The Dynamic Effect of Root Exudates on Soil Structure – Characterization by X-ray Tomography

Author(s):  
Maoz Dor ◽  
John Koestel ◽  
Simon Emmanuel ◽  
Yael Mishael

<p>Soil mucilage strongly affects soil structural packing and stability. We characterized the effects of mucilage and the subsequent effect of wetting and drying on the microstructure of three agricultural soils: clayey, sandy-clay-loam, and loamy-sand soils. Soil stability measurement trends, assessed by a laser granulometry based aggregate durability index (ADI), varied between the soils. While aggregates stability of the clayey and loamy-sand soils decreased after subjecting soil samples to wetting and drying, stability increased in the case of the sandy-clay-loam soil. This observation can be explained by the high CaCO<sub>3</sub> content in the loamy-sand soils (19.5%) which contributes to the formation of durable aggregates induced by calcite cementation. ADI values of all soils increased following mucilage amendment (0.035 w/w). Mucilage, consisting mainly of polysaccharides and lipids, may affect soil mechanical properties and structure by binding soil particles due to its adhesive properties, thus reinforcing the internal structure of the aggregates. Stability was further analyzed after subjecting the mucilage amended samples to a wetting and drying cycle, and a diverse trend was measured. While stability increased for the clayey and the loamy-sand soils, it decreased for the sandy-clay-loam soil. Mucilage is known to induce surface hydrophobicity, following its dehydration, which may lead to a decrease in the wettability of soil particles and protect aggregates from deterioration by water. However, in the sandy-clay-loam soil, the cumulative effect CaCO<sub>3</sub> and mucilage which increases entropy overpowers the mucilage stabilizing effect.</p><p>The packing of the microstructure as a function of mucilage amendment and wetting and drying was characterized by quantifying morphological and geometrical changes within the pore-network, extracted by X-ray computed tomography (XCT). Pore volume in all soils decreased upon mucilage amendment, correlating with the observed increase in stability. However, while porosity of the clayey soil increased after wetting and drying, it decreased or remained the same in the Loamy-sand and sandy-clay-loam soil, respectively. To evaluate pore connectivity, we calculated the Euler number (c) in which smaller values (negative) indicate better pore-connectivity. Poor connectivity was assessed in the amended clayey (c=1128) and sandy-clay-loam (c=172085) soils, probably due to soil aggregation which is in correlation with porosity assessment. Following wetting and drying, connectivity improved in the clayey soil <br>(c=-17281), while in the sandy-clay-loam it remained poor (c=143119). As expected, pore connectivity (c<0) of the loamy-sand soil remained in all treatments. These observations are in agreement with the stability results. As stability increased in all soils following mucilage amendment, pore-volume, and connectivity decreased. Wetting and drying of the stabilized clayey soil increased porosity and connectivity. However, the decreased stability of the sandy-clay-loam soil, due to the cumulative effect of CaCO3 and mucilage, was expressed by poor connectivity and porosity. These results demonstrate the effect of mucilage amendment and wetting and drying cycle on soil structure. Finally, applying X-ray tomography and laser granulometry measurements to characterize soil structure as a function of soil amendments may shed light on how soil structure controls the storage and fluxes of water, nutrients, and gases.</p>

2003 ◽  
Vol 54 (3) ◽  
pp. 273 ◽  
Author(s):  
M. A. Hamza ◽  
W. K. Anderson

In the low rainfall, cropping area of Western Australia, massive soil structure due to machinery traffic is common on a range of soil types and is a major obstacle to crop yield improvement. Yield increases on compacted soils have been poor in the last decade compared with those on other soils. An experiment was conducted over 4 years (1997–2000) on a loamy sand soil with massive subsoil structure using a factorial combination of soil ripping to 0.4 m (DR), and application of commercial grade gypsum at 2.5 t/ha (G) to address the soil compaction problem. Complete nutrients, based on soil test each year, were applied to all treatments and regarded as the control treatment. All crop residues were retained after harvest and returned to the soil. The experiment was conducted in a wheat–grain legume (chickpea in 1998, field pea in 2000) rotation at Tammin in Western Australia. The purpose of the experiment was to assess possible improvements in soil properties and grain yields that may result from deep soil disturbance and application of an aggregating agent such as gypsum on a loamy sand soil in a low rainfall cropping system. Soil water infiltration rate, soil strength, porosity, water-stable aggregates, exchangeable Ca and Mg, cation exchange capacity, and grain yields were measured. The results of this experiment on a loamy sand soil are compared and contrasted with those from a similar experiment on another common soil type in the low rainfall zone, a sandy clay loam soil (reported earlier by MA Hamza and WK Anderson). Grain yields were increased slightly more on the loamy sand soil at Tammin than on the sandy clay loam soil at Merredin due to deep ripping and gypsum application, even though the corresponding improvements in soil parameters were not as great on the loamy sand soil. The yield increases of wheat and legumes due to gypsum treatment were significantly lower on both soil types than those due to the combination of gypsum and ripping, whereas ripping alone without gypsum produced a yield decrease in the third and subsequent years after treatment. The main treatment effects on yield were additive, as significant interactions between the treatments on yield were seldom found. Deep ripping and gypsum application (DRG) resulted in the greatest improvement in the soil physical properties as indicated by crop growth on both soil types. The DRG treatment increased soil water infiltration rate by about 90% on the loamy sand soil but by more than 130% on the sandy clay loam soil 4 years after the application of the treatments. Strength and porosity of the topsoil were decreased much more on the sandy clay loam soil. Summer rain stored in the soil prior to seeding was increased almost 3 times in both soils. The increase in water-stable aggregates was only 8% in the loamy sand soil but 46% on the sandy clay loam soil. Cation exchange capacity and exchangeable calcium were also increased more on the clayey than on the sandy soil by the use of DRG. Economic analysis of the yield improvements showed that the DRG treatment produced significantly higher profit than the G or DR treatments alone on both soil types, but was slightly greater on the loamy sand soil type. The combination of soil ripping and gypsum application in the presence of complete nutrients and annual return of crop residues to the soil had somewhat different effects on the soil physical properties and grain yields at a loamy sand soil site compared with the sandy clay loam soil site. However, the effect in both cases was favourable and is suggested to improve crop grain yield and soil physical fertility on both commonly occurring soil types in the low rainfall, cropping zone of Western Australia.


2020 ◽  
Vol 8 (6) ◽  
pp. 1038-1041
Author(s):  
C Bharathi ◽  
P Murali Arthanari ◽  
C Chinnusamy

2021 ◽  
Vol 14 (4) ◽  
Author(s):  
Haroon Shahzad ◽  
Muhammad Iqbal ◽  
Noman Latif ◽  
Muhammad Arshad Khan ◽  
Qudrat Ullah Khan

2017 ◽  
Vol 9 (2) ◽  
pp. 720-729
Author(s):  
Sanjay T. Satpute ◽  
Man Singh

The understanding of soil and nutrient dynamics under drip fertigation is relevant for crop production as well as water and nutrient management. The aim of this study was to generate information about the distribution of phosphorus (P) under different fertigation strategies for onion production on sandy clay loam soil during 2007-2008 to 2008-2009. The study involved field experiment, laboratory analysis and modeling of P distribution. The phosphorus distribution data in the field were collected, analyzed and used to calibrate and validate the solute transport model HYDRUS-2D for sandy clay loam soil. The performance of HYDRUS-2D was evaluated by comparing its simulated values with the observed values of soil moisture and nutrient concentration. The coefficient of determination (R2), root mean square error (RMSE) and mean absolute error (MAE) were used as model performance indicators. The range of R2 between 0.72-0.99 for water as well as nutrient distribution indicates good correlation between the observed and simulated values. The MAE and RMSE values for water and nutrient distribution were in between 0.0009 to 0.0039 which indicated the accuracy of the model. From these results, it can be concluded that the model is performing well for predicting the P concentration in the soil as well as the soil moisture distribution for onion crop grown under sandy clay loam. The model was also validated for water and phosphorus distribution with the observed values at the end of the crop season and found to be performing well. The HYDRUS-2D model may be used to carry out simulations for different soil types and with different fertigation and irrigation strategies for developing guidelines.


Sign in / Sign up

Export Citation Format

Share Document