scholarly journals Dual Phase 3D Angiography with 64 MDCT: The Evaluation of Vascular Anatomy before Laparoscopic Gastrectomy

2019 ◽  
Vol 09 (01) ◽  
Author(s):  
Ali Onder Atca ◽  
Berrin Erok ◽  
Ebru Yılmaz ◽  
Sevil Fisekci Oktar ◽  
Erhun Eyuboglu ◽  
...  
2019 ◽  
Vol 09 (01) ◽  
Author(s):  
Ali Onder Atca ◽  
Berrin Erok ◽  
Ebru Yılmaz ◽  
Sevil Fisekci Oktar ◽  
Erhun Eyuboglu ◽  
...  

2006 ◽  
Vol 186 (4) ◽  
pp. 1079-1085 ◽  
Author(s):  
Mitsuru Matsuki ◽  
Masato Tanikake ◽  
Hiroyuki Kani ◽  
Fuminari Tatsugami ◽  
Shuji Kanazawa ◽  
...  

2010 ◽  
Vol 25 (5) ◽  
pp. 1420-1424 ◽  
Author(s):  
Toshiyuki Natsume ◽  
Kiyohiko Shuto ◽  
Noriyuki Yanagawa ◽  
Takashi Akai ◽  
Hiroshi Kawahira ◽  
...  

2008 ◽  
Vol 49 (4) ◽  
pp. 350-356 ◽  
Author(s):  
ANA V. CCERES ◽  
ALLISON L. ZWINGENBERGER ◽  
LILLIAN R. ARONSON ◽  
WILFRIED MAI

2018 ◽  
Vol 25 (9) ◽  
pp. 1236
Author(s):  
Pierleone Lucatelli ◽  
Gianluca De Rubeis ◽  
Renato Argirò ◽  
Mario Corona ◽  
Mario Bezzi

Author(s):  
L.J. Chen ◽  
H.C. Cheng ◽  
J.R. Gong ◽  
J.G. Yang

For fuel savings as well as energy and resource requirement, high strength low alloy steels (HSLA) are of particular interest to automobile industry because of the potential weight reduction which can be achieved by using thinner section of these steels to carry the same load and thus to improve the fuel mileage. Dual phase treatment has been utilized to obtain superior strength and ductility combinations compared to the HSLA of identical composition. Recently, cooling rate following heat treatment was found to be important to the tensile properties of the dual phase steels. In this paper, we report the results of the investigation of cooling rate on the microstructures and mechanical properties of several vanadium HSLA steels.The steels with composition (in weight percent) listed below were supplied by China Steel Corporation: 1. low V steel (0.11C, 0.65Si, 1.63Mn, 0.015P, 0.008S, 0.084Aℓ, 0.004V), 2. 0.059V steel (0.13C, 0.62S1, 1.59Mn, 0.012P, 0.008S, 0.065Aℓ, 0.059V), 3. 0.10V steel (0.11C, 0.58Si, 1.58Mn, 0.017P, 0.008S, 0.068Aℓ, 0.10V).


Sign in / Sign up

Export Citation Format

Share Document