Near Field Simulation of Low Level Waste Water Released from Nuclear Power Plants in Rivers through Surface by CORMIX

2013 ◽  
Vol 807-809 ◽  
pp. 113-117 ◽  
Author(s):  
Yang Yang ◽  
Yong Ye Liu ◽  
Ya Hua Qiao ◽  
Fu Dong Liu ◽  
Chun Ming Zhang ◽  
...  

CORMIX obtaining the approval from USEPA is widely used in the environmental evaluation of US inland nuclear power plants. Carry out 3-d simulation for the low level radioactive liquid effluent released from an inland nuclear power plant in rivers through surface by CORMIX. Compare the diluent effect of different discharge capacity (2 and 4 units) and different season (summer and winter). Dilution ratios of these four simulation conditions are all reach 10 at 500m downstream. The 0.1C0 isoconcentration line range of four units is much larger than two units. It is found from the concentration distribution of cross-section at 1km downstream that the diffusing vertically of effluent in summer is better than it in winter. The accuracy of the software will be confirmed by actual measurement.

2019 ◽  
Vol 7 (2A) ◽  
Author(s):  
Roberto Pellacani Monteiro ◽  
Aluísio Souza Reis Junior ◽  
Geraldo Frederico Kastner ◽  
Eliane Silvia Codo Temba ◽  
Thiago César De Oliveira ◽  
...  

The aim of this work is to present radiochemical methodologies developed at CDTN/CNEN in order to answer a program for isotopic inventory of radioactive wastes from Brazilian Nuclear Power Plants.  In this program  some radionuclides, 3H, 14C, 55Fe, 59Ni, 63Ni, 90Sr, 93Zr, 94Nb, 99Tc, 129I, 235U, 238U, 238Pu, 239+240Pu, 241Pu, 242Pu, 241Am, 242Cm e 243+244Cm, were determined  in Low Level Wastes (LLW) and Intermediate Level Wastes (ILW) and a protocol of analytical methodologies based on radiochemical separation steps and spectrometric and nuclear techniques was stablished.


Author(s):  
Takeshi Ishikura ◽  
Daiichiro Oguri

Abstract Minimizing the volume of radioactive waste generated during dismantling of nuclear power plants is a matter of great importance. In Japan waste forms buried in shallow burial disposal facility as low level radioactive waste (LLW) must be solidified by cement with adequate strength and must extend no harmful openings. The authors have developed an improved method to minimize radioactive waste volume by utilizing radioactive concrete and metal for mortar to fill openings in waste forms. Performance of a method to pre-place large sized metal or concrete waste and to fill mortar using small sized metal or concrete was tested. It was seen that the improved method substantially increases the filling ratio, thereby decreasing the numbers of waste containers.


2014 ◽  
Vol 302 (1) ◽  
pp. 41-47 ◽  
Author(s):  
T. C. Oliveira ◽  
R. P. G. Monteiro ◽  
G. F. Kastner ◽  
F. Bessueille-Barbier ◽  
A. H. Oliveira

2020 ◽  
Vol 11 (2) ◽  
pp. 66-74
Author(s):  
A. A. Ekidin ◽  
◽  
K. L. Antonov ◽  

Generation of radioactive wastes (RW) is viewed a most urgent problem of radiation safety under normal operation of nuclear power plants (NPP). The paper demonstrates the application of a specifi c indicator (rate) of RW generation per unit of generated power (m3/GW·h) for a retrospective assessment and forecasting of RW generation volumes at Russian NPPs. Mean and median values of annual specifi c RW generation rates were calculated for each NPP based on published environmental reports of JSC Rosenergoatom Concern for the period of 2008—2018. Advantage of applying median values in retrospective and forecast assessments was shown. Medians for solid very low-level, low-level, intermediate-level and high-level radioactive waste amounted to 1.5·10−2 m3/GW·h, 3.3·10−2 m3/GW·h, 3.3·10−3 m3/GW·h and 2.8·10−4 m3/GW·h, respectively; for liquid low-level and intermediate-level waste these values accounted for 1.4·10−3 m3/GW·h, 2.5·10−3 m3/GW·h, respectively. NPPs with RBMK reactor units are characterized by the highest mean and median values of specifi c RW generation rates for all RW categories. Given various types of reactor facilities and their characteristic specifi c rates, retrospective estimates for the total volume of liquid RW was increased by 8 % and for solid RW — by 12 %. The forecast estimates based on specifi c rate medians, as well as on increased power generation planned for Russian NPPs indicates probable increase in RW generation volumes by 0.8—7.1 % (depending on waste category) from 2020 to 2027.


1992 ◽  
Vol 36 (7) ◽  
pp. 591-595 ◽  
Author(s):  
Shusa Hashimoto ◽  
Tadashi Nihei

In recent years, it has been expected more than before that the indoor environment of control rooms in nuclear power plants will be made more comfortable without inhibiting function. In order to derive the environmental problems of control rooms in nuclear power plants that should be discussed, the design standards and operators' complaints were investigated. As a result, some problems such as unsuitable lighting, noisy acostics and operators' dissatisfaction with thier enclosed circumstances were derived. In order to improve the indoor environments and to establish comprehensive environmental evaluation methodology, experiments on environmental factors such as indoor view, noise level, glare on VDU and shift time-zone that were thought to be related to the above problems were conducted. 6 subjects' psychological, physiological and behavioral responses to thier environments were measured in the environmentally changeable laboratory, which was mocked up like a control room. Subjects were imposed to do 2 kinds of VDU tasks. From Principal Component Analysis of the experimental results, some psychological, physiological and behavioral indices for evaluating indoor environments were obtained. Furthermore, the relationship between these indices and environmental factors was obtained by Multiple Regression Analysis. The multiple correlation values shows that the environmental factors were most reflected in the psychological evaluation indices. However, other indices are also important because psychological comfort does not always mean good physiological conditions or good task performance. The space functions of the room as a control room and operator's physicological condition should be considered for comprehensive environmental evaluation. The result shows that the introduction of darkgreen louver, potted plants/artificial window and noise reduction are desirable in control rooms.


Sign in / Sign up

Export Citation Format

Share Document