Author(s):  
M. Packiasudha ◽  
S. Suja

In the deregulating electricity market, many private sector power producers are participating actively. With growing number of the wind mills and solar power generation, the reactive power production will be more because of induction generator and inductive type load. Many blackouts have happened in the past decades due to more reactive power which lead to a decrease in the magnitude of real power. It is very essential to compensate the reactive power, increase the real power flow in the transmission line, increase the transmission efficiency, improve the system stability and be in a safer place to save the fossil fuels for the future. In this paper the importance of reactive power and its various compensation techniques are applied to a five bus deregulated test case modeled and analyzed. The simulations were done using Matlab Simulink, for various FACT controllers such as STATCOM, SVC, SSSC and UPFC compensation and the results were tabulated and compared.


Author(s):  
Prakash Kumar Hota ◽  
Atulya Prasad Naik

This paper presents a new method for transmission loss allocation in a deregulated power system. As the power loss is a nonlinear quantity, so to allocate the loss in a common transmission corrider is a difficult task. It allocates transmission losses to loads based on the actual power flow in the lossy lines due to the concerned load. Each lossy line is subdivided into as many sub-lines as corresponding to the numbers of load attached to it. The tracing of power flow through each sub-line is worked out by using proportional sharing method. The power loss in each lossy line is equal with the total loss due to all the sub-lines under it. Then by using Pro-rata for each lossy line, the individual loss for each sub-line is formulated. As the application of Pro-rata is limited to an individual line of the system, so the error in calculation is minimized. The total loss allocated to a particular load is the sum of losses occurred in each lossy lines through which the power is flowing to the concerned load. As this method is based on the actual flow of power in the transmission line corresponding to the concerned load, hence, the loss allocation made by the method gives proper and justifiable allocations to the different loads which are attached to the system.<strong> </strong>The proposed method is applied to a six-bus system and finds the mismatch in the commonly used methods. Then, it is applied to higher bus systems in which more accurate results are obtained compared to the other methods.


2014 ◽  
Vol 573 ◽  
pp. 310-316 ◽  
Author(s):  
K. Poun Raj ◽  
V. Raja Sekaren ◽  
S. Selvaperumal ◽  
N. Mageswari

– The unified power flow controller (UPFC) is the most versatile and complex power electronic equipment that has emerged as the indispensable equipment for the control and optimization of power flow in electrical power transmission system. In this manuscript is investigated the control of real and reactive power flow through a transmission line with the use of UPFC at the sending end. Computer simulation using MATLAB Simulink is done and the behavior of the UPFC is studied. In the UPFC based control of transmission line parameter control systems, it is observed that whenever the SSSC sources some real power into the transmission line it is manifested as a voltage drop across the DC link. Reactive power demand is indicated as fall in the bus bar AC voltage. The fall of the DC link voltage is an indication of real power demand from the receiving end. Similarly a fall of the bus bar AC voltage is an indication of reactive power demand from the receiving end. Fuzzy Logic and PI controllers are used in this works, the control of DC voltage, AC voltage and power transfer.


2020 ◽  
Vol 7 (2) ◽  
pp. E1-E6
Author(s):  
L. Kanagasabai

This paper aims to use the Rock Dove (RD) optimization algorithm and the Fuligo Septica optimization (FSO) algorithm for power loss reduction. Rock Dove towards a particular place is based on the familiar (sight) objects on the traveling directions. In the formulation of the RD algorithm, atlas and range operator, and familiar sight operators have been defined and modeled. Every generation number of Rock Dove is reduced to half in the familiar sight operator and Rock Dove segment, which hold the low fitness value that occupying the lower half of the generation will be discarded. Because it is implicit that the individual’s Rock Dove is unknown with familiar sights and very far from the destination place, a few Rock Doves will be at the center of the iteration. Each Rock Dove can fly towards the final target place. Then in this work, the FSO algorithm is designed for real power loss reduction. The natural vacillation mode of Fuligo Septica has been imitated to develop the algorithm. Fuligo Septica connects the food through swinging action and possesses exploration and exploitation capabilities. Fuligo Septica naturally lives in chilly and moist conditions. Mainly the organic matter in the Fuligo Septica will search for the food and enzymes formed will digest the food. In the movement of Fuligo Septica it will spread like a venous network, and cytoplasm will flow inside the Fuligo Septica in all ends. THE proposed RD optimization algorithm and FSO algorithm have been tested in IEEE 14, 30, 57, 118, and 300 bus test systems and simulation results show the projected RD and FSO algorithm reduced the real power loss. Keywords: optimal reactive power, transmission loss, Rock Dove, Fuligo Septica.


2019 ◽  
Vol 8 (3) ◽  
pp. 6724-6727

In a present day a necessity for fair allocation of transmission loss in a deregulated electricity market. This paper presents modifiedZbus loss allocation method to calculate the allocation of transmission loss loss . The procedure depends on straightforward circuit laws and doesn't include any suppositions. results obtained for IEEE 14 Bus system are analysed with the other present methods


Now days’ electrical power requirement has enlarged expanding as expansion & restructuring of electrical power system (PS) for generation & transmission in power sector is critically limited due to current resources & environmental circumstances. As outcome, approximately of corridors of power transmission overhead lines are greatly loaded & congested. Also major issue of power system voltage stability becomes power transfer restricted and capability issue. A Modern power electronics technology FATCS considered device Static Synchronous Series Compensator (SSSC) is VSC demanded series FACTS equipment. Unified power flow controller (UPFC) is to manage power flow (PF), voltage magnitude & phase angle. In this research paper suggested to maintain voltage magnitude as well as PF of faulty lines. The consequence of mutation of PS parameters like voltage, phase angle, active power, reactive power, & overall power factor with & without SSSC & UPFC have also incorporated. Assessment of PS safety is essential in society to expand customs to sustain system functions when one or more components fail. A PS is "secure" when it can defy loss of one or more ingredients & still go on working without major problems. The Contingency event investigation technique is taken to identify electrical node PF in faulty transmission lines (TL). The Performance of PS has been tested on IEEE 14-Bus System.


2012 ◽  
Vol 516-517 ◽  
pp. 1425-1428
Author(s):  
Li Ming Wei ◽  
Jun Lin

The introduction of distributed generation will bring new challenges to the theory of power electricity market. The problem of loss allocation is one of them. In the paper three contents are introduced. Firstly, a loss allocation method is proposed for power distribution network with distributed generation. Secondly, the changes of loss allocation which introduction of distributed generation before and after brings about are analyzed and compared and relevant conclusions are obtained. Lastly, a typical mini-grid with a distributed generation is simulated. Simulation results prove the correctness and feasibility of the method.


Sign in / Sign up

Export Citation Format

Share Document