Exploring the Corundum Structure as a Host for Colored Compounds - Synthesis, Structures, and Optical Studies of (MM′)3 TeO6 (M = Mg, Mn, Co, Ni, Zn; M′ = Mg, Mn, Co, Ni, Cu)

2018 ◽  
Vol 2018 (20-21) ◽  
pp. 2277-2284 ◽  
Author(s):  
Anupam Bhim ◽  
Jagannatha Gopalakrishnan ◽  
Srinivasan Natarajan
1987 ◽  
Vol 48 (C5) ◽  
pp. C5-525-C5-528 ◽  
Author(s):  
K. J. MOORE ◽  
P. DAWSON ◽  
C. T. FOXON
Keyword(s):  
Type I ◽  
Type Ii ◽  

1970 ◽  
Author(s):  
Roger James Bartlett
Keyword(s):  

2020 ◽  
pp. 260-266
Author(s):  
V.E. Arkhipov ◽  
T.I. Murav’eva ◽  
M.S. Pugachev ◽  
O.O. Shcherbakova

The problems of changes in the coating structure depending on the composition of the sprayed mechanical mixture using copper particles and mixture of copper and zinc particles (" brass") and the effect of structural factors on the tribological properties of the deposited metal layer are considered. The results of X-ray structural, phase, chemical and durometric analyzes, as well as tribological testing of coatings are presented. It is found that structure with hardness of ≈102.7 HV is formed in the coating from mechanical mixture of particles of copper and aluminum oxide (corundum). Numerous pores are observed in the structure of the deposited metal layer, the main size of which does not exceed 2 μm. In the coating from mechanical mixture of particles copper, zinc and aluminum oxide (corundum), structure is formed based on copper with hardness of ≈106.5 HV, zinc — ≈49.7 HV, intermetallic compounds (γ- and ε-phases) — ≈168.7 HV, the mass fraction of which is 62.0, 7.9 and 24.2 %, respectively. Both coatings can be used in sliding friction pairs.


Author(s):  
Farzad Bayati ◽  
Mohammad Kazem Mohammadi ◽  
Reza Jalilzadeh Yengejeh ◽  
Ali Akbar Babaei

Plasmonics ◽  
2016 ◽  
Vol 13 (1) ◽  
pp. 31-38 ◽  
Author(s):  
Binbin Yu ◽  
Huiyu Chen ◽  
Qianwen Liu ◽  
Dingguo Li ◽  
Shengli Huang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document