scholarly journals Gravity Study using Multi-2.5D Modeling and 3D Presentation for Al Ma'aniyah Depression, Southwest of Iraq

2021 ◽  
Vol 54 (2D) ◽  
pp. 113-124
Author(s):  
Ali M. Al-Rahim

Tectonic depression area within and/or beside widespread basin is regarded as an important location for sub-basin sedimentary sequence of Iraq which may represent an excellent accumulation of bounded sediments. Al-Ma'aniyah depression, southwest Iraq is one of such type of sub-basin. Free-air gravity data show a NS extend of this depression inside Saudi Arabia. This work focuses on studying and multi-2.5D model creation for the depression in the Iraqi territory part using Bouguer gravity data and mapping its basement relief. Firstly, the exact boundary of the depression was outlined utilizing the Free-Air gravity data. Then, a precise selection of regional field for the study area was determined by using the power spectrum method, which accordingly defines the residual anomalies that could represent structural enclosures. Many positive anomalies were assigned and enhanced using vertical and total horizontal derivatives, where they were interpreted as basement-related features. Subsequently, a 2.5D multi modeling and depth inversion for the Bouguer gravity data were accomplished by converting the gravity map to a stacked profiles depth map. A nineteen gravity profiles, which cover the study area, were modeled by assuming 2D intra-sedimentary bodies. These bodies were best presented by a 3D view that clarifies the nature of the subsurface modeled structures. The modeling shows an extra density at the northern part of the depression, in contrast, it suggests low density bodies at its southern part, the case that appears inconsistent with a previously performed magnetic interpretation. The inversion of gravity data shows that the basement depth at Al-Ma'aniyah depression ranges from 7.5 to10 km.

2012 ◽  
Vol 2012 ◽  
pp. 1-15 ◽  
Author(s):  
Javier Sanchez-Rojas

A new gravity data compilation for Venezuela was processed and homogenized. Gravity was measured in reference to the International Gravity Standardization Net 1971, and the complete Bouguer anomaly was calculated by using the Geodetic Reference System 1980 and 2.67 Mg/m3. A regional gravity map was computed by removing wavelengths higher than 200 km from the Bouguer anomaly. After the anomaly separation, regional and residual Bouguer gravity fields were then critically discussed in term of the regional tectonic features. Results were compared with the previous geological and tectonic information obtained from former studies. Gravity and topography data in the spectral domain were used to examine the elastic thickness and depths of the structures of the causative measured anomaly. According to the power spectrum analysis results of the gravity data, the averaged Moho depths for the massif, plains, and mountainous areas in Venezuela are 42, 35, and 40 km, respectively. The averaged admittance function computed from the topography and Free-Air anomaly profiles across Mérida Andes showed a good fit for a regional compensation model with an effective elastic thickness of 15 km.


Geofizika ◽  
2020 ◽  
Vol 37 (2) ◽  
pp. 237-261
Author(s):  
Fan Luo ◽  
Xin Tao ◽  
Guangming Fu ◽  
Chong Zhang ◽  
Kun Zhang ◽  
...  

Satellite gravity data are widely used in the field of geophysics to study deep structures at the regional and global scales. These data comprise free-air gravity anomaly data, which usually need to be corrected to a Bouguer gravity anomaly for practical application. Bouguer reduction approaches can be divided into two methods based on the coordinate system: the spherical coordinates method (SBG) and the Cartesian coordinates method; the latter is further divided into the CEBG and CBG methods, which do and do not include the Earth’s curvature correction. In this paper, free-air gravity anomaly data from the eastern Tibetan Plateau and its adjacent areas were used as the basic data to compare the CBG, CEBG, and SBG Bouguer gravity correction methods. The comparison of these three Bouguer gravity correction methods shows that the effect of the Earth’s curvature on the gravitational effect increases with increasing elevation in the study area. We want to understand the inversion accuracy for the data obtained by different Bouguer gravity reduction approaches. The depth distributions of the Moho were obtained by the interface inversion of the Bouguer gravity anomalies obtained by the CBG, CEBG, and SBG, and active seismic profiles were used as references for comparison and evaluation. The results show that the depths of the Moho obtained by the SBG inversion are more consistent with the measured seismic profile depths. Therefore, the SBG method is recommended as the most realistic approach in the process of global or regional research employing gravity data.


2012 ◽  
Vol 58 (209) ◽  
pp. 540-552 ◽  
Author(s):  
James R. Cochran ◽  
Robin E. Bell

AbstractA possible cause for accelerated thinning and break-up of floating marine ice shelves is warming of the water in the cavity below the ice shelf. Accurate bathymetry beneath large ice shelves is crucial for developing models of the ocean circulation in the sub-ice cavities. A grid of free-air gravity data over the floating Larsen C ice shelf collected during the IceBridge 2009 Antarctic campaign was utilized to develop the first bathymetry model of the underlying continental shelf. Independent control on the continental shelf geologic structures from marine surveys was used to constrain the inversion. Depths on the continental shelf beneath the ice shelf estimated from the inversion generally range from about 350 to 650 m, but vary from <300 to >1000 m. Localized overdeepenings, 20-30 km long and 900-1000 m deep, are located in inlets just seaward of the grounding line. Submarine valleys extending seaward from the overdeepenings coalesce into two broad troughs that extend to the seaward limit of the ice shelf and appear to extend to the edge of the continental shelf. The troughs are generally at a depth of 550-700 m although the southernmost mapped trough deepens to over 1000 m near the edge of the ice shelf just south of 68° S. The combination of the newly determined bathymetry with published ice-draft determinations based on laser altimetry and radar data defines the geometry of the water-filled cavity. These newly imaged troughs provide a conduit for water to traverse the continental shelf and interact with the overlying Larsen C ice shelf and the grounding lines of the outlet glaciers.


2020 ◽  
Author(s):  
Lucia Seoane ◽  
Benjamin Beirens ◽  
Guillaume Ramillien

&lt;p&gt;We propose to cumulate complementary gravity data, i.e. geoid height and (radial) free-air gravity anomalies, to evaluate the 3-D shape of the sea floor more precisely. For this purpose, an Extended Kalman Filtering (EKF) scheme has been developed to construct the topographic solution by injecting gravity information progressively. The main advantage of this sequential cumulation of data is the reduction of the dimensions of the inverse problem. Non linear Newtonian operators have been re-evaluated from their original forms and elastic compensation of the topography is also taken into account. The efficiency of the method is proved by inversion of simulated gravity observations to converge to a stable topographic solution with an accuracy of only a few meters. Real geoid and gravity data are also inverted to estimate bathymetry around the New England and Great Meteor seamount chains. Error analysis consists of comparing our topographic solutions to accurate single beam ship tracks for validation.&lt;/p&gt;


2020 ◽  
Vol 39 (2) ◽  
pp. 135-143
Author(s):  
Sajjad Sajjadi ◽  
Zdeněk Martinec ◽  
Patrick Prendergast ◽  
Jan Hagedoorn ◽  
Libor Šachl ◽  
...  

The systematic biases and errors associated with gravity data in Ireland and Northern Ireland and the conversion of gravity to a consistent and unified system are analyzed. The gravity data in Ireland and Northern Ireland are given in different coordinate systems (Irish Grid and Irish Transverse Mercator), different gravity base stations (Dunsink and Cambridge), and different vertical datums (Malin Head and Belfast tide gauge). The conversion of the gravity data to a consistent system, which refers to unified coordinates, base station, and vertical datum, is essential in geophysics and geodesy, especially in geoid determination. A new standardized and unified data format is computed and proposed for the supply of gravity data for Ireland and Northern Ireland to minimize the potential of misinterpreting the data. As part of this study, simple Bouguer and free-air gravity anomaly maps are produced for Ireland and Northern Ireland to give an example of how to integrate the data.


Science ◽  
2013 ◽  
Vol 340 (6140) ◽  
pp. 1552-1555 ◽  
Author(s):  
H. J. Melosh ◽  
Andrew M. Freed ◽  
Brandon C. Johnson ◽  
David M. Blair ◽  
Jeffrey C. Andrews-Hanna ◽  
...  

High-resolution gravity data from the Gravity Recovery and Interior Laboratory spacecraft have clarified the origin of lunar mass concentrations (mascons). Free-air gravity anomalies over lunar impact basins display bull’s-eye patterns consisting of a central positive (mascon) anomaly, a surrounding negative collar, and a positive outer annulus. We show that this pattern results from impact basin excavation and collapse followed by isostatic adjustment and cooling and contraction of a voluminous melt pool. We used a hydrocode to simulate the impact and a self-consistent finite-element model to simulate the subsequent viscoelastic relaxation and cooling. The primary parameters controlling the modeled gravity signatures of mascon basins are the impactor energy, the lunar thermal gradient at the time of impact, the crustal thickness, and the extent of volcanic fill.


Sign in / Sign up

Export Citation Format

Share Document