SUMMARY
This study evaluated the influence of fiber inserts, type of composites, and location of the gingival seat on microleakage in Class II resin composite restorations. Fifty noncarious human third molars were selected for the study. Standardized Class II box type cavities were prepared on the mesial and distal side of 45 teeth. The gingival margin was placed above the cementoenamel junction (CEJ) on the mesial side and below the CEJ on the distal side. The remaining five teeth received no cavity preparations. The prepared samples were divided randomly on the basis of type of composite and presence or absence of fiber inserts, into four experimental groups of 10 teeth each and two control groups of five teeth each. The groups were defined as follows: group I (n=10) – Z350 XT; group II (n=10) – Z350 XT with fibers; group III (n=10) – P90; group IV (n=10) – P90 with fibers; and group V (n=5) – positive controls, cavities were not restored; group VI (n=5) – negative controls, no cavities were prepared. The samples were stored in distilled water in incubator at 37°C for 24 hours and then subjected to 500 cycles of thermocycling (5°C and 55°C) with a dwell time of 15 seconds. They were then placed in a 2% methylene blue dye solution for 24 hours at 37°C. Samples were sectioned longitudinally and evaluated for microleakage at the occlusal and gingival margin under a stereomicroscope at 20× magnification. Kruskal-Wallis and Mann-Whitney U-tests were used to compare the mean leakage scores. Restorations with gingival margins in enamel showed significantly less microleakage. Significant reduction in microleakage was observed in groups restored with P90 composite than those restored with Z350 XT. No improvement in microleakage was observed with the use of fiber inserts (p>0.05).
Retrospective study of fracture survival in endodontically treated molars: the effect of single-unit crowns versus direct-resin composite restorations
