scholarly journals Correction to: Friction and Wear Characteristics of Single Crystal Ni-Based Superalloys at Elevated Temperatures

2018 ◽  
Vol 66 (2) ◽  
Author(s):  
Pantcho Stoyanov ◽  
Lesley Dawag ◽  
Daniel G. Goberman ◽  
Dilip Shah
Keyword(s):  
Single Crystal ◽  
Friction And Wear ◽  
Elevated Temperatures ◽  
Wear Characteristics ◽  
Friction And Wear Characteristics

scholarly journals Wear and Friction Characteristics of 65Mn Steel for Spike-Tooth Harrow

Coatings ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 319
Author(s):  
Zhiguo Lu ◽  
Chuanyu Du ◽  
Qingcai Chen ◽  
Tianying Niu ◽  
Na Wang ◽  
...  
Keyword(s):  
Friction And Wear ◽  
Working Environment ◽  
Manganese Steel ◽  
Wear Loss ◽  
Variable Parameters ◽  
Wear Characteristics ◽  
Before And After ◽  
Set Up ◽  
Worn Surface ◽  
Friction And Wear Characteristics

The friction and wear characteristics of spike-tooth material (65Mn steel) of Spike-Tooth Harrow in a two-stage peanut harvester were studied in this paper. The friction and wear tests of pin and disc on 65 manganese steel were carried out on the tribometer, then the wear loss and the friction coefficient were studied. The wear loss of the pin was acquired by calculating the mass of the pin before and after the experiment using an electronic balance. According to the actual working environment of peanut spring-finger, four variable parameters are set up: load, speed, soil moisture and soil type. The friction and wear characteristics of pins were studied under different loads, speeds and different soil environments. After wearing, the worn surface of the material was observed by scanning microscope and the wear mechanism was studied. The experimental results show that the wear of the pin increases with the increase of load and decreases with the increase of rotational speed in the same rotation number. Especially in the case of the sandy soil with 20% in moisture, a maximum wear loss of the pin is achieved.

Sign in / Sign up

Export Citation Format

Share Document