Sulphur Deposition and Changes in Swedish Lake Chemistry 1988–1993

1995 ◽  
pp. 2449-2454
Author(s):  
L. Rapp ◽  
K. Bishop
2002 ◽  
Vol 59 (8) ◽  
pp. 1287-1295 ◽  
Author(s):  
A Henriksen ◽  
P J Dillon ◽  
J Aherne

Critical loads of acidity and the amount by which these critical loads are exceeded by atmospheric deposition (termed "exceedances") were estimated for 1469 lakes from five regions in south-central Ontario, Canada, using single lake chemistry measurements and sulphur deposition data for the period 1976–1999. Based on the Steady-State Water Chemistry (SSWC) model, four of the five regions had low critical loads, which is consistent with the underlying geology (silicate bedrock) and the thin glacial soils in these regions. Sulphur deposition in the study area showed a clear downward trend over the time period, with a decrease of approximately 50% to current levels of approximately 44 meq·m–2·year–1. As a result of the declining deposition, the portion of lakes with critical load exceedances has dropped substantially, from 74–82% in the four sensitive regions in 1976 to 11–26% in 1999. The pentile critical load is typically used as a regional target to account for uncertainties, but also to ensure that a sufficient percentage of lakes are protected (95%). This suggests that further reductions in emissions are required to reduce depositions to approximately 34 meq·m–2·year–1 (11 kg S·ha–1·year–1) to prevent critical load exceedance.


1995 ◽  
Vol 85 (4) ◽  
pp. 2449-2454 ◽  
Author(s):  
L. Rapp ◽  
K. Bishop

1987 ◽  
Vol 22 (3) ◽  
pp. 365-376
Author(s):  
C. H. Chan ◽  
L. H. Perkins

Abstract Wet deposition estimates were computed from monthly wet precipitation samples collected in the Lake Superior Basin. Sulphate and nitrogen loadings from wet precipitation corresponded to 142 and 40 thousand tonnes per year. On a percentage basis, wet deposition of sulphate and nitrogen accounted for 21% and 54%, respectively, of the total load. Atmospheric sources for other major ions ranged from 1 to 10%. Atmospheric deposition at the eastern end of Lake Superior was higher than the western end of the Basin. The relative accuracy of these estimates were examined in relation to the changes in lake chemistry in Lake Superior from 1973 to 1983.


2021 ◽  
Vol 758 ◽  
pp. 143639 ◽  
Author(s):  
Charles Marty ◽  
Louis Duchesne ◽  
Suzanne Couture ◽  
Christian Gagnon ◽  
Daniel Houle

2009 ◽  
Vol 123 (2) ◽  
pp. 146 ◽  
Author(s):  
Robert Alvo

I monitored Common Loon (Gavia immer) breeding success in relation to lake pH (range 4.0–8.5) between 1982 and 2007 on 38 single-pair lakes (5–88 ha) in the Sudbury, Ontario, area. No chicks fledged on lakes with pH < 4.4. Chicks fledged on lakes with slightly higher pH only if the lakes were relatively large. Acidic lakes became less acidic as sulphur dioxide emissions from the Sudbury smelters and sulphur deposition from other long-range sources decreased. Two lakes initially too acidic to support successful loon reproduction eventually had successful reproduction. One loon pair used two large acidic lakes (combined area 140 ha) connected by shallow rapids, and one of the adults made extremely long dives (average = 99 s) while foraging for the chicks. One chick died on that lake after apparently ingesting a very large food item; the lack of smaller items was attributed to the lake’s acidity. My results suggest that a shortage of food for chicks is the main reason why low pH reduces breeding success. I suggest that, for lakes without high levels of dissolved organic carbon (DOC), the critical pH for loon breeding success is approximately 4.3, and the suboptimal pH is approximately 4.4–6.0.


2017 ◽  
Vol 96 (4) ◽  
pp. 886-894 ◽  
Author(s):  
Jinghong Hu ◽  
Zhengdong Lei ◽  
Zhangxin Chen ◽  
Zhanguo Ma

2021 ◽  
Author(s):  
Bashirul Haq

Abstract Sour gas reservoirs are vital sources for natural gas production. Sulphur deposition in the reservoir reduces a considerable amount of gas production due to permeability reduction. Consequently, well health monitoring and early prediction of Sulphur deposition are crucial for effective gas production from a sour gas reservoir. Dynamic gas material balance analysis is a useful technique in calculating gas initially in place utilizing the flowing wellhead or bottom hole pressures and rates during the well's lifetime. The approach did not apply to monitor a producing gas's health well and detect Sulphur deposition. This work aims to (i) modify dynamic gas material balance equation by adding the Sulphur deposition term, (ii) build a model to predict and validate the issue utilizing the modified equation. A unique form of the flowing material balance is developed by including Sulphur residue term. The curve fitting tool and modified flowing gas material balance are applied to predict well-expected behaviour. The variation between expected and actual performance indicates the health issue of a well. Initial, individual components of the model are tested. Then the model is validated with the known values. The workflow is applied to active gas field and correctly detected the health issue. The novel workflow can accurately predict Sulphur evidence. Besides,the workflow can notify the production engineers to take corrective measures about the subject. Keywords: Sulfur deposition, Dynamic gas material balance analysis, Workflow


Sign in / Sign up

Export Citation Format

Share Document