Analytical Performance of Low Noise Amplifier Using Single-Stage Configuration for ADS-B Receiver

Automatic dependent surveillance-broadcast (ADS-B) is an equipment of a radar system to reach difficult areas. For radar applications, an ADS-B requires a low noise amplifier (LNA) with high gain, stability, and a low noise figure. In this research, to produce an LNA with good performance, an LNA was designed using a BJT transistor 2SC5006 with DC bias, VCE = 3 V, and current Ic = 10 mA, also a DC supply with VCC = 12 V, to achieve a high gain with a low noise figure. The initial LNA impedance circuit was simulated using 2 elements and then converted into 3 elements to obtain parameters according to the target specification through the tuning process, impedance matching circuit was used to reduce return loss and voltage standing wave ratio (VSWR) values. The LNA sequence obtains the working frequency of 1090 MHz, return loss of -52.103 dB, a gain of 10.382, VSWR of 1.005, a noise figure of 0.552, stability factor of 0.997, and bandwidth of 83 MHz. From the simulation results, the LNA has been successfully designed according to the ADS-B receiver specifications.

A photoreceiver with an integrated X-band low-noise amplifier

The paper presents development results for a photodetector module with an integrated lownoise amplifier. The photodetector is based on a commercial indium-phosphide photodiode and a custom-designed adapter board and allows to use an optical carrier with wavelengths of 1.31 and 1.55 μm and performs optoelectronic conversion for electrical signals into 0–50 GHz range. The developed gallium arsenide low-noise amplifier is used to compensate photodiode conversion loss in the X-band frequency range. The photodetector module is intended for use as a microwave photonic link receiver, which provides a significant extension of the signal transmission range in comparison with classical types of transmission lines

A Wideband Noise and Harmonic Distortion Canceling Low-Noise Amplifier for High-Frequency Ultrasound Transducers

This paper presents a wideband low-noise amplifier (LNA) front-end with noise and distortion cancellation for high-frequency ultrasound transducers. The LNA employs a resistive shunt-feedback structure with a feedforward noise-canceling technique to accomplish both wideband impedance matching and low noise performance. A complementary CMOS topology was also developed to cancel out the second-order harmonic distortion and enhance the amplifier linearity. A high-frequency ultrasound (HFUS) and photoacoustic (PA) imaging front-end, including the proposed LNA and a variable gain amplifier (VGA), was designed and fabricated in a 180 nm CMOS process. At 80 MHz, the front-end achieves an input-referred noise density of 1.36 nV/sqrt (Hz), an input return loss (S11) of better than −16 dB, a voltage gain of 37 dB, and a total harmonic distortion (THD) of −55 dBc while dissipating a power of 37 mW, leading to a noise efficiency factor (NEF) of 2.66.

Single Event Effect Analysis of SiGe Low Noise Amplifier

This paper analyzes the single event transient (SET) response of low noise amplifier (LNA) designed using SiGe heterojunction bipolar transistors (HBT). To verify the radiation tolerance of the proposed LNA, a total of four cascode configurations were designed. Comprehensive mixed-mode simulations were performed to evaluate the SET susceptibility of considered LNA cascode configurations, and we have analyzed how the strike parameters affect their output response. In this fact the strike position, linear energy transfer (LET), and track radius, were varied, and the resulting transients were compared for the different LNA configurations. Through this study, the potential capability of the inverse mode SiGe heterojunction bipolar transistor (HBT) in LNA radiation tolerance was confirmed for various strike operating conditions. It has been demonstrated that the single event sensitivity was reduced for LNA employing inverse mode SiGe HBT for strike device. The strike influence on the different LNA configurations response depends on strike LET, where a reduced SET variation is observed for high LET.