scholarly journals Comparison between turbulence eddy dissipation rates retrieved by wind profiler radar and in situ radiosondes

2016 ◽  
Vol 66 (0) ◽  
pp. 39-55 ◽  
Author(s):  
Shunsuke HOSHINO ◽  
Hiromasa KOBAYASHI ◽  
Tetsuji KOIKE ◽  
Hiroyuki HASHIGUCHI ◽  
Seiji KAWAMURA ◽  
...  
2014 ◽  
Vol 7 (1) ◽  
pp. 135-148 ◽  
Author(s):  
M. Maruri ◽  
J. A. Romo ◽  
L. Gomez

Abstract. It is well known in the scientific community that some remote sensing instruments assume that sample volumes present homogeneous conditions within a defined meteorological profile. At complex topographic sites and under extreme meteorological conditions, this assumption may be fallible depending on the site, and it is more likely to fail in the lower layers of the atmosphere. This piece of work tests the homogeneity of the wind field over a boundary layer wind profiler radar located in complex terrain on the coast under different meteorological conditions. The results reveal the qualitative importance of being aware of deviations in this homogeneity assumption and evaluate its effect on the final product. Patterns of behavior in data have been identified in order to simplify the analysis of the complex signal registered. The quality information obtained from the homogeneity study under different meteorological conditions provides useful indicators for the best alternatives the system can offer to build wind profiles. Finally, the results are also to be considered in order to integrate them in a quality algorithm implemented at the product level.


Author(s):  
M. Satyavani ◽  
P. S. Brahmanandam ◽  
P. S. V. Subba Rao ◽  
M. P. Rao

This study reports diurnal variations of wind directions, wind speed of vector winds, and the evolution of boundary layer (BL) over a mid-latitude measured using a transportable 1290 MHz wind profiling radar located at Cardington (Lat. 52.10ºN; Long. 0.42ºE), Bedfordshire, UK from 17 to 28 April 2010. The horizontal winds show benign behavior during nighttime hours, while winds during daytime hours had magnitudes around, on average, 10-20 m/s, in the majority of the cases. The heights of the boundary layer (BL) varied from as low as ~1100 m to ~2600 km and BL height had shown to have evolved from 0700 universal time (UT) onwards and collapsed by 0000 UT.  Besides, a comparison made between winds measured by the 1290 MHz radar and near-by radiosonde showed a moderate similitude between them, albeit a few discrepancies are found in wind directions and speeds. The possible reasons for these discrepancies could be different volume sensing of observations of these independent observations. An attempt is, therefore, made to calculate radiosonde balloon drifts [1] for the ascending node of the balloons, which had confirmed that the balloons often drifted horizontally as long as up to 100 km. The large drifts, most probably, are the possible reasons for the mismatching of winds measured by these two independent remote sensing instruments.


2008 ◽  
Vol 35 (24) ◽  
Author(s):  
C. J. Pan ◽  
H. C. Lai ◽  
S. S. Yang ◽  
K. K. Reddy ◽  
S.-C. Chang

2010 ◽  
Vol 27 (10) ◽  
pp. 1652-1664 ◽  
Author(s):  
Ewan J. O’Connor ◽  
Anthony J. Illingworth ◽  
Ian M. Brooks ◽  
Christopher D. Westbrook ◽  
Robin J. Hogan ◽  
...  

Abstract A method of estimating dissipation rates from a vertically pointing Doppler lidar with high temporal and spatial resolution has been evaluated by comparison with independent measurements derived from a balloon-borne sonic anemometer. This method utilizes the variance of the mean Doppler velocity from a number of sequential samples and requires an estimate of the horizontal wind speed. The noise contribution to the variance can be estimated from the observed signal-to-noise ratio and removed where appropriate. The relative size of the noise variance to the observed variance provides a measure of the confidence in the retrieval. Comparison with in situ dissipation rates derived from the balloon-borne sonic anemometer reveal that this particular Doppler lidar is capable of retrieving dissipation rates over a range of at least three orders of magnitude. This method is most suitable for retrieval of dissipation rates within the convective well-mixed boundary layer where the scales of motion that the Doppler lidar probes remain well within the inertial subrange. Caution must be applied when estimating dissipation rates in more quiescent conditions. For the particular Doppler lidar described here, the selection of suitably short integration times will permit this method to be applicable in such situations but at the expense of accuracy in the Doppler velocity estimates. The two case studies presented here suggest that, with profiles every 4 s, reliable estimates of ε can be derived to within at least an order of magnitude throughout almost all of the lowest 2 km and, in the convective boundary layer, to within 50%. Increasing the integration time for individual profiles to 30 s can improve the accuracy substantially but potentially confines retrievals to within the convective boundary layer. Therefore, optimization of certain instrument parameters may be required for specific implementations.


Sign in / Sign up

Export Citation Format

Share Document