Faculty Opinions recommendation of Is the in situ accessibility of the 16S rRNA of Escherichia coli for Cy3-labeled oligonucleotide probes predicted by a three-dimensional structure model of the 30S ribosomal subunit?

Author(s):  
Robert Palmer
2003 ◽  
Vol 69 (8) ◽  
pp. 4935-4941 ◽  
Author(s):  
Sebastian Behrens ◽  
Bernhard M. Fuchs ◽  
Florian Mueller ◽  
Rudolf Amann

ABSTRACT Systematic studies on the hybridization of fluorescently labeled, rRNA-targeted oligonucleotides have shown strong variations in in situ accessibility. Reliable predictions of target site accessibility would contribute to more-rational design of probes for the identification of individual microbial cells in their natural environments. During the past 3 years, numerous studies of the higher-order structure of the ribosome have advanced our understanding of its spatial conformation. These studies range from the identification of rRNA-rRNA interactions based on covariation analyses to physical imaging of the ribosome for the identification of protein-rRNA interactions. Here we reevaluate our Escherichia coli 16S rRNA in situ accessibility data with regard to a tertiary-structure model of the small subunit of the ribosome. We localized target sequences of 176 oligonucleotides on a 3.0-Å-resolution three-dimensional (3D) model of the 30S ribosomal subunit. Little correlation was found between probe hybridization efficiency and the proximity of the probe target region to the surface of the 30S ribosomal subunit model. We attribute this to the fact that fluorescence in situ hybridization is performed on fixed cells containing denatured ribosomes, whereas 3D models of the ribosome are based on its native conformation. The effects of different fixation and hybridization protocols on the fluorescence signals conferred by a set of 10 representative probes were tested. The presence or absence of the strongly denaturing detergent sodium dodecyl sulfate had a much more pronounced effect than a change of fixative from paraformaldehyde to ethanol.


1998 ◽  
Vol 64 (12) ◽  
pp. 4973-4982 ◽  
Author(s):  
Bernhard Maximilian Fuchs ◽  
Günter Wallner ◽  
Wolfgang Beisker ◽  
Ines Schwippl ◽  
Wolfgang Ludwig ◽  
...  

ABSTRACT In situ identification of whole fixed bacterial cells by hybridization with fluorescently labeled, rRNA-targeted oligonucleotide probes is often limited by low signal intensities. In addition to an impermeability of the cell periphery and a low cellular rRNA content, the three-dimensional structure of the ribosome may hinder the access of oligonucleotides to their target sites. Until now, a systematic study on the accessibility of 16S rRNA target sites had not been done. Here, we report fluorescence intensities obtained with more than 200 oligonucleotide probes (mostly 18-mers) used with whole fixed cells ofEscherichia coli DSM 30083T. Two overlapping sets of adjacent oligonucleotides, 171 in total, were designed to cover the full length of the 16S rRNA. The two sets are shifted by 5 to 13 nucleotides. The probes were labeled with carboxyfluorescein, and signal intensities of hybridized cells were quantified by flow cytometry. Care was taken that the signal intensity of cells was dependent solely on the in situ accessibility of probe target sites. The brightest signal resulted from probe Eco1482, complementary to positions 1482 to 1499. With this probe, the fluorescence was 1.7 times brighter than that of the standard bacterial probe EUB338 and 44 times brighter than that of the worst probe, Eco468. The distribution of probe-conferred cell fluorescence in six arbitrarily set brightness classes (classes I to VI; 100 to 81%, 80 to 61%, 60 to 41%, 40 to 21%, 20 to 6%, and 5 to 0% of the brightness with Eco1482, respectively) was as follows: I, 4%; II, 14%; III, 21%; IV, 29%, V, 19%; and VI, 13%. A more detailed analysis of helices 6, 18, and 23 with additional probes demonstrated that a shift of the target region by only a few bases could result in a decline of cell fluorescence from >80 to <10%. Considering the high evolutionary conservation of 16S rRNA, the in situ accessibility map of E. coli should facilitate a more rational selection of probe target sites for other species as well.


2020 ◽  
Vol 31 (3) ◽  
pp. 47-61
Author(s):  
Uus Saepuloh ◽  
Diah Iskandriati ◽  
Joko Pamungkas ◽  
Dedy Duryadi Solihin ◽  
Sela Septima Mariya ◽  
...  

Simian betaretrovirus serotype-2 (SRV-2) is an important pathogenic agent in Asian macaques. It is a potential confounding variable in biomedical research. SRV-2 also provides a valuable viral model compared to other retroviruses which can be used for understanding many aspects of retroviral-host interactions and immunosuppression, infection mechanism, retroviral structure, antiretroviral and vaccine development. In this study, we isolated the gene encoding reverse transcriptase enzyme (RT) of SRV-2 that infected Indonesian cynomolgus monkey (Mf ET1006) and predicted the three dimensional structure model using the iterative threading assembly refinement (I-TASSER) computational programme. This SRV-2 RT Mf ET1006 consisted of 547 amino acids at nucleotide position 3284–4925 of whole genome SRV-2. The polymerase active site located in the finger/palm subdomain characterised by three conserved catalytic aspartates (Asp90, Asp165, Asp166), and has a highly conserved YMDD motif as Tyr163, Met164, Asp165 and Asp166. We estimated that this SRV-2 RT Mf ET1006 structure has the accuracy of template modelling score (TM-score 0.90 ± 0.06) and root mean square deviation (RMSD) 4.7 ± 3.1Å, indicating that this model can be trusted and the accuracy can be seen from the appearance of protein folding in tertiary structure. The superpositionings between SRV-2 RT Mf ET1006 and Human Immunodeficiency Virus-1 (HIV-1) RT were performed to predict the structural in details and to optimise the best fits for illustrations. This SRV-2 RT Mf ET1006 structure model has the highest homology to HIV-1 RT (2B6A.pdb) with estimated accuracy at TM-score 0.911, RMSD 1.85 Å, and coverage of 0.953. This preliminary study of SRV-2 RT Mf ET1006 structure modelling is intriguing and provide some information to explore the molecular characteristic and biochemical mechanism of this enzyme.


1991 ◽  
Vol 221 (4) ◽  
pp. 1311-1324 ◽  
Author(s):  
Patrick Sodano ◽  
Tai-he Xia ◽  
John H. Bushweller ◽  
Olof Björnberg ◽  
Arne Holmgren ◽  
...  

Biochemistry ◽  
1995 ◽  
Vol 34 (11) ◽  
pp. 3502-3512 ◽  
Author(s):  
Giovanna Scapin ◽  
John S. Blanchard ◽  
James C. Sacchettini

Sign in / Sign up

Export Citation Format

Share Document