Motion artifacts assessment and correction using optical tracking in synchrotron radiation breast CT

Abstract Background The SYRMA-3D collaboration is setting up the first clinical trial of phase-contrast breast CT with synchrotron radiation at the Elettra synchrotron facility in Trieste, Italy. In this communication, a quality control protocol for breast CT is proposed, and a first test of image quality measurements is performed by means of a custom-made radiographic phantom. Materials and methods A set of projections is acquired and used to perform a CT reconstruction of two selected portions of the phantom. Such portions contain a uniform layer of water and a set of radiographic inserts, respectively. Together, they allow to perform several image quality measurements, namely CT number linearity, reconstruction accuracy, uniformity, noise, and low contrast resolution. All measurements are repeated at different beam energies in the range of interest, and at two different dose values. Results Measurements show a good linearity in the soft tissue range, paired to a high accuracy of the CT number reconstruction. Uniformity and noise measurements show that reconstruction inhomogeneities are bound to a few percent of the average pixel values. However, low contrast detectability is limited to the higher portion of the explored energy range. Conclusions The results of the measurements are satisfactory in terms of their quality, feasibility and reproducibility. With minimal modifications, the phantom is promising to allow a set of image quality measurements to be used in the upcoming clinical trial.

Download Full-text

Image quality comparison between a phase-contrast synchrotron radiation breast CT and a clinical breast CT: a phantom based study

Scientific Reports ◽

10.1038/s41598-019-54131-z ◽

2019 ◽

Vol 9 (1) ◽

Cited By ~ 5

Author(s):

Luca Brombal ◽

Fulvia Arfelli ◽

Pasquale Delogu ◽

Sandro Donato ◽

Giovanni Mettivier ◽

...

Keyword(s):

Synchrotron Radiation ◽

Image Quality ◽

Spatial Resolution ◽

Phase Retrieval ◽

Medical Center ◽

Equivalent Material ◽

Noise Power ◽

Breast Ct ◽

Noise Ratio

AbstractIn this study we compared the image quality of a synchrotron radiation (SR) breast computed tomography (BCT) system with a clinical BCT in terms of contrast-to-noise ratio (CNR), signal-to-noise ratio (SNR), noise power spectrum (NPS), spatial resolution and detail visibility. A breast phantom consisting of several slabs of breast-adipose equivalent material with different embedded targets (i.e., masses, fibers and calcifications) was used. Phantom images were acquired using a dedicated BCT system installed at the Radboud University Medical Center (Nijmegen, The Netherlands) and the SR BCT system at the SYRMEP beamline of Elettra SR facility (Trieste, Italy) based on a photon-counting detector. Images with the SR setup were acquired mimicking the clinical BCT conditions (i.e., energy of 30 keV and radiation dose of 6.5 mGy). Images were reconstructed with an isotropic cubic voxel of 273 µm for the clinical BCT, while for the SR setup two phase-retrieval (PhR) kernels (referred to as “smooth” and “sharp”) were alternatively applied to each projection before tomographic reconstruction, with voxel size of 57 × 57 × 50 µm3. The CNR for the clinical BCT system can be up to 2-times higher than SR system, while the SNR can be 3-times lower than SR system, when the smooth PhR is used. The peak frequency of the NPS for the SR BCT is 2 to 4-times higher (0.9 mm−1 and 1.4 mm−1 with smooth and sharp PhR, respectively) than the clinical BCT (0.4 mm−1). The spatial resolution (MTF10%) was estimated to be 1.3 lp/mm for the clinical BCT, and 5.0 lp/mm and 6.7 lp/mm for the SR BCT with the smooth and sharp PhR, respectively. The smallest fiber visible in the SR BCT has a diameter of 0.15 mm, while for the clinical BCT is 0.41 mm. Calcification clusters with diameter of 0.13 mm are visible in the SR BCT, while the smallest diameter for the clinical BCT is 0.29 mm. As expected, the image quality of the SR BCT outperforms the clinical BCT system, providing images with higher spatial resolution and SNR, and with finer granularity. Nevertheless, this study assesses the image quality gap quantitatively, giving indications on the benefits associated with SR BCT and providing a benchmarking basis for its clinical implementation. In addition, SR-based studies can provide a gold-standard in terms of achievable image quality, constituting an upper-limit to the potential clinical development of a given technique.

Download Full-text

Real-time correction by optical tracking with integrated geometric distortion correction for reducing motion artifacts in functional MRI

Magnetic Resonance in Medicine ◽

10.1002/mrm.24309 ◽

2012 ◽

Vol 69 (3) ◽

pp. 734-748 ◽

Cited By ~ 19

Author(s):

David Rotenberg ◽

Mark Chiew ◽

Shawn Ranieri ◽

Fred Tam ◽

Rajiv Chopra ◽

...

Keyword(s):

Real Time ◽

Functional Mri ◽

Motion Artifacts ◽

Distortion Correction ◽

Optical Tracking ◽

Geometric Distortion ◽

Time Correction

Download Full-text

Direct Observation of Monolayer Zones in Al-wt 4% Cu

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100178823 ◽

1990 ◽

Vol 48 (1) ◽

pp. 14-15

Author(s):

B. Jouffrey ◽

D. Dorignac ◽

A. Bourret

Keyword(s):

Solid Solution ◽

Synchrotron Radiation ◽

Direct Observation ◽

Supersaturated Solid Solution ◽

Original Model ◽

X Ray ◽

Image Position

Since the early works on GP zones and the model independently proposed by Preston and Guinier on the first steps of precipitation in supersaturated solid solution of aluminium containing a few percent of copper, many works have been performed to understand the structure of different stages in the sequence of precipitation.The scheme which is generally admitted can be drawn from a work by Phillips.In their original model Guinier and Preston analysed a GP zone as composed of a single (100) copperrich plane surrounded by aluminum atomic planes with a slightly shorter distance from the original plane than in the solid solution.From X-ray measurements it has also been shown that GP1 zones were not only copper monolayer zones. They could be up to a few atomic planes thick. Different models were proposed by Guinier, Gerold, Toman. Using synchrotron radiation, proposals have been recently made.

Download Full-text