The Special Research on a Low Noise Amplifier

2012 ◽  
Vol 605-607 ◽  
pp. 2057-2061
Author(s):  
Xin Yin ◽  
Yi Yao ◽  
Jin Ling Jia
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Noise Figure ◽  
Design Method ◽  
Local Area ◽  
Low Noise ◽  
Low Noise Amplifier ◽  
Design System ◽  
Area Network ◽  
Noise Amplifier

This paper studies a low noise amplifier design method for 5.8G wireless local area network. Using the software of designing RF circuit ADS(Advanced Design System) and Avago Technologies’s ATF-36077,we designed a three-cascade LNA. In 5.725G~5.85GHz range, noise figure less than 0.5dB, more than 30dB gain, input and output standing wave ratio less than 1.3dB.The LNA meet the design requirements.

A Full Integrated LNA in 0.18μm SiGe BiCMOS Technology

2013 ◽  
Vol 380-384 ◽  
pp. 3287-3291
Author(s):  
Bing Liang Yu ◽  
Xiao Ning Xie ◽  
Wen Yuan Li
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Noise Figure ◽  
Impedance Matching ◽  
Local Area ◽  
Low Noise ◽  
Area Network ◽  
Bicmos Technology ◽  
Sige Bicmos ◽  
Noise Amplifier

A fully integrated low noise amplifier (LNA) for wireless local area network (WLAN) application is presents. The circuit is fabricated in 0.18μm SiGe BiCMOS technology. For the low noise figure, a feedback path is introduced into the traditional inductively degenerated common emitter cascade LNA, which decreases the inductance for input impedance matching, therefore reduces the thermal noise caused by loss resistor. Impedance matching and noise matching are achieved at the same time. Measured results show that the resonance point of the output resonance network shifts from 2.4GHz to 2.8GHz, due to the parasitic effects at the output. At the frequency of 2.8GHz, the LNA achieves 2.2dB noise figure, 19.4dB power gain. The core circuit consumes only 13mW from a 1.8V supply and occupies less than 0.5mm2.

Sign in / Sign up

Export Citation Format

Share Document