Laser Performance and Temperature-Dependent Spectroscopy of Titanium-Doped Crystals

1986 ◽  
pp. 235-239 ◽  
Author(s):  
K. L. Schepler
Keyword(s):  
Temperature Dependent ◽  
Laser Performance

Yb-Doped Sesquioxide Ceramics: Temperature Dependent Laser Performance and Spectroscopy

2007 ◽  
Author(s):  
Nikolay Ter-Gabrielyan ◽  
Mark Dubinskii ◽  
Larry D. Merkle ◽  
G. Alex Newburgh
Keyword(s):  
Temperature Dependent ◽  
Laser Performance

Temperature-Dependent Fluorescence Properties and Diode-Pumped Deep Red Laser Performance of Pr:LiGdF 4 Crystal

2015 ◽  
Vol 32 (5) ◽  
pp. 054210 ◽  
Author(s):  
Yu-Xia Zhang ◽  
Shu-Xian Wang ◽  
Lieto Di Alberto ◽  
Guo-Lei Yu ◽  
Hao-Hai Yu ◽  
...  
Keyword(s):  
Fluorescence Properties ◽  
Temperature Dependent ◽  
Laser Performance ◽  
Diode Pumped

(111) Monocrystalline Nickel Films

1972 ◽  
Vol 30 ◽  
pp. 512-513
Author(s):  
T.E. Pratt ◽  
R.W. Vook
Keyword(s):  
Film Thickness ◽  
Deposition Rate ◽  
Room Temperature ◽  
Narrow Range ◽  
High Vacuum ◽  
Residual Pressure ◽  
Temperature Dependent ◽  
Deposition Parameters ◽  
Transmission Electron ◽  
Substrate Temperatures

(111) oriented thin monocrystalline Ni films have been prepared by vacuum evaporation and examined by transmission electron microscopy and electron diffraction. In high vacuum, at room temperature, a layer of NaCl was first evaporated onto a freshly air-cleaved muscovite substrate clamped to a copper block with attached heater and thermocouple. Then, at various substrate temperatures, with other parameters held within a narrow range, Ni was evaporated from a tungsten filament. It had been shown previously that similar procedures would yield monocrystalline films of CU, Ag, and Au.For the films examined with respect to temperature dependent effects, typical deposition parameters were: Ni film thickness, 500-800 A; Ni deposition rate, 10 A/sec.; residual pressure, 10-6 torr; NaCl film thickness, 250 A; and NaCl deposition rate, 10 A/sec. Some additional evaporations involved higher deposition rates and lower film thicknesses.Monocrystalline films were obtained with substrate temperatures above 500° C. Below 450° C, the films were polycrystalline with a strong (111) preferred orientation.

Temperature-dependent translational regulation of the ER omega-3 fatty acid desaturase gene in wheat root tips

2000 ◽  
Vol 24 (6) ◽  
pp. 805-813 ◽  
Author(s):  
Gorou Horiguchi ◽  
Takuichi Fuse ◽  
Naoto Kawakami ◽  
Hiroaki Kodama ◽  
Koh Iba
Keyword(s):  
Fatty Acid ◽  
Translational Regulation ◽  
Fatty Acid Desaturase ◽  
Wheat Root ◽  
Omega 3 ◽  
Root Tips ◽  
Temperature Dependent ◽  
Desaturase Gene ◽  
Omega 3 Fatty Acid ◽  
Fatty Acid Desaturase Gene
Sign in / Sign up

Export Citation Format

Share Document