R&D activities and some development are performed at CEA on the brittle crack propagation and arrest. Phenomena occurring after the initiation of a brittle crack are not yet well understood. Absence of model able to predict the rapid growth of a brittle crack motivates this study. Due to the rapid growth of the crack, inertial effects and dynamic fracture should be considered. Assumption of a linear elastic solid are often preferred, but when plasticity of the material become non negligible (which is the case in the vicinity of the transition zone), these models become more limited. That’s why the paper presented here deals with dynamic crack propagation in elastic-viscoplastic material and aims at proposing a model able to predict the brittle crack propagation and arrest. To this end, experimental work is carried out for different geometries made of french RPV ferritic steel. Compact Tension specimens with different thickness, isothermal rings under compression with different positions of the initial defect to study also a mixed mode configuration. The test conditions and mains results (crack initiation, crack velocity measurements, ...) are collected and presented in a first part of the paper. To model efficiently the crack propagation in the Finite Element calculation, the eXtended Finite Element Method (X-FEM) implemented in the CEA F.E. software CAST3M is described in the second part of the paper. Thanks to this numerical technique, the crack path does not need to follow the element edges and the crack progress is directly incorporated in the degrees of freedom of the elements crossed by the crack. A two-steps methodology is presented in the third and fourth parts of this paper. The first step consider only the CT specimen, experimental crack speed evolution with time is imposed in numerical simulations. Energy terms and stress field at the crack tip are evaluated and discussed to build up a criterion. Then, the criterion identified on CT specimen is used in a second step as a predictive model to simulate crack propagation for each geometry studied (CT, ring in both mode I and mixed mode). In particular, crack propagation models based on the stress field evaluated at the crack tip and on a critical cleavage stress dependent on the strain rate, exhibit very good agreement with experimental data in term of crack speed, crack path and crack length at arrest. The mixed mode case is discussed in detail because to be pertinent, a model of brittle crack propagation should not only give the crack speed, but also its preferred direction of evolution.
Study on Brittle Crack Propagation and Arrest Behavior in Plates and Beams Structure (1 st. report)
