YieldOpt, a model to predict the power output and energy yield for concentrating photovoltaic modules

2014 ◽  
Vol 23 (3) ◽  
pp. 385-397 ◽  
Author(s):  
Marc Steiner ◽  
Gerald Siefer ◽  
Thorsten Hornung ◽  
Gerhard Peharz ◽  
Andreas W. Bett
2015 ◽  
Vol 57 (12) ◽  
pp. 1338-1344
Author(s):  
S. A. Bogomolova ◽  
Yu. E. Lukashov ◽  
M. Z. Shvarts

2019 ◽  
Vol 11 (22) ◽  
pp. 6234 ◽  
Author(s):  
Hyeonwook Park ◽  
Sungho Chang ◽  
Sanghwan Park ◽  
Woo Kyoung Kim

The outdoor performance of n-type bifacial Si photovoltaic (PV) modules and string systems was evaluated for two different albedo (ground reflection) conditions, i.e., 21% and 79%. Both monofacial and bifacial silicon PV modules were prepared using n-type bifacial Si passivated emitter rear totally diffused cells with multi-wire busbar incorporated with a white and transparent back-sheet, respectively. In the first set of tests, the power production of the bifacial PV string system was compared with the monofacial PV string system installed on a grey concrete floor with an albedo of ~21% for approximately one year (June 2016–May 2017). In the second test, the gain of the bifacial PV string system installed on the white membrane floor with an albedo of ~79% was evaluated for approximately ten months (November 2016–August 2017). During the second test, the power production by an equivalent monofacial module installed on a horizontal solar tracker was also monitored. The gain was estimated by comparing the energy yield of the bifacial PV module with that of the monofacial module. For the 1.5 kW PV string systems with a 30° tilt angle to the south and 21% ground albedo, the year-wide average bifacial gain was determined to be 10.5%. An increase of the ground albedo to 79% improved the bifacial gain to 33.3%. During the same period, the horizontal single-axis tracker yielded an energy gain of 15.8%.


2012 ◽  
Vol 466-467 ◽  
pp. 272-276
Author(s):  
Dao E Qiao ◽  
Xiao Li Xu

Efficient energy yield is a major concern in solar photovoltaic (PV) systems. This paper describes a distributed control system to optimize the power output of the PV systems. The PV systems contain many PV modules. And every PV module has a monitoring and control network node. The communication data are successfully transmitted using a low-cost ZigBee wireless network. The field conditions are monitored by voltage, current, irradiance, and temperature sensors. The power operating point tracking is implemented at the PV module level. The reference voltage is calculated based on a neural network model, which is used to identify maximum power point. And the output voltage is regulated by a digital controller in the integrated converter according to the reference voltage. Experiments show that the power output can be greatly increased with this distributed control system under many shadow conditions.


2003 ◽  
Vol 125 (4) ◽  
pp. 433-440 ◽  
Author(s):  
Sander Mertens ◽  
Gijs van Kuik ◽  
Gerard van Bussel

Application of wind turbines on roofs of higher buildings is a subject of increasing interest. However, the wind conditions at the roof are complex and suitable wind turbines for this application are not yet developed. This paper addresses both issues: the wind conditions on the roof and the behavior of a roof-located wind turbine with respect to optimized energy yield. Vertical Axis Wind Turbines (VAWTs) are to be preferred for operation in a complex wind environment as is found on top of a roof. Since the wind vector at a roof is not horizontal, wind turbines on a roof operate in skewed flow. Thus the behavior of an H-Darrieus (VAWT) is studied in skewed flow condition. Measurements showed that the H-Darrieus produces an increased power output in skewed flow. The measurements are compared with a model based on Blade Element Momentum theory that also shows this increased power output. This in contradiction to a HAWT in skewed flow which suffers from a power decrease. The paper thus concludes that due to this property an H-Darrieus is preferred above the HAWT for operation on a flat roof of higher buildings.


2020 ◽  
Vol 6 ◽  
pp. 680-686 ◽  
Author(s):  
A. Hadj Arab ◽  
B. Taghezouit ◽  
K. Abdeladim ◽  
S. Semaoui ◽  
A. Razagui ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document