Research on the Half-Bridge Three-Level DC/DC Converter with High Frequency and High Voltage

2013 ◽  
Vol 732-733 ◽  
pp. 1175-1178
Author(s):  
Hong Zhang ◽  
Gui Xin Wang ◽  
Hao Yan ◽  
Lu Zhou Zhang
Keyword(s):  
High Voltage ◽  
Input Voltage ◽  
Zero Voltage Switching ◽  
High Voltage Direct Current ◽  
Parameters Selection ◽  
Converter Topology ◽  
Working Principle ◽  
Current Zero ◽  
Zero Voltage ◽  
Voltage Switching

In this research, a high-voltage direct current zero voltage switching (ZVS) PWM half-bridge converter is proposed. The parameters of the converter as follows: the input voltage is up to 4000V;the output voltage is 600V.The new ZVS PWM TL converter has neutral point clamping diodes and flying capacitor. This research is going to analyze the working principle of circuit witch thus realizing the zero voltage switching and the circuit parameters selection. Moreover, circuits simulation is carried out by MATLAB to verify the reliability and feasibility of this DC/DC converter topology.

scholarly journals Soft-Switching High Gain Step-Up DC/DC Converter without Auxiliary Switches

2019 ◽  
Vol 8 (12S) ◽  
pp. 633-636
Keyword(s):  
Theoretical Analysis ◽  
Power Flow ◽  
High Efficiency ◽  
Input Voltage ◽  
High Gain ◽  
Soft Switching ◽  
Zero Voltage Switching ◽  
Auxiliary Cell ◽  
Zero Voltage ◽  
Voltage Switching

This manuscript presents a novel high gain, high efficiency Soft-switching high step-up DC/DC converter for battery-operated vehicles. The high step-up converter can transfer the power flow from the small voltage to high voltage. The conventional two input inductor hard switched non-isolated DC-DC converter improved with an additional auxiliary cell to attain the Zero voltage switching, due to obtaining the softswitching the efficiency may improve and reduces the stress across the main switches. The isolated converters are used as a transformer to attain high gain, whereas in the proposed converter obtains the high gain without a transformer and contains the high efficiency in the step-up mode of operation. The main aim of the converter is to attain the Zero voltage switching without using any additional auxiliary switches. In this paper, the input voltage applied as 30V, and the obtained output voltage is fifteen times to the applied voltage, which is 450V and the output power 850W. This paper mainly presents the theoretical analysis of converter operation and the evaluation of the simulation results validated with the theoretical analysis.

Sign in / Sign up

Export Citation Format

Share Document