Numerical Simulation of the Bursting of a Laminar Separation Bubble

2007 ◽  
pp. 253-267 ◽  
Author(s):  
Olaf Marxen ◽  
Dan Henningson
Keyword(s):  
Numerical Simulation ◽  
Separation Bubble ◽  
Laminar Separation Bubble ◽  
Laminar Separation

Direct Numerical Simulation and Large Eddy Simulation of Laminar Separation Bubbles at Moderate Reynolds Numbers

2014 ◽  
Vol 136 (6) ◽  
Author(s):  
Francois Cadieux ◽  
Julian A. Domaradzki ◽  
Taraneh Sayadi ◽  
Sanjeeb Bose
Keyword(s):  
Heat Transfer ◽  
Numerical Simulation ◽  
Boundary Layer ◽  
Direct Numerical Simulation ◽  
Separation Bubble ◽  
Leading Edge ◽  
Transition To Turbulence ◽  
Laminar Separation Bubble ◽  
Laminar Separation ◽  
Large Eddy

Flows over airfoils and blades in rotating machinery for unmanned and microaerial vehicles, wind turbines, and propellers consist of different flow regimes. A laminar boundary layer near the leading edge is often followed by a laminar separation bubble with a shear layer on top of it that experiences transition to turbulence. The separated turbulent flow then reattaches and evolves downstream from a nonequilibrium turbulent boundary layer to an equilibrium one. Typical Reynolds-averaged Navier–Stokes (RANS) turbulence modeling methods were shown to be inadequate for such laminar separation bubble flows (Spalart and Strelets, 2000, “Mechanisms of Transition and Heat Transfer in a Separation Bubble,” J. Fluid Mech., 403, pp. 329–349). Direct numerical simulation (DNS) is the most reliable but is also the most computationally expensive alternative. This work assesses the capability of large eddy simulations (LES) to reduce the resolution requirements for such flows. Flow over a flat plate with suitable velocity boundary conditions away from the plate to produce a separation bubble is considered. Benchmark DNS data for this configuration are generated with the resolution of 59 × 106 mesh points; also used is a different DNS database with 15 × 106 points (Spalart and Strelets, 2000, “Mechanisms of Transition and Heat Transfer in a Separation Bubble,” J. Fluid Mech., 403, pp. 329–349). Results confirm that accurate LES are possible using O(1%) of the DNS resolution.

scholarly journals Laminar Separation Bubble and Flow Topology of NACA 0015 at Low Reynolds Number

CFD Letters ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 36-51
Author(s):  
Mohamed Ibren ◽  
Amelda Dianne Andan ◽  
Waqar Asrar ◽  
Erwin Sulaeman
Keyword(s):  
Numerical Simulation ◽  
Reynolds Number ◽  
Flow Field ◽  
Separation Bubble ◽  
Low Reynolds Number ◽  
Angle Of Attack ◽  
Laminar Separation Bubble ◽  
Laminar Separation ◽  
Low Reynolds ◽  
Naca 0015

The development of sophisticated unmanned aerial vehicles and wind turbines for daily activities has triggered the interest of researchers. However, understanding the flow phenomena is a strenuous task due to the complexity of the flow field. The engaging topic calls for more research at low Reynolds numbers. The computational investigations on a two-dimensional (2D) airfoil are presented in this paper. Numerical simulation of unsteady, laminar-turbulent flow around NACA 0015 airfoil was performed by using shear-stress transport (SST) model at relatively low Reynolds number (8.4 × 104 to 1.7 × 105) and moderate angles of attack (0 ≤ α ≤ 6). In general, on the suction side, with increasing Reynolds number and angles of attack, separation, and reattachment point shifts upstream and concurrently shrinking the size of the laminar bubble. However, On the pressure side, the laminar bubble is seen to move toward the trailing edge at the relatively same size as the angle of attack increases. Moreover, the variations in the angle of attack have more influence on the laminar separation bubble characteristics as compared to the Reynolds number. The reattachment points were barely observed for the range of the angles of attack studied. At very high angles of attack, it is recommended to simulate the flow field using large eddy simulation or direct numerical simulation since the flow is considered three-dimensional and detached from the surface thus forming a complex phenomenon.

scholarly journals Effect of synthetic jet modulation schemes on the reduction of a laminar separation bubble

2018 ◽  
Vol 3 (3) ◽  
Author(s):  
J. H. Seo ◽  
F. Cadieux ◽  
R. Mittal ◽  
E. Deem ◽  
L. Cattafesta
Keyword(s):  
Separation Bubble ◽  
Synthetic Jet ◽  
Laminar Separation Bubble ◽  
Laminar Separation ◽  
Modulation Schemes
Sign in / Sign up

Export Citation Format

Share Document