scholarly journals Adsorptive Cathodic Stripping Voltammetry for Quantification of Alprazolam

Molecules ◽  
2021 ◽  
Vol 26 (10) ◽  
pp. 2958
Author(s):  
Waree Boonmee ◽  
Kritsada Samoson ◽  
Janjira Yodrak ◽  
Adul Thiagchanya ◽  
Apichai Phonchai ◽  
...  
Keyword(s):  
Cyclic Voltammetry ◽  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Electrochemical Impedance ◽  
Stripping Voltammetry ◽  
Spectrometric Method ◽  
Carbon Electrode ◽  
Mass Spectrometric Method ◽  
Cathodic Stripping Voltammetry ◽  
Cathodic Stripping

A simple and highly sensitive electrochemical sensor was developed for adsorptive cathodic stripping voltammetry of alprazolam. Based on an electrochemically pretreated glassy carbon electrode, the sensor demonstrated good adsorption and electrochemical reduction of alprazolam. The morphology of the glassy carbon electrode and the electrochemically pretreated glassy carbon electrode were characterized by scanning electron microscopy/energy dispersive X-ray spectroscopy, Fourier transform infrared spectroscopy, cyclic voltammetry, and electrochemical impedance spectroscopy. The electrochemical behaviors of alprazolam were determined by cyclic voltammetry, and the analytical measurements were studied by adsorptive cathodic stripping voltammetry. Optimized operational conditions included the concentration and deposition time of sulfuric acid in the electrochemical pretreatment, preconcentration potential, and preconcentration time. Under optimal conditions, the developed alprazolam sensor displayed a quantification limit of 0.1 mg L−1, a detection limit of 0.03 mg L−1, a sensitivity of 67 µA mg−1 L cm−2 and two linear ranges: 0.1 to 4 and 4 to 20 mg L−1. Sensor selectivity was excellent, and repeatability (%RSD < 4.24%) and recovery (82.0 ± 0.2 to 109.0 ± 0.3%) were good. The results of determining alprazolam in beverages with the developed system were in good agreement with results from the gas chromatography–mass spectrometric method.

scholarly journals The effect of tamoxifen on the electrochemical behavior of Bi+3/Bi on the glassy carbon electrode and its determination via differential pulse anodic stripping voltammetry

2019 ◽  
Vol 63 (1) ◽  
Author(s):  
Mehdi Jalali ◽  
Zeinab Deris Falahieh ◽  
Mohammad Alimoradi ◽  
Jalal Albadi ◽  
Ali Niazi
Keyword(s):  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Electrochemical Behavior ◽  
Electrochemical Impedance ◽  
Anodic Stripping Voltammetry ◽  
Stripping Voltammetry ◽  
Differential Pulse ◽  
Peak Height ◽  
Carbon Electrode

The electrochemical behavior of Bi+3 ions on the surface of a glassy carbon electrode, in acidic media and in the presence of tamoxifen, was investigated. Cyclic voltammetry, chronoamperometry, differential pulse voltammetry, electrochemical impedance spectroscopy, and scanning electron microscopy with energy-dispersive X-ray spectroscopy were used to find the probable mechanism contributing to the reduction of the peak height of bismuth oxidation with an increase in the concentration of tamoxifen. The obtained results show a slight interaction between the bismuth species and tamoxifen which co-deposit on the surface of glassy carbon electrode. Therefore, the reduction in the peak height of bismuth oxidation as a function of tamoxifen concentration was used to develop a new differential pulse anodic striping voltammetry method for determination of trace amount of tamoxifen. The effects of experimental parameters on the in situ DPASV of Bi+3 ions in the presence of tamoxifen shown the optimal conditions as: 2 mol L-1 H2SO4 (1% v v-1 MeOH), a deposition potential of -0.5 V, a deposition time of 60 s, and a glassy carbon electrode rotation rate of 300 rpm. The calibration curve was plotted in the range of 0.5 to 6 µg mL-1 and the limits of detection and quantitation were calculated to be 3.1 × 10-5 µg mL-1 and 1.0 × 10-4 µg mL-1, respectively. The mean, RSD, and relative bias for 0.5 µg mL-1 (n=5) were found to be 0.49 µg mL-1, 0.3%, and 2%, respectively. Finally, the proposed method was successfully used for the determination of tamoxifen in serum and pharmaceutical samples.

Preparation and characterization of a poly-o-phenylenediamine film modified glassy carbon electrode as a H2O2 sensor

2013 ◽  
Vol 91 (11) ◽  
pp. 1077-1084 ◽  
Author(s):  
Wenying Zhai ◽  
Xiuying Tian ◽  
Yun Yan ◽  
Yuehua Xu ◽  
Yuechun Zhao ◽  
...  
Keyword(s):  
Cyclic Voltammetry ◽  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Electrochemical Impedance ◽  
Monomer Concentration ◽  
Acetate Buffer ◽  
Acetate Buffer Solution ◽  
Carbon Electrode ◽  
Modified Glassy Carbon Electrode ◽  
Buffer Solution

A poly-o-phenylenediamine film modified glassy carbon electrode (PoPD/GC) was successfully prepared by cyclic voltammetry in acetate buffer solution. The polymerization mechanism of oPD is discussed. The impedance behavior and morphology of the PoPD membrane were characterized using cyclic voltammetry, electrochemical impedance spectroscopy, and scanning electron microscopy, respectively. It is discovered that the PoPD/GC prepared only in acetate buffer solution had dual electrocatalytic activity toward the oxidation and reduction of H2O2. The optimal buffer solution pH, scanning rate, monomer concentration, and number of scannings for film forming were 4.2, 0.05 V s−1, 6.0 mmol L−1, and 30, respectively. The linear ranges between the anodic (Δia) or cathodic (Δic) current and H2O2 concentration were 0.07−1.0 × 104 and 0.04−4.5 × 104 μmol L−1, respectively. The corresponding calibration curves were Δia (μA) = 8.03c (mmol L−1) + 6.36 (n = 18, R2 = 0.9989) and Δic (μA) = −5.52c (mmol L−1) − 0.77 (n = 18, R2 = 0.9990) with a detection limit of 0.03 and 0.02 μmol L−1 (S/N = 3), respectively. The PoPD/GC prepared in the optimal conditions showed good stability and quick response (<0.2 s) to H2O2, which was successfully applied to the determination of H2O2 in real water samples with satisfactory results.

scholarly journals Voltammetric detection of glutathione: an adsorptive stripping voltammetry approach

The Analyst ◽  
2016 ◽  
Vol 141 (10) ◽  
pp. 2904-2910 ◽  
Author(s):  
Madalena C. C. Areias ◽  
Kenichi Shimizu ◽  
Richard G. Compton
Keyword(s):  
Cyclic Voltammetry ◽  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Stripping Voltammetry ◽  
Adsorptive Stripping Voltammetry ◽  
Sensitive Detection ◽  
Carbon Electrode ◽  
Bare Glassy Carbon Electrode ◽  
Voltammetric Detection

High sensitive detection of glutathione in presence of copper(ii) ions by cyclic voltammetry using a bare glassy carbon electrode is presented.

Solar Exfoliated Graphene Oxide: A Platform for Electrochemical Sensing of Epinephrine

2020 ◽  
Vol 16 (4) ◽  
pp. 393-403 ◽  
Author(s):  
Renjini Sadhana ◽  
Pinky Abraham ◽  
Anithakumary Vidyadharan
Keyword(s):  
Cyclic Voltammetry ◽  
Graphene Oxide ◽  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Simultaneous Detection ◽  
Differential Pulse ◽  
Carbon Electrode ◽  
Modified Glassy Carbon Electrode ◽  
Reduced Graphene ◽  
Pulse Voltammetry

Introduction: In this study, solar exfoliated graphite oxide modified glassy carbon electrode was used for the anodic oxidation of epinephrine in a phosphate buffer medium at pH7. The modified electrode showed fast response and sensitivity towards Epinephrine Molecule (EP). The electrode was characterized electrochemically through Cyclic Voltammetry (CV) and Differential Pulse Voltammetry (DPV). Area of the electrode enhanced three times during modification and studies reveal that the oxidation process of EP occurs by an adsorption controlled process involving two electrons. The results showed a detection limit of 0.50 ± 0.01μM with a linear range up to 100 μM. The rate constant calculated for the electron transfer reaction is 1.35 s-1. The electrode was effective for simultaneous detection of EP in the presence of Ascorbic Acid (AA) and Uric Acid (UA) with well-resolved signals. The sensitivity, selectivity and stability of the sensor were also confirmed. Methods: Glassy carbon electrode modified by reduced graphene oxide was used for the detection and quantification of epinephrine using cyclic voltammetry and differential pulse voltammetry. Results: The results showed an enhancement in the electrocatalytic oxidation of epinephrine due to the increase in the effective surface area of the modified electrode. The anodic transfer coefficient, detection limit and electron transfer rate constant of the reaction were also calculated. Conclusion: The paper reports the determination of epinephrine using reduced graphene oxide modified glassy carbon electrode through CV and DPV. The sensor exhibited excellent reproducibility and repeatability for the detection of epinephrine and also its simultaneous detection of ascorbic acid and uric acid, which coexist in the biological system.

scholarly journals Electrokinetic and Impedimetric Dynamics of FeCo-Nanoparticles on Glassy Carbon Electrode

Nano Hybrids ◽  
2013 ◽  
Vol 3 ◽  
pp. 1-23 ◽  
Author(s):  
Chinwe O. Ikpo ◽  
Njagi Njomo ◽  
Kenneth I. Ozoemena ◽  
Tesfaye Waryo ◽  
Rasaq A. Olowu ◽  
...  
Keyword(s):  
Electron Transfer ◽  
Glassy Carbon Electrode ◽  
Glassy Carbon ◽  
Transfer Process ◽  
Dimethyl Carbonate ◽  
Electrochemical Impedance ◽  
Ethylene Carbonate ◽  
Carbon Electrode ◽  
Electron Transfer Process ◽  
Feco Nanoparticles

The electrochemical dynamics of a film of FeCo nanoparticles were studied on a glassy carbon electrode (GCE). The film was found to be electroactive in 1 M LiClO4 containing 1:1 v/v ethylene carbonate dimethyl carbonate electrolyte system. Cyclic voltammetric experiments revealed a diffusion-controlled electron transfer process on the GCE/FeCo electrode surface. Further interrogation on the electrochemical properties of the FeCo nanoelectrode in an oxygen saturated 1 M LiClO4 containing 1:1 v/v ethylene-carbonate-dimethyl carbonate revealed that the nanoelectrode showed good response towards the electro-catalytic reduction of molecular oxygen with a Tafel slope of about 120 mV which is close to the theoretical 118 mV for a single electron transfer process in the rate limiting step; and a transfer coefficient (α) of 0.49. The heterogeneous rate constant of electron transfer (ket), exchange current density (io) and time constant (τ) were calculated from data obtained from electrochemical impedance spectroscopy and found to have values of 2.3 x 10-5 cm s-1, 1.6 x 10-4 A cm-2 and 2.4 x 10-4 s rad-1, respectively.

Sign in / Sign up

Export Citation Format

Share Document