Carbothermic Reduction of Amorphous Silica Refined from Diatomaceous Earth

2010 ◽  
Vol 41 (2) ◽  
pp. 350-358 ◽  
Author(s):  
Masataka Hakamada ◽  
Yasuhiro Fukunaka ◽  
Toshio Oishi ◽  
Takashi Nishiyama ◽  
Hiromu Kusuda
Proceedings ◽  
2020 ◽  
Vol 57 (1) ◽  
pp. 76
Author(s):  
Carmen Lupu ◽  
Mariana Popescu ◽  
Florin Oancea

Diatomaceous earth (kieselguhr), composed mainly of amorphous silica, SiO2xnH2O, is largely used as a feed additive [1]. [...]


Author(s):  
J. W. Mellowes ◽  
C. M. Chun ◽  
I. A. Aksay

Mullite (3Al2O32SiO2) can be fabricated by transient viscous sintering using composite particles which consist of inner cores of a-alumina and outer coatings of amorphous silica. Powder compacts prepared with these particles are sintered to almost full density at relatively low temperatures (~1300°C) and converted to dense, fine-grained mullite at higher temperatures (>1500°C) by reaction between the alumina core and the silica coating. In order to achieve complete mullitization, optimal conditions for coating alumina particles with amorphous silica must be achieved. Formation of amorphous silica can occur in solution (homogeneous nucleation) or on the surface of alumina (heterogeneous nucleation) depending on the degree of supersaturation of the solvent in which the particles are immersed. Successful coating of silica on alumina occurs when heterogeneous nucleation is promoted and homogeneous nucleation is suppressed. Therefore, one key to successful coating is an understanding of the factors such as pH and concentration that control silica nucleation in aqueous solutions. In the current work, we use TEM to determine the optimal conditions of this processing.


In many rice producing countries of the world, including in Vietnam, various research aimed at using rice husk ash (RHA) as a finely dispersed active mineral additive in cements, concrete and mortars are being conducted. The effect of the duration of the mechanoactivation of the RHA, produced under laboratory conditions in Vietnam, on its pozzolanic activity were investigated in this study. The composition of ash was investigated by laser granulometry and the values of indicators characterizing the dispersion of its particles before and after mechanical activation were established. The content of soluble amorphous silicon oxide in rice husk ash samples was determined by photocolorimetric analysis. The pizzolanic activity of the RHA, fly ash and the silica fume was also compared according to the method of absorption of the solution of the active mineral additive. It is established that the duration of the mechanical activation of rice husk ash by grinding in a vibratory mill is optimal for increasing its pozzolanic activity, since it simultaneously results in the production of the most dispersed ash particles with the highest specific surface area and maximum solubility of the amorphous silica contained in it. Longer grinding does not lead to further reduction in the size of ash particles, which can be explained by their aggregation, and also reduces the solubility of amorphous silica in an aqueous alkaline medium.


2017 ◽  
Vol 37 (04) ◽  
pp. 243-258 ◽  
Author(s):  
Charles Adarkwah ◽  
Daniel Obeng-Ofori ◽  
Vanessa Hörmann ◽  
Christian Ulrichs ◽  
Matthias Schöller

Abstract Food losses caused by insects during postharvest storage are of paramount economic importance worldwide, especially in Africa. Laboratory bioassays were conducted in stored grains to determine the toxicity of powders of Eugenia aromatica and Moringa oleifera alone or combined with enhanced diatomaceous earth (Probe-A® DE, 89.0% SiO2 and 5% silica aerogel) to adult Sitophilus granarius, Tribolium castaneum and Acanthoscelides obtectus. Adult mortality was observed up to 7 days, while progeny production was recorded at 6–10 weeks. LD50 and LT50 values for adult test insects exposed to plant powders and DE, showed that A. obtectus was the most susceptible towards the botanicals (LD50 0.179% and 0.088% wt/wt for E. aromatica and M. oleifera, respectively), followed by S. granarius. Tribolium castaneum was most tolerant (LD50 1.42% wt/wt and 1.40% wt/wt for E. aromatica and M. oleifera, respectively). The combined mixture of plant powders and DE controlled the beetles faster compared to the plant powders alone. LT50 ranged from 55.7 h to 62.5 h for T. castaneum exposed to 1.0% M. oleifera and 1.0% DE, and 0.5% E. aromatica and 1.0% DE, respectively. Botanicals caused significant reduction of F1 adults compared to the control. Combined action of botanical insecticides with DE as a grain protectant in an integrated pest management approach is discussed.


Sign in / Sign up

Export Citation Format

Share Document