Understanding earthquake physics through high frequency multiple point source inversion and earthquake cycle simulation

2021 ◽  
Author(s):  
◽  
Qibin Shi
2009 ◽  
Vol 4 (2) ◽  
pp. 99-105
Author(s):  
Kazuro Hirahara ◽  

Recent earthquake cycle simulation based on laboratory derived rate and state friction laws with super-parallel computers have successfully reproduced historical earthquake cycles. Earthquake cycle simulation is thus a powerful tool for providing information on the occurrence of the next Nankai megathrust earthquake, if simulation is combined with data assimilation for historical data and recently ongoing crustal activity data observed by networks extending from the land to the ocean floor. Present earthquake cycle simulation assumes simplifications in calculation, however, that differ from actual complex situations. Executing simulation relaxing these simplifications requires huge computational demands, and is difficult with present supercomputers. Looking toward advanced simulation of Nankai megathrust earthquake cycles with next-generation petaflop supercomputers, we present 1) an evaluation of effects of the actual medium in earthquake cycle simulation, 2) improved deformation data with GPS and InSAR and of inversion for estimating frictional parameters, and 3) the estimation of the occurrence of large inland earthquakes in southwest Japan and of Nankai megathrust earthquakes.


2013 ◽  
Vol 600 ◽  
pp. 196-204 ◽  
Author(s):  
Nobuki Kame ◽  
Satoshi Fujita ◽  
Masao Nakatani ◽  
Tetsuya Kusakabe

2011 ◽  
Vol 4 ◽  
pp. 1456-1465 ◽  
Author(s):  
M. Ohtani ◽  
K. Hirahara ◽  
Y. Takahashi ◽  
T. Hori ◽  
M. Hyodo ◽  
...  

2014 ◽  
Vol 14 (18) ◽  
pp. 9755-9770 ◽  
Author(s):  
M. Maione ◽  
F. Graziosi ◽  
J. Arduini ◽  
F. Furlani ◽  
U. Giostra ◽  
...  

Abstract. Methyl chloroform (MCF) is a man-made chlorinated solvent contributing to the destruction of stratospheric ozone and is controlled under the "Montreal Protocol on Substances that Deplete the Ozone Layer" and its amendments, which called for its phase-out in 1996 in developed countries and 2015 in developing countries. Long-term, high-frequency observations of MCF carried out at three European sites show a constant decline in the background mixing ratios of MCF. However, we observe persistent non-negligible mixing ratio enhancements of MCF in pollution episodes, suggesting unexpectedly high ongoing emissions in Europe. In order to identify the source regions and to give an estimate of the magnitude of such emissions, we have used a Bayesian inversion method and a point source analysis, based on high-frequency long-term observations at the three European sites. The inversion identified southeastern France (SEF) as a region with enhanced MCF emissions. This estimate was confirmed by the point source analysis. We performed this analysis using an 11-year data set, from January 2002 to December 2012. Overall, emissions estimated for the European study domain decreased nearly exponentially from 1.1 Gg yr−1 in 2002 to 0.32 Gg yr−1 in 2012, of which the estimated emissions from the SEF region accounted for 0.49 Gg yr−1 in 2002 and 0.20 Gg yr−1 in 2012. The European estimates are a significant fraction of the total semi-hemisphere (30–90° N) emissions, contributing a minimum of 9.8% in 2004 and a maximum of 33.7% in 2011, of which on average 50% are from the SEF region. On the global scale, the SEF region is thus responsible for a minimum of 2.6% (in 2003) and a maximum of 10.3% (in 2009) of the global MCF emissions.


2014 ◽  
Vol 57 (3) ◽  
Author(s):  
Andrea Bizzarri

<p>The focus on the present study is on the point-source approximation of a seismic source. First, we compare the synthetic motions on the free surface resulting from different analytical evolutions of the seismic source (the Gabor signal (G), the Bouchon ramp (B), the Cotton and Campillo ramp (CC), the Yoffe function (Y) and the Liu and Archuleta function (LA)). Our numerical experiments indicate that the CC and the Y functions produce synthetics with larger oscillations and correspondingly they have a higher frequency content. Moreover, the CC and the Y functions tend to produce higher peaks in the ground velocity (roughly of a factor of two). We have also found that the falloff at high frequencies is quite different: it roughly follows ω<span><sup>−2</sup></span> in the case of G and LA functions, it decays more faster than ω<span><sup>−2</sup></span> for the B function, while it is slow than ω<span><sup>−1</sup></span> for both the CC and the Y solutions. Then we perform a comparison of seismic waves resulting from 3-D extended ruptures (both supershear and subshear) obeying to different governing laws against those from a single point-source having the same features. It is shown that the point-source models tend to overestimate the ground motions and that they completely miss the Mach fronts emerging from the supershear transition process. When we compare the extended fault solutions against a multiple point-sources model the agreement becomes more significant, although relevant discrepancies still persist. Our results confirm that, and more importantly quantify how, the point-source approximation is unable to adequately describe the radiation emitted during a real world earthquake, even in the most idealized case of planar fault with homogeneous properties and embedded in a homogeneous, perfectly elastic medium.</p>


2019 ◽  
Vol 105 (6) ◽  
pp. 912-917
Author(s):  
Ivan V. Andronov

The problem of diffraction of a high-frequency point source acoustic field by an infinite elliptic cylinder with a strongly elongated cross-section is studied. At every direction of propagation, the solution is shown to be similar to those of a linear source field diffraction by a cylinder with correspondingly enlarged major semiaxis.


Sign in / Sign up

Export Citation Format

Share Document