ChemInform Abstract: THE EFFECT OF SURFACE IMPLANTATION OF YTTRIUM AND CERIUM UPON THE OXIDATION BEHAVIOR OF STAINLESS STEELS AND ALUMINIZED COATINGS AT HIGH TEMPERATURES

1977 ◽  
Vol 8 (4) ◽  
pp. no-no
Author(s):  
J. E. ANTILL ◽  
M. J. BENNETT ◽  
R. F. A. CARNEY ◽  
G. DEARNALEY ◽  
F. H. FERN ◽  
...  
Keyword(s):  
High Temperatures ◽  
Stainless Steels ◽  
Oxidation Behavior ◽  
Effect Of Surface

Comparative Study on the Oxidation Behavior of Austenitic and Ferritic Heat-Resistant Stainless Steels at High Temperatures

JOM ◽  
2019 ◽  
Vol 71 (10) ◽  
pp. 3744-3754 ◽  
Author(s):  
Yuqing Zhou ◽  
Dening Zou ◽  
Yang Pang ◽  
Tongyu Wei ◽  
Wei Zhang ◽  
...  
Keyword(s):  
Comparative Study ◽  
High Temperatures ◽  
Stainless Steels ◽  
Oxidation Behavior ◽  
Heat Resistant

The effect of surface implantation of yttrium and cerium upon the oxidation behaviour of stainless steels and aluminized coatings at high temperatures

1976 ◽  
Vol 16 (10) ◽  
pp. 729-745 ◽  
Author(s):  
J.E. Antill ◽  
M.J. Bennett ◽  
R.F.A. Carney ◽  
G. Dearnaley ◽  
F.H. Fern ◽  
...  
Keyword(s):  
High Temperatures ◽  
Stainless Steels ◽  
Oxidation Behaviour ◽  
Effect Of Surface

Oxidation behavior of 26Cr-16Ni and AISI 309 austenitic stainless steels in air flow at 1,173 K

2015 ◽  
Vol 57 (7-8) ◽  
pp. 597-601 ◽  
Author(s):  
Peeraya Pipatnukun ◽  
Panyawat Wangyao ◽  
Gobboon Lothongkum
Keyword(s):  
Stainless Steels ◽  
Oxidation Behavior ◽  
Air Flow ◽  
Austenitic Stainless Steels

Oxidation behavior of rhenium at high temperatures

1993 ◽  
Vol 28 (12) ◽  
pp. 1565-1570 ◽  
Author(s):  
T.C. Chou ◽  
A. Joshi ◽  
C.M. Packer
Keyword(s):  
High Temperatures ◽  
Oxidation Behavior

The effect of surface preparation on the oxidation behavior of gamma TiAl-base intermetallic alloys

1996 ◽  
Vol 35 (12) ◽  
pp. 1417-1422 ◽  
Author(s):  
J.M. Rakowski ◽  
G.H. Meier ◽  
F.S. Pettit ◽  
F. Dettenwanger ◽  
E. Schumann ◽  
...  
Keyword(s):  
Oxidation Behavior ◽  
Surface Preparation ◽  
Intermetallic Alloys ◽  
Effect Of Surface

Effect of Phase Fraction Ratio Between Al3Mg2 and Mg2Si on the Oxidation Behavior of Al–Mg–Si Alloys

2021 ◽  
Vol 16 (7) ◽  
pp. 1047-1051
Author(s):  
Seong-Ho Ha ◽  
Abdul Wahid Shah ◽  
Bong-Hwan Kim ◽  
Young-Ok Yoon ◽  
Hyun-Kyu Lim ◽  
...  
Keyword(s):  
Oxidation Resistance ◽  
High Temperatures ◽  
Cross Sections ◽  
Oxidation Behavior ◽  
Eutectic Phase ◽  
Mg Alloy ◽  
Phase Fraction ◽  
The Matrix ◽  
Si Content

The effect of the phase fraction ratio between Al3Mg2 and Mg2Si on the oxidation resistance of Al–Mg–Si alloys at high temperatures was investigated. With addition of 1 mass%Si in Al-6 mass%Mg alloy, the as-cast microstructures showed formation of Mg2Si phase by eutectic reactions. With increasing Si content more than 3 mass%, the Mg2Si and Si are formed as eutectic phases with no β-Al3Mg2 phase. In addition, with an increase in the Si content from 3 mass%, significantly refined as-cast microstructures and distribution of extended eutectic phase areas were observed. The oxidized cross-sections of Al-6 mass%Mg and Al-6 mass%Mg-1 mass%Si alloys showed coarse and dark areas, which are considered as oxide clusters, nonuniformly grown into the matrix. However, Al-6 mass%Mg-3 mass%Si and Al-6 mass%Mg-5 mass%Si alloys had no significantly grown oxide clusters on the surfaces. Based on the results, it was concluded that the reduction of the ratio between β-Al3Mg2 and Mg2Si phases can reduce the rapid oxidation of Mg.

Sign in / Sign up

Export Citation Format

Share Document