Investigation of Initial Transient Oxidation of Fe–xCr–6at.%Al Alloys Using Synchrotron Radiation During Heating to 1000 °C in Air

The contrast in electron microscopic images of planar faults in a crystal is characterized by a phase factor , where is the reciprocal lattice vector of the operating reflection, and the lattice displacement due to the fault under consideration. Within the two-beam theory a planar fault with an integer value of is invisible, but a detectable contrast is expected when the many-beam dynamical effect is not negligibly small. A weak fringe contrast is also expected when differs slightly from an integer owing to an additional small displacement of the lattice across the fault. These faint contrasts are termed as many-beam contrasts in the former case, and as ε fringe contrasts in the latter. In the present work stacking faults in Cu-Al alloys and antiphase boundaries (APB) in CuZn, FeCo and Fe-Al alloys were observed under such conditions as mentioned above, and the results were compared with the image profiles of the faults calculated in the systematic ten-beam approximation.

Download Full-text

Microstructure of an extruded rapidly solidified Al-8Fe-2Mo alloy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100144218 ◽

1986 ◽

Vol 44 ◽

pp. 548-549

Author(s):

W. T. Donlon ◽

J. E. Allison ◽

S. Shinozaki

Keyword(s):

Electron Microscopy ◽

Automotive Industry ◽

Fuel Economy ◽

High Strength ◽

Al Alloys ◽

Light Weight ◽

Thin Sections ◽

Strength And Durability ◽

Rapidly Solidified ◽

Whitney Aircraft

Light weight materials which possess high strength and durability are being utilized by the automotive industry to increase fuel economy. Rapidly solidified (RS) Al alloys are currently being extensively studied for this purpose. In this investigation the microstructure of an extruded Al-8Fe-2Mo alloy, produced by Pratt & Whitney Aircraft, Goverment Products Div. was examined in a JE0L 2000FX AEM. Both electropolished thin sections, and extraction replicas were examined to characterize this material. The consolidation procedure for producing this material included a 9:1 extrusion at 340°C followed by a 16:1 extrusion at 400°C, utilizing RS powders which have also been characterized utilizing electron microscopy.

Download Full-text

Direct Observation of Monolayer Zones in Al-wt 4% Cu

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100178823 ◽

1990 ◽

Vol 48 (1) ◽

pp. 14-15

Author(s):

B. Jouffrey ◽

D. Dorignac ◽

A. Bourret

Keyword(s):

Solid Solution ◽

Synchrotron Radiation ◽

Direct Observation ◽

Supersaturated Solid Solution ◽

Original Model ◽

X Ray ◽

Image Position

Since the early works on GP zones and the model independently proposed by Preston and Guinier on the first steps of precipitation in supersaturated solid solution of aluminium containing a few percent of copper, many works have been performed to understand the structure of different stages in the sequence of precipitation.The scheme which is generally admitted can be drawn from a work by Phillips.In their original model Guinier and Preston analysed a GP zone as composed of a single (100) copperrich plane surrounded by aluminum atomic planes with a slightly shorter distance from the original plane than in the solid solution.From X-ray measurements it has also been shown that GP1 zones were not only copper monolayer zones. They could be up to a few atomic planes thick. Different models were proposed by Guinier, Gerold, Toman. Using synchrotron radiation, proposals have been recently made.

Download Full-text