Resin-bonded fixed partial denture technique: Results of a medium-term clinical follow-up investigation

1993 ◽  
Vol 69 (2) ◽  
pp. 144-148 ◽  
Author(s):  
Christian Besimo
2014 ◽  
Vol 40 (S1) ◽  
pp. 371-374
Author(s):  
Yoshiyuki Hagiwara ◽  
Tatsuya Narita ◽  
Masao Araki ◽  
Kunihiko Sawada ◽  
Kiyoshi Nakajima

Even in the case of implant loss, replacement of the implant and refabrication of the superstructure are often sufficient, as long as the bone and soft tissue are in good condition. However, if implant loss accompanied by serious bone resorption occurs with a fixed implant superstructure supported by multiple implants, it is very difficult to treat. This clinical report describes the process by which multiple implant-supported fixed metal ceramic restorations were repaired with a metal ceramic resin-bonded fixed partial denture without complete refabrication after removal of one of the implants due to severe bone resorption. The 3-year follow-up indicated excellent serviceability and a well-satisfied patient.


2018 ◽  
Vol 9 (3) ◽  
pp. 137
Author(s):  
JBrintha Jei ◽  
TAnjan Kumar ◽  
NGopi Chander

2013 ◽  
Vol 07 (03) ◽  
pp. 363-367 ◽  
Author(s):  
Ulkem Aydin ◽  
Derya Yildirim ◽  
Esin Bozdemir

ABSTRACTSubpontic osseous hyperplasia (SOH) is an ectopic growth of bone occurring on the edentulous ridge beneath a fixed partial denture. The aim of this article is to present three patients with SOH with long-term follow-up and to make a current overview of the literature. Presented maxillary SOH is the second case in the dental literature. Intraorally the lesions were bone-hard and painless swellings in the subpontic space. Radiographically, the maxillary case was a nodular bone growth having similar radiodensity and trabeculation to the adjacent bone with a thin radiopaque border. Mandibular cases were bony growths, which were more radiopaque than the adjacent alveolar ridge. Follow-up radiographs revealed regression in two of the cases. Clinicians should take care not to cause the possible etiologies of SOH such as functional stresses and chronic irritation by the prosthetic treatments and be aware of SOH does not usually require treatment or a biopsy.


2018 ◽  
Vol 32 (3) ◽  
pp. 146
Author(s):  
Amanda Mahammad Mushashe ◽  
Leonardo Fernandes Da Cunha ◽  
Carlos Eduardo Edwards Rezende ◽  
Carla Castiglia Gonzaga ◽  
Gisele Maria Correr

OBJECTIVE: This report aimed to present a case of functional and aesthetic rehabilitation of anterior maxillary region through dentogingival prosthesis in a patient with high smile line.CASE DESCRIPTION: Patient female, 65 years old, had aesthetic complaints related to fixed partial denture from upper left canine to upper right lateral incisor. The patient reported loss of upper central incisors due to periodontal disease progression. Clinical and radiographic examination showed marginal leakage, discrepancy in teeth proportion, dental inclination and alignment, and excessive prolongation of the cervical-incisal direction, plus a resorbed alveolar ridge, in both volume and height, in the described area. Faced with these conditions, it was decided to perform a fixed partial dentogingival denture, restoring harmony and smile functionality.CONCLUSION: After a 1-year follow up, maintenance of functional and aesthetic aspects of the prosthesis was observed.


2003 ◽  
Vol 30 (10) ◽  
pp. 971-977 ◽  
Author(s):  
M. Zalkind ◽  
P. Ever-Hadani ◽  
N. Hochman

Author(s):  
Tugce Merve Ordueri ◽  
Asena Kaptanogl ◽  
Mehmet Muzaffer Ates

Chipping is the most common complication in zirconia-supported porcelain prosthesis. If the prosthesis has ideal adaptation and there is no problem other than chipping, intraoral repair is the most practical solution for such failures. Composite resins are often preferred for intraoral porcelain repair. However, the wear and unstable colour of composite resins negatively affect aesthetics. This complication could be restored intraorally and aesthetically with ceramic veneer. This case report presents the intraoral repair of a zirconia supported Fixed Partial Denture (FPD) consisting of four units. The cohesive fracture of the ceramic material in the incisal part of maxillary right central incisor was restored with ceramic veneers. Preparation was done with a tapered, rounded end diamond bur under water-cooling. The impression was taken with elastomeric impression material. Ceramic veneer was manufactured with a leucite-reinforced glass-ceramic and cemented with light cure resin cement. Based on the three-year follow up of the performed intraoral repair, ceramic veneers have shown to be an alternative treatment for fractured FPD.


1987 ◽  
Vol 58 (5) ◽  
pp. 542-545 ◽  
Author(s):  
N. Hochman ◽  
I. Ginio ◽  
J Ehrlich

Sign in / Sign up

Export Citation Format

Share Document