Direct Liquid–Liquid Lipid Extraction Method for Biodiesel Production from Sewage and Petrochemical Industry Sludges

2018 ◽  
Vol 9 (12) ◽  
pp. 2471-2479 ◽  
Author(s):  
E. Babayigit ◽  
D. Atik Alper ◽  
A. Erdincler
2017 ◽  
Vol 71 (2) ◽  
pp. 167-174 ◽  
Author(s):  
Myung-Gyun Kim ◽  
Hyun-Wook Hwang ◽  
Antony Nzioka ◽  
Young-Ju Kim

In order to secure more effective lipid extraction method, this research investigated new lipid extraction method using laser with absorbent and sought its optimum operation control. In addition, this study compared lipid extraction efficiency and FAME conversion rate between laser extraction method at optimum condition and existing extraction method. Results from experiments for optimizing lipid extraction method using laser showed that the maximum extraction efficiency (81.8%) was attained when using laser with an output capacity of 75Wh/L. Extraction efficiency increased up to 90.8% when microwave treatment as pretreatment process was conducted. Addition of absorbents during lipid extraction process with laser showed higher extraction efficiency than laser and chemical method. It was also found that laser extraction method with absorbent had higher total fatty acid content (853.7 mg/g oil) in extracted lipid than chemical extraction method (825.4 mg/g oil). Furthermore, it had the highest FAME conversion rate (94.2%).


2020 ◽  
Vol 18 (1) ◽  
pp. 874-881
Author(s):  
Laras Prasakti ◽  
Sangga Hadi Pratama ◽  
Ardian Fauzi ◽  
Yano Surya Pradana ◽  
Arief Budiman ◽  
...  

AbstractAs fossil fuels were depleting at an alarming rate, the development of renewable energy has become necessary. One of the promising renewable energy to be used is biodiesel. The interest in using third-generation feedstock, which is microalgae, is rapidly growing. The use of third-generation biodiesel feedstock will be more beneficial as it does not compete with food crop use and land utilization. The advantageous characteristic which sets microalgae apart from other biomass sources is that microalgae have high biomass yield. Conventionally, microalgae biodiesel is produced by lipid extraction followed by transesterification. In this study, combination process between hydrothermal liquefaction (HTL) and esterification is explored. The HTL process is one of the biomass thermochemical conversion methods to produce liquid fuel. In this study, the HTL process will be coupled with esterification, which takes fatty acid from HTL as raw material for producing biodiesel. Both the processes will be studied by simulating with Aspen Plus and thermodynamic analysis in terms of energy and exergy. Based on the simulation process, it was reported that both processes demand similar energy consumption. However, exergy analysis shows that total exergy loss of conventional exergy loss is greater than the HTL-esterification process.


2021 ◽  
pp. 100696
Author(s):  
Prakash Bhuyar ◽  
Sathyavathi Sundararaju ◽  
Mohd Hasbi Ab. Rahim ◽  
Gaanty Pragas Maniam ◽  
Natanamurugaraj Govindan

2014 ◽  
Vol 28 (3) ◽  
pp. 341-348 ◽  
Author(s):  
Agata Piasecka ◽  
Izabela Krzemińska ◽  
Jerzy Tys

Abstract The prospect of depletion of natural energy resources on the Earth forces researchers to seek and explore new and alternative energy sources. Biomass is a composite resource that can be used in many ways leading to diversity of products. Therefore, microalgal biomass offers great potential. The main aim of this study is to find the best physical method of microalgal biomass pretreatment that guarantees efficient lipid extraction. These studies identifies biochemical composition of microalgal biomass as source for biodisel production. The influence of drying at different temperatures and lyophilization was investigated. In addition, wet and untreated biomass was examined. Cell disruption (sonication and microwave) techniques were used to improve lipid extraction from wet biomass. Additionally, two different extraction methods were carried out to select the best method of crude oil extraction. The results of this study show that wet biomass after sonication is the most suitable for extraction. The fatty acid composition of microalgal biomass includes linoleic acid (C18:2), palmitic acid (C16:0), oleic acid (C18:1), linolenic acid (C18:3), and stearic acid (C18:0), which play a key role in biodiesel production.


2003 ◽  
Vol 51 (19) ◽  
pp. 5607-5611 ◽  
Author(s):  
Sören Jensen ◽  
Lisbeth Häggberg ◽  
Hrönn Jörundsdóttir ◽  
Göran Odham

2012 ◽  
Vol 53 (8) ◽  
pp. 1690-1700 ◽  
Author(s):  
Lars Löfgren ◽  
Marcus Ståhlman ◽  
Gun-Britt Forsberg ◽  
Sinikka Saarinen ◽  
Ralf Nilsson ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document