Wind Tunnel Testing of Micro Air Vehicles at Low Reynolds Numbers

Author(s):  
Roberto Albertani ◽  
Paul Hubner ◽  
Peter Ifju ◽  
Rick Lind ◽  
Jason Jackowski
2000 ◽  
Author(s):  
Ajit Pal Singh ◽  
S. H. Winoto ◽  
D. A. Shah ◽  
K. G. Lim ◽  
Robert E. K. Goh

Abstract Performance characteristics of some low Reynolds number airfoils for the use in micro air vehicles (MAVs) are computationally studied using XFOIL at a Reynolds number of 80,000. XFOIL, which is based on linear-vorticity stream function panel method coupled with a viscous integral formulation, is used for the analysis. In the first part of the study, results obtained from the XFOIL have been compared with available experimental data at low Reynolds numbers. XFOIL is then used to study relative aerodynamic performance of nine different airfoils. The computational analysis has shown that the S1223 airfoil has a relatively better performance than other airfoils considered for the analysis.


2021 ◽  
pp. 0309524X2110550
Author(s):  
Moutaz Elgammi ◽  
Tonio Sant ◽  
Atiyah Abdulmajid Ateeah

Modeling of the flow over aerofoil profiles at low Reynolds numbers is difficult due to the complex physics associated with the laminar flow separation mechanism. Two major problems arise in the estimation of profile drag: (1) the drag force at low Reynolds numbers is extremely small to be measured in a wind tunnel by force balance techniques, (2) the profile drag is usually calculated by pressure integration, hence the skin friction component of drag is excluded. In the present work, three different 4-digit NACA aerofoils are investigated. Measurements are conducted in an open-ended subsonic wind tunnel, while numerical work is performed by time Reynolds-averaged Navier Stokes (RANS) coupled with the laminar-kinetic-energy ( K-kl-w) turbulence model. The influence of the flow separation bubbles and transition locations on the profile drag is discussed and addressed. This paper gives important insights into importance of measurements at low Reynolds numbers for better aerodynamic loads predictions.


Author(s):  
David Holst ◽  
Francesco Balduzzi ◽  
Alessandro Bianchini ◽  
Christian Navid Nayeri ◽  
Christian Oliver Paschereit ◽  
...  

Abstract Wind industry needs high quality airfoil data for a range of the angle of attack (AoA) much wider than that often provided by the technical literature, which often lacks data i.e. in deep- and post-stall region. Especially in case of vertical axis wind turbines (VAWTs), the blades operate at very large AoAs, which exceed the range of typical aviation application. In a previous study, some of the authors analyzed the trend of the lift coefficient of a NACA 0021 airfoil, using the suggestions provided by detailed CFD analyses to correct experimental data at low Reynolds numbers collected in an open-jet tunnel. In the present study, the correction method is extended in order to analyze even the drag and moment coefficients over a wide range of AoAs for two different Reynolds numbers (Re = 140k and Re = 180k) of particular interest for small wind turbines. The utility of these data is again specifically high in case of VAWTs, in which both the drag and the moment coefficient largely contribute to the torque. The investigation involves tunnel data regarding both static polars and dynamic sinusoidal pitching movements at multiple reduced frequencies. Concerning the numerical simulations, two different computational domains were considered, i.e. the full wind tunnel and the open field. Once experimental data have been purged by the influence of the wind tunnel by means of the proposed correction method, they were compared to existing data for similar Reynolds both for the NACA0021 and for similar airfoils. By doing so, some differences in the static stall angle and the extent of the hysteresis cycle are discussed. Overall, the present paper provides the scientific community with detailed analysis of low-Reynolds NACA 0021 data in multiple variations, which may enable, inter alia, a more effective VAWT design in the near future.


Aviation ◽  
2020 ◽  
Vol 23 (4) ◽  
pp. 104-113
Author(s):  
Ahmed Aboelezz ◽  
Yunes Elqudsi ◽  
Mostafa Hassanalian ◽  
Ahmed Desoki

The increase in the number of Unmanned Aerial Vehicles (UAVs) and Micro Air Vehicles (MAVs), which are used in a variety of applications has led to a surge in low Reynolds number aerodynamics research. Flow around fixedwing MAVs has an unusual behavior due to its low aspect ratio and operates at low Reynolds number, which demanded to upgrade the used wind tunnel for this study. This upgrade enables measuring the small aerodynamics forces and moment of fixed-wing MAVs. The wind tunnel used in this work is upgraded with a state of art data acquisition system to deal with the different sensors signals in the wind tunnel. For accurate measurements, the sting balance, angle sensor, and airspeed sensor are calibrated. For validation purposes, an experiment is made on a low aspect ratio flat plate wing at low Reynolds number, and the measured data are corrected and compared with published results. The procedure presented in this paper for the first time gave a detailed and complete guide for upgrading and calibrating old wind tunnel, all the required corrections to correct the measured data was presented, the turbulence level correction new technique presented in this paper could be used to estimate the flow turbulence effect on the measured data and correct the measured data against published data.


Sign in / Sign up

Export Citation Format

Share Document