Effects of Natural Gas Percentage on Performance and Emissions of a Natural Gas/Diesel Dual-Fuel Engine

2015 ◽  
pp. 181-188
Author(s):  
Zhiqin Jia ◽  
Ingemar Denbratt
Keyword(s):  
Natural Gas ◽  
Dual Fuel ◽  
Performance And Emissions

Combustion characteristics of compressed natural gas/diesel dual-fuel turbocharged compressed ignition engine

2003 ◽  
Vol 217 (9) ◽  
pp. 833-838 ◽  
Author(s):  
Liu Shenghua ◽  
Zhou Longbao ◽  
Wang Ziyan ◽  
Ren Jiang
Keyword(s):  
Natural Gas ◽  
Ignition Delay ◽  
Combustion Characteristics ◽  
Operating Conditions ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Delay Effects ◽  
Low Load ◽  
Performance And Emissions ◽  
Ci Engine

The combustion characteristics of a turbocharged natural gas and diesel dual-fuelled compression ignition (CI) engine are investigated. With the measured cylinder pressures of the engine operated on pure diesel and dual fuel, the ignition delay, effects of pilot diesel and engine load on combustion characteristics are analysed. Emissions of HC, CO, NOx and smoke are measured and studied too. The results show that the quantity of pilot diesel has important effects on the performance and emissions of a dual-fuel engine at low-load operating conditions. Ignition delay varies with the concentration of natural gas. Smoke is much lower for the developed dual-fuel engine under all the operating conditions.

Performance and Emissions Characteristics of Bio-Diesel (B100)-Ignited Methane and Propane Combustion in a Four Cylinder Turbocharged Compression Ignition Engine

2012 ◽  
Vol 134 (8) ◽  
Author(s):  
N. T. Shoemaker ◽  
C. M. Gibson ◽  
A. C. Polk ◽  
S. R. Krishnan ◽  
K. K. Srinivasan
Keyword(s):  
Natural Gas ◽  
Fuel Efficiency ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Propane Combustion ◽  
Compression Ignition Engine ◽  
Engine Knock ◽  
Performance And Emissions ◽  
Cylinder Compression ◽  
Dual Fueling

Different combustion strategies and fuel sources are needed to deal with increasing fuel efficiency demands and emission restrictions. One possible strategy is dual fueling using readily available resources. Propane and natural gas are readily available with the current infrastructure and biodiesel is growing in popularity as a renewable fuel. This paper presents experimental results from dual fuel combustion of methane (as a surrogate for natural gas) and propane as primary fuels with biodiesel pilots in a 1.9 liter, turbocharged, 4-cylinder compression ignition engine at 1800 rev/min. Experiments were performed with different percentage energy substitutions (PES) of propane and methane and at different brake mean effective pressures (BMEP/bmep). Brake thermal efficiency (BTE) and emissions (NOx, HC, CO, CO2, O2 and smoke) were also measured. Maximum PES levels for B100-methane dual fueling were limited to 70% at 2.5 bars bmep and 48% at 10 bars bmep, and corresponding values for B100-propane dual fueling were 64% and 43%, respectively. Maximum PES was limited by misfire at 2.5 bars bmep and the onset of engine knock at 10 bars bmep. Dual fuel BTEs approached straight B100 values at 10 bars bmep while they were significantly lower than B100 values at 2.5 bars bmep. In general, dual fueling was beneficial in reducing NOx and smoke emissions by 33% and 50%, respectively, from baseline B100 levels; however, both CO and THC emissions were significantly higher than baseline B100 levels at all PES and loads.

Performance and Emissions Characteristics of Bio-Diesel (B100)-Ignited Methane and Propane Combustion in a Four Cylinder Turbocharged Compression Ignition Engine

2011 ◽  
Author(s):  
N. T. Shoemaker ◽  
C. M. Gibson ◽  
A. C. Polk ◽  
S. R. Krishnan ◽  
K. K. Srinivasan
Keyword(s):  
Natural Gas ◽  
Fuel Efficiency ◽  
Dual Fuel ◽  
Propane Combustion ◽  
Compression Ignition Engine ◽  
Brake Thermal Efficiency ◽  
Engine Knock ◽  
Performance And Emissions ◽  
Dual Fuel Combustion ◽  
Dual Fueling

Different combustion strategies and fuel sources are needed to deal with increasing fuel efficiency demands and emission restrictions. One possible strategy is dual fueling using readily available resources. Propane and natural gas are readily available with the current infrastructure and biodiesel is growing in popularity as a renewable fuel. This paper presents experimental results from dual fuel combustion of methane (as a surrogate for natural gas) and propane as primary fuels with biodiesel pilots in a 1.9 liter, turbocharged, 4 cylinder diesel engine at 1800 rev/min. Experiments were performed with different percentage energy substitutions (PES) of propane and methane and at different brake mean effective pressures (BMEP/bmep). Brake thermal efficiency (BTE) and emissions (NOx, HC, CO, CO2, O2 and smoke) were also measured. Maximum PES levels for B100-methane dual fuelling were limited to 70% at 2.5 bar bmep and 48% at 10 bar bmep, and corresponding values for B100-propane dual fuelling were 64% and 43%, respectively. Maximum PES was limited by misfire at 2.5 bar bmep and the onset of engine knock at 10 bar bmep. Dual fuel BTEs approached straight B100 values at 10 bar bmep while they were significantly lower than B100 values at 2.5 bar bmep. In general dual fuelling was beneficial in reducing NOx and smoke emissions by 33% and 50%, respectively from baseline B100 levels; however, both CO and THC emissions were significantly higher than baseline B100 levels at all PES and loads.

To Study the Effects of (Compressed Natural Gas + Diesel) Under Dual Fuel Mode on Engine Performance and Emissions Characteristic

2020 ◽  
Vol 18 (2) ◽  
pp. 108-112
Author(s):  
Ashok Kumar ◽  
Piyushi Nautiyal ◽  
Kamalasish Dev
Keyword(s):  
Diesel Engine ◽  
Natural Gas ◽  
Engine Performance ◽  
Experimental Results ◽  
Dual Fuel ◽  
Compressed Natural Gas ◽  
Performance And Emissions ◽  
Pilot Fuel ◽  
Energy Share ◽  
Engine Performance And Emissions

The present study is investigated on the performance and emissions characteristics of a diesel engine fuelled by compressed natural gas and base diesel (CNG + Diesel). The CNG fuels used as the primary fuel, and diesel as pilot fuel under dual-fuel mode. The pilot fuel is partially replaced by CNG at a different percentage. The primary fuel is injected into the engine with intake air during the suction stroke. The experimental results reveal the effect of CNG + diesel under dual fuel mode on BTE, BSFC, CO, CO2, HC, NOx and Smoke. It is observed from the experimental results that CO2, NOx and Smoke emissions decreased but HC and CO emissions increase with an increase in CNG energy share.

Performance and Emissions of a Converted RABA 2356 Bus Engine in Diesel and Dual Fuel Diesel/Natural Gas Operation

1993 ◽  
Author(s):  
M. David Checkel ◽  
Paul E. Newman ◽  
Bruce H. van der bee ◽  
Ivan Pollak
Keyword(s):  
Natural Gas ◽  
Dual Fuel ◽  
Performance And Emissions

J0801-3-3 Effects of Injection Conditions on Performance and Emissions in a Dual Fuel Natural Gas Engine

2010 ◽  
Vol 2010.7 (0) ◽  
pp. 181-182 ◽  
Author(s):  
Jengho KANG ◽  
Keizo IWATA ◽  
Yutaka OZAWA ◽  
Takuma OGATA ◽  
Takuji ISHIYAMA ◽  
...  
Keyword(s):  
Natural Gas ◽  
Dual Fuel ◽  
Gas Engine ◽  
Natural Gas Engine ◽  
Performance And Emissions

scholarly journals Emission and Performance Optimization of Marine Four-Stroke Dual-Fuel Engine Based on Response Surface Methodology

2020 ◽  
Vol 2020 ◽  
pp. 1-9
Author(s):  
Huaiyu Wang ◽  
Huibing Gan ◽  
Guanjie Wang ◽  
Guoqiang Zhong
Keyword(s):  
Response Surface Methodology ◽  
Natural Gas ◽  
Response Surface ◽  
Performance Optimization ◽  
Engine Performance ◽  
Dual Fuel ◽  
Boost Pressure ◽  
Shipping Industry ◽  
Performance And Emissions ◽  
And Performance

As the emissions regulations have become more stringent, reducing NOX emissions is of great importance to the shipping industry. Due to the price and emissions advantages of natural gas, the diesel-natural gas engines have become an attractive solution for engine manufacturers. Firstly, in this paper, the NOX emissions prediction model of a large marine four-stroke dual-fuel engine is built by using AVL-BOOST. In addition, the model is further calibrated to calculate the performance and emissions of the engine. Then, the influences of boost pressure, compression ratio, and the timing of intake valve closing on engine performance and emissions are analyzed. Finally, the response surface methodology is used to optimize the emissions and performance to obtain the optimal setting parameters of the engine. The results indicate that the response surface method is a highly desirable optimization method, which can save a lot of repeated research. Compared with the results from manufactured data, the power is increased by 0.55% and the BSFC, the NOX emissions, and the peak combustion pressure are decreased by 0.60%, 13.21%, and 1.51%, respectively, at low load.

Sign in / Sign up

Export Citation Format

Share Document