scholarly journals Excitation of the Round Infinite Impedance Cylinder by Internal Extrinsic Current: Far-Field Radiation

2021 ◽  
Vol 7 (3) ◽  
pp. 47-54
Author(s):  
M. Protsenko
Keyword(s):  
Approximate Solution ◽  
Electric Dipole ◽  
Complete System ◽  
Formal Solution ◽  
Arbitrary Distribution ◽  
Far Field ◽  
Dielectric Cylinder ◽  
Directional Diagram ◽  
Field Radiation ◽  
Impedance Cylinder

The paper considers the method of solving the problem of excitation a circular infinite impedance cylinder by means of extrinsic current with an arbitrary spatial orientation. The formal solution of the problem is based on the method of expanding the fields in a complete system of eigenfunctions. Arbitrary distribution of extrinsic currents is taken into account factors excitation. An approximate solution of the problem in the far field is presented. The effect of a dielectric cylinder on the directional diagram of an axial electric dipole is studied.

The shape of things to come — Development and testing of a new marine vibrator source

2019 ◽  
Vol 38 (9) ◽  
pp. 680-690 ◽  
Author(s):  
Benoît Teyssandier ◽  
John J. Sallas
Keyword(s):  
Seismic Source ◽  
Test Facility ◽  
Data Sets ◽  
Far Field ◽  
Ocean Bottom ◽  
Air Gun ◽  
Seismic Image ◽  
Field Radiation ◽  
Technical Issues ◽  
To Come

Ten years ago, CGG launched a project to develop a new concept of marine vibrator (MV) technology. We present our work, concluding with the successful acquisition of a seismic image using an ocean-bottom-node 2D survey. The expectation for MV technology is that it could reduce ocean exposure to seismic source sound, enable new acquisition solutions, and improve seismic data quality. After consideration of our objectives in terms of imaging, productivity, acoustic efficiency, and operational risk, we developed two spectrally complementary prototypes to cover the seismic bandwidth. In practice, an array composed of several MV units is needed for images of comparable quality to those produced from air-gun data sets. Because coupling to the water is invariant, MV signals tend to be repeatable. Since far-field pressure is directly proportional to piston volumetric acceleration, the far-field radiation can be well controlled through accurate piston motion control. These features allow us to shape signals to match precisely a desired spectrum while observing equipment constraints. Over the last few years, an intensive validation process was conducted at our dedicated test facility. The MV units were exposed to 2000 hours of in-sea testing with only minor technical issues.

Radiation from supersonic faulting

1971 ◽  
Vol 61 (4) ◽  
pp. 1009-1012 ◽  
Author(s):  
J. C. Savage
Keyword(s):  
Initial Point ◽  
Step Function ◽  
Fault Model ◽  
Dislocation Segment ◽  
Far Field ◽  
Fault Propagation ◽  
Unit Step ◽  
Propagation Factor ◽  
Double Couple ◽  
Field Radiation

abstract The far-field radiation from a simple fault model is given by the radiation pattern associated with the appropriate strain nucleus (e.g., double couple) multiplied by a fault propagation factor. For a unilateral fault model the propagation factor is F ( c ; t ) = ζ bd [ H ( τ ) − H ( τ − ( L / ζ ) ( 1 − ( ζ / c ) cos ψ )) ] / ( 1 − ( ζ / c ) cos ψ ) where ξ is the velocity of fault propagation, b is the fault slip, d is the fault width, τ = t − r0/c, r0 is the distance of the observer from the initial point of faulting, c is the velocity of the seismic wave, H(τ) is the unit-step function, L is the length of the fault, and ψ the angle between r0 and the direction of fault propagation. This representation is valid for both subsonic and supersonic fault propagation. The latter case is important because Weertman (1969) has recently shown that spontaneous faulting may propagate at supersonic velocities. Because the propagation factor is always positive, the nodal planes for the radiation are the same as for the appropriate strain nucleus. Finally, it is shown by the application of this equation that the radiation from a screw dislocation segment is represented by the double-couple nucleus, not the compensated linear-vector dipole nucleus as recently suggested by Knopoff and Randall (1970).

scholarly journals Light-Emitting Metasurfaces: Simultaneous Control of Spontaneous Emission and Far-Field Radiation

Nano Letters ◽  
2018 ◽  
Vol 18 (11) ◽  
pp. 6906-6914 ◽  
Author(s):  
Sheng Liu ◽  
Aleksandr Vaskin ◽  
Sadhvikas Addamane ◽  
Benjamin Leung ◽  
Miao-Chan Tsai ◽  
...  
Keyword(s):  
Spontaneous Emission ◽  
Far Field ◽  
Light Emitting ◽  
Simultaneous Control ◽  
Field Radiation

scholarly journals Scattering centers modeling of non-anechoic measurement environments

2012 ◽  
Vol 10 ◽  
pp. 69-73 ◽  
Author(s):  
K. A. Yinusa ◽  
C. H. Schmidt ◽  
T. F. Eibert
Keyword(s):  
Near Field ◽  
Field Measurements ◽  
Field Pattern ◽  
Far Field ◽  
Scattering Centers ◽  
Field Transformation ◽  
Field Radiation ◽  
Echo Suppression ◽  
Multipath Signals ◽  
Far Field Pattern

Abstract. Near-field measurements are established techniques to obtain the far-field radiation pattern of an Antenna Under Test via near-field measurements and subsequent near-field far-field transformation. For measurements acquired in echoic environments, additional post-processing is required to eliminate the effects of multipath signals in the resulting far-field pattern. One of such methods models the measurement environment as a multiple source scenario whereby the collected near-field data is attributed to the AUT and some scattering centers in the vicinity of the AUT. In this way, the contributions of the AUT at the probe can be separated from those of the disturbers during the near-field far-field transformation if the disturber locations are known. In this paper, we present ways of modeling the scattering centers on equivalent surfaces such that echo suppression is possible with only partial or no information about the geometry of the scatterers.

Moving Load on a Laminated Composite

1974 ◽  
Vol 41 (3) ◽  
pp. 663-667 ◽  
Author(s):  
C. Sve ◽  
G. Herrmann
Keyword(s):  
Dynamic Response ◽  
Half Plane ◽  
Moving Load ◽  
Formal Solution ◽  
Laminated Composite ◽  
Laplace Transforms ◽  
Layered Material ◽  
Effective Stiffness ◽  
Far Field ◽  
Numerical Examples

A solution is presented for the dynamic response of a periodically laminated half plane that consists of alternating layers of two different materials and is subjected to a moving load. The laminations are parallel to the surface of the half plane, and the velocity of the load is steady and supersonic. An effective stiffness theory developed by Sun, Achenbach, and Herrmann is used to model the layered material, and the formal solution is obtained with the aid of Laplace transforms. A far-field solution is constructed with the head-of-the-pulse procedure, and several numerical examples are presented.

Sign in / Sign up

Export Citation Format

Share Document