Calibration of Resistance-Ratio Thermometry Bridges Using an Automated Resistance Bridge Calibrator

MAPAN ◽  
2021 ◽  
Author(s):  
Dongjin Jang ◽  
Inseok Yang
Keyword(s):  
Resistance Ratio ◽  
Resistance Bridge

Investigation of resistance-ratio bridges using the automated resistance bridge calibrator

Measurement ◽  
2009 ◽  
Vol 42 (7) ◽  
pp. 1065-1072 ◽  
Author(s):  
T. Podgornik ◽  
J. Bojkovski ◽  
V. Batagelj ◽  
J. Drnovsek
Keyword(s):  
Resistance Ratio ◽  
Resistance Bridge

Negative cross resistance of Spodoptera litura Fabricius population of tomato to newer molecule spinetoram

ENTOMON ◽  
2019 ◽  
Vol 44 (2) ◽  
pp. 127-132
Author(s):  
M. Visnupriya ◽  
N. Muthukrishnan
Keyword(s):  
Spodoptera Litura ◽  
Laboratory Strain ◽  
Field Population ◽  
Resistance Ratio ◽  
Cross Resistance ◽  
In Vivo Toxicity

Field population of Spodoptera litura from tomato ( resistant to the majority of the conventional insecticide molecules) were subjected to the in vivo toxicity of spinetoram 12 SC to assess whether cross resistance exists or not. Untreated larvae of both field and laboratory strains showed no mortality during 48 hours of feeding. After 48 hours of feeding on spinetoram 12 SC treated leaves, LC50s of field larvae were 0.28, 0.93, 3.71 and 7.11 ppm for the 2nd, 3rd, 4th and 5th instars of S. litura respectively. However, in the laboratory strain these values were 1.12, 5.86, 36.72 and 91.55 ppm for 2nd, 3rd, 4th and 5th instars of S. litura respectively. Resistance ratio was 0.25, 0.16, 0.10 and 0.08 for the 2nd instar up to the 5th instar of S. litura.

Noise properties of thin-film Ni-P resistors embedded in printed circuit boards

2013 ◽  
Vol 61 (3) ◽  
pp. 731-735
Author(s):  
A.W. Stadler ◽  
Z. Zawiślak ◽  
W. Stęplewski ◽  
A. Dziedzic
Keyword(s):  
Thin Film ◽  
Printed Circuit Boards ◽  
Circuit Boards ◽  
Noise Component ◽  
Printed Circuit ◽  
Resistance Bridge ◽  
Different Types ◽  
Signal Path ◽  
Resistance Fluctuations ◽  
Made In

Abstract. Noise studies of planar thin-film Ni-P resistors made in/on Printed Circuit Boards, both covered with two different types of cladding or uncladded have been described. The resistors have been made of the resistive-conductive-material (Ohmega-Ply©) of 100 Ώ/sq. Noise of the selected pairs of samples has been measured in the DC resistance bridge with a transformer as the first stage in a signal path. 1/f noise caused by resistance fluctuations has been found to be the main noise component. Parameters describing noise properties of the resistors have been calculated and then compared with the parameters of other previously studied thin- and thick-film resistive materials.

scholarly journals Comparison of Proportion and Resistance Ratio Methods for Drug Susceptibility Testing of Mycobacterium tuberculosis Isolated from Patients Attending National Tuberculosis Centre, Nepal

2010 ◽  
Vol 5 (1) ◽  
pp. 13-20
Author(s):  
S Acharya ◽  
P Ghimire ◽  
DK Khadka ◽  
S Nepali
Keyword(s):  
Mycobacterium Tuberculosis ◽  
Fluorescence Microscopy ◽  
Susceptibility Testing ◽  
Drug Susceptibility ◽  
Drug Susceptibility Testing ◽  
Resistance Ratio ◽  
National Tuberculosis ◽  
Smear Negative ◽  
Culture Positive ◽  
Good Agreement

Background: Tuberculosis (TB) is among the most serious infectious cause of global morbidity and mortality. Emergence of Multi-drug resistant tuberculosis (MDR-TB) is posing an increased threat to TB control programs. Drug susceptibility testing (DST) of Mycobacterium tuberculosis (M. tuberculosis) isolates is important for tackling such problems. Setting: National Tuberculosis Centre (NTC), Thimi, Bhaktapur, Nepal. Objectives: Comparative evaluation of two in vitro DST methods in determining susceptibility of M. tuberculosis isolates from patients attending NTC, to front-line anti-TB drugs: (Isoniazid-INH, Rifampicin-RFP, Streptomycin-SM, and Ethambutol-EMB). Methodology: This study was conducted from Sep 2006-Jun 2007. A total of 862 sputum samples (diagnosis or follow up cases) collected from patients (type of patients or their categories was not differentiated in this study) attending NTC bacteriology lab for sputum direct smear microscopy were analyzed using fluorescence microscopy. All smear positive samples, smear negative samples requested for culture were cultured. All culture positive samples confirmed as M. tuberculosis by biochemical tests were processed for DST by both proportion (PR) and resistance ratio (RR) methods. Results: Out of 862 sputum samples analyzed, 226 (26.2%) samples were positive for Acid Fast Bacilli (AFB) by fluorescence microscopy. Among 323 samples 226 smear positive samples and 97 smear negative samples requested for culture), 221 (68.4%) were culture positive, 92 (28.5%) were culture negative and 10 (3.1%) were contaminated. Out of 221 isolates of M. tuberculosis, 57.5% were resistant to one or more drugs by the PR method and 56.6% by the RR method. Similarly, MDR isolates were 29.9% and 29% by PR and RR methods respectively. On correlation analysis using Mc Nemar Chi-square test, no significant difference between the two tests were observed (p>0.05). The results showed high agreement between both methods and agreement rates to INH, RFP, SM and EMB were 93.2%, 93.7%, 93.2% and 94.1% respectively. Similarly, the agreement rates between both methods using kappa analysis showed kappa (k) value of 0.86, 0.85, 0.86 and 0.84 for INH, RFP, SM and EMB respectively, which is believed to be good agreement between both methods (k=0.80 to 1.00: Very good agreement). Conclusion: In conclusion, this study showed that both the Proportion and Resistance ratio methods are equally good for determining drug susceptibility of M. tuberculosis. Keywords: Mycobacterium tuberculosis; Drug Susceptibility Testing; Proportion Method; Resistance Ratio Method. DOI: 10.3126/saarctb.v5i1.3078 SAARC J. Tuber. Lung Dis. HIV/AIDS 2008 Vol.5(1) 13-20

scholarly journals Round Robin Test of Residual Resistance Ratio of Nb3Sn Composite Superconductors

2018 ◽  
Vol 28 (2) ◽  
pp. 1-5 ◽  
Author(s):  
Teruo Matsushita ◽  
Edmund S. Otabe ◽  
Dongho Kim ◽  
Taejong Hwang ◽  
Huixian Gao ◽  
...  
Keyword(s):  
Round Robin ◽  
Resistance Ratio ◽  
Residual Resistance ◽  
Round Robin Test ◽  
Composite Superconductors ◽  
Residual Resistance Ratio

scholarly journals Evaluation of a Bacteriophage-Based Assay (Phage Amplified Biologically Assay) as a Rapid Screen for Resistance to Isoniazid, Ethambutol, Streptomycin, Pyrazinamide, and Ciprofloxacin among Clinical Isolates of Mycobacterium tuberculosis

1999 ◽  
Vol 37 (11) ◽  
pp. 3528-3532 ◽  
Author(s):  
I. J. Eltringham ◽  
S. M. Wilson ◽  
F. A. Drobniewski
Keyword(s):  
Mycobacterium Tuberculosis ◽  
Rapid Determination ◽  
Low Cost ◽  
Resistance Ratio ◽  
Clinical Isolates ◽  
Rapid Screening ◽  
Ratio Method ◽  
Predictive Values ◽  
Molecular Assays ◽  
Detection Of Mutations

Rapid molecular assays for the detection of mutations associated with rifampin resistance in Mycobacterium tuberculosis are commercially available. However, they are complex and expensive and have predictive values of 90 to 95%. Molecular assays for other drugs are less predictive of resistance. Ideally, assays based on phenotypic markers should be used for susceptibility testing, but these can take weeks to complete. We previously described a rapid phenotypic assay, the phage amplified biologically (PhaB) assay, for the rapid determination of rifampin and isoniazid susceptibility in clinical isolates of M. tuberculosis. In this study, we extended the assay to the study of ethambutol, pyrazinamide, streptomycin, and ciprofloxacin. After the optimization of antibiotic concentrations and incubation conditions, the assay was applied to each drug for a total of 157 isolates. The correlations between the results of the PhaB assay and the resistance ratio method were 94% for isoniazid, 96% for streptomycin, 100% for ciprofloxacin, 88% for ethambutol, and 87% for pyrazinamide. For ciprofloxacin, ethambutol, and pyrazinamide, significantly better correlations were found when a 90% reduction in plaque count was used as the cutoff. Turnaround times for the PhaB assay were 2 to 3 days, compared with 10 days for the resistance ratio method. We believe that this low-cost assay may have widespread applicability for the rapid screening of drug resistance in M. tuberculosis isolates, especially in developing countries.

Sign in / Sign up

Export Citation Format

Share Document