Turbulence Pattern in Triangular Cylinder

2011 ◽  
Vol 110-116 ◽  
pp. 4719-4722
Author(s):  
V. Parthiban ◽  
Ashwin Russelle
Keyword(s):  
Numerical Simulation ◽  
Reynolds Number ◽  
Numerical Method ◽  
Vortex Shedding ◽  
Velocity Vector ◽  
High Reynolds Number ◽  
Reynolds Stress Model ◽  
Stress Model ◽  
High Reynolds ◽  
Solution Velocity

In order to predict a turbulent flow around a triangular cylinder a high Reynolds number of 45000 is done in the numerical simulation. In this simulation both steady and unsteady vortex shedding is predicted and various time steps. The numerical method used in this simulation is Reynolds Stress model. For steady and unsteady solution velocity contours and velocity vector plots is to be predicted for the vortex shedding behind the triangular cylinder.

Prediction of Vortex Shedding From a High Reynolds Number Airfoil Using LES With and Without Wall Model

2006 ◽  
Author(s):  
Peter A. Chang ◽  
Meng Wang ◽  
Jonathan Gershfeld
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Turbulent Boundary Layer ◽  
Vortex Shedding ◽  
High Reynolds Number ◽  
Wall Stress ◽  
Wall Pressure ◽  
Pressure Side ◽  
Stress Model ◽  
High Reynolds

ATTACHED, wall-bounded flows impose computational requirements on LES that increase drastically with Reynolds number. For that reason, even simple geometries, such as airfoils at small angles of attack, with spanwise uniform section shape, challenge the bounds of LES as chord-based Reynolds numbers increase much above 1 million. Of particular concern is the ability of LES to predict the occurrence, and strength of, weak vortex shedding from the airfoil trailing edge (by weak vortex shedding we mean that the acoustic vortex shedding signature may rise only a few decibels above that for the broadband turbulent boundary layer acoustic sources). Correct prediction of weak vortex shedding may depend on accurately predicting the flow over the entire airfoil that includes the attached, turbulent upstream flow, adverse pressure gradient and separated flow regions and finally, the turbulent wake. This paper compares results of two full-LES and two LES with wall-stress model for the flow about a modified NACA 0016 airfoil with a 41° trailing edge apex angle and a slightly convex pressure side. Comparisons of vortex shedding, as measured by the power spectral density (PSD) of wall pressure fluctuations (WPF) on the pressure side of the TE and the PSD of the vertical velocity fluctuations in the wake are made. The results indicate that vortex shedding predictions are dependent upon the stream-wise and spanwise grid resolution. In order to reduce the large computational times required for simulating the high-Reynolds number flows with fully-resolved LES, a wall-stress model that solves the turbulent boundary layer equations in the near-wall region is applied. Compared with the fully-resolved LES, the LES with wall-stress simulations require about 20 percent the number of grid points and require about 10 percent of the computational time. However, the LES with wall stress model results under-predict the vortex shedding peak in the wake and are not able to predict the vortex shedding signature in TE wall pressure spectra. These results indicate that near-wall turbulence structures need to be resolved in order to correctly predict the occurence and strength of vortex shedding.

scholarly journals Numerical Simulation of Flow Around Two Side-by-Side Circular Cylinders at High Reynolds Number

2020 ◽  
Vol 38 (1) ◽  
pp. 77-91
Author(s):  
Hamidreza Rahimi ◽  
Xiaonan Tang ◽  
Yaser Esmaeeli ◽  
Ming Li ◽  
Alireza Pourbakhtiar
Keyword(s):  
Numerical Simulation ◽  
Reynolds Number ◽  
High Reynolds Number ◽  
Circular Cylinders ◽  
High Reynolds

Cellular vortex shedding in the wake of a tapered plate

2008 ◽  
Vol 617 ◽  
pp. 355-379 ◽  
Author(s):  
VAGESH D. NARASIMHAMURTHY ◽  
HELGE I. ANDERSSON ◽  
BJØRNAR PETTERSEN
Keyword(s):  
Experimental Data ◽  
Reynolds Number ◽  
Vortex Shedding ◽  
High Reynolds Number ◽  
Three Dimensional ◽  
Base Pressure ◽  
Recirculation Bubble ◽  
Apparent Lack ◽  
Secondary Motion ◽  
High Reynolds

Direct numerical simulation (DNS) of vortex shedding behind a tapered plate with the taper ratio 20 placed normal to the inflow has been performed. The Reynolds numbers based on the uniform inflow velocity and the width of the plate at the wide and narrow ends were 1000 and 250, respectively. For the first time ever cellular vortex shedding was observed behind a tapered plate in a numerical experiment (DNS). Multiple cells of constant shedding frequency were found along the span of the plate. This is in contrast to apparent lack of cellular vortex shedding found in the high-Reynolds-number experiments by Gaster & Ponsford (Aero. J., vol. 88, 1984, p. 206). However, the present DNS data is in good qualitative agreement with similar high-Reynolds-number experimental data produced by Castro & Watson (Exp. Fluids, vol. 37, 2004, p. 159). It was observed that a tapered plate creates longer formation length coupled with higher base pressure as compared to non-tapered (i.e. uniform) plates. The three-dimensional recirculation bubble was nearly conical in shape. A significant base pressure reduction towards the narrow end of the plate, which results in a corresponding increase in Strouhal number, was noticed. This observation is consistent with the experimental data of Castro & Rogers (Exp. Fluids, vol. 33, 2002, p. 66). Pressure-driven spanwise secondary motion was observed, both in the front stagnation zone and also in the wake, thereby reflecting the three-dimensionality induced by the tapering.

Sign in / Sign up

Export Citation Format

Share Document