scholarly journals Degradation of polyethylene during extrusion. II. Degradation of low-density polyethylene, linear low-density polyethylene, and high-density polyethylene in film extrusion

2004 ◽  
Vol 92 (1) ◽  
pp. 684-685
Author(s):  
Thorbjörn Andersson ◽  
Berit Stålbom ◽  
Bengt Wesslén
Keyword(s):  
High Density Polyethylene ◽  
High Density ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Linear Low Density Polyethylene ◽  
Film Extrusion

An experimental study on foaming of linear low-density polyethylene/high-density polyethylene blends

2016 ◽  
Vol 53 (1) ◽  
pp. 83-105 ◽  
Author(s):  
Peyman Shahi ◽  
Amir Hossein Behravesh ◽  
Ali Haghtalab ◽  
Ghaus Rizvi ◽  
Fatemeh Goharpei
Keyword(s):  
Bulk Density ◽  
High Density Polyethylene ◽  
Cell Structure ◽  
High Density ◽  
Low Density Polyethylene ◽  
Low Density ◽  
Linear Low Density Polyethylene ◽  
Polyethylene Blends ◽  
Wide Range ◽  
Foaming Behavior

In this research work, foaming behavior of selected polyethylene blends was studied in a solid-state batch process, using CO2 as the blowing agent. Special emphasis was paid towards finding a relationship between foamability and thermal and rheological properties of blends. Pure high-density polyethylene, linear low-density polyethylene, and their blends with two weight fraction levels of high-density polyethylene (10 and 25%wt.) were examined. The dry blended batches were mixed using an internal mixer in a molten state, and then the disk-shaped specimens, 1.8 mm in thickness, were produced for foaming purposes. The foaming step was conducted over a wide range of temperatures (120–170℃), and the overall expansion and cellular morphology were evaluated via density measurements and captured SEM micrographs, respectively. Three-dimensional structural images were also captured using a high resolution X-ray micro CT for different foamed samples and were compared. Rheological and DSC tests for the virgin and blends were also performed to seek for a possible correlation with the formability. Based on the results, blended polyethylene foams exhibited remarkable expansion and highly enhanced cell structure compared to pure polymers. Bulk density, as low as 0.33 g/cm3, was obtained for blends, while for the virgin high-density polyethylene  and linear low-density polyethylene, bulk density lower than 0.5 g/cm3 was not attainable. The lowest density was observed at a foaming temperature of 10–20℃ above the melting (peak) temperature obtained via DSC test. Rheological characteristics, including storage modulus and cross-over frequency value, were also found to be the indicators for the materials foaming behavior. Moreover, blends with 25% wt. of high-density polyethylene exhibited the highest expansion values over a wider range of temperature compared with 90% linear low-density polyethylene/10% high-density polyethylene.

Sign in / Sign up

Export Citation Format

Share Document