Characterization of soluble microbial products from anaerobic treatment by molecular weight distribution and nickel-chelating properties

1996 ◽  
Vol 30 (4) ◽  
pp. 915-922 ◽  
Author(s):  
Wen-Chien Kuo ◽  
Gene F. Parkin
2002 ◽  
Vol 45 (10) ◽  
pp. 127-132 ◽  
Author(s):  
S.F. Aquino ◽  
D.C. Stuckey

The residual COD from anaerobic treatment processes is usually too high to comply with legislative discharge levels. It has been shown that in well operated systems the majority of the effluent COD originates from soluble microbial products (SMP) produced by the system itself, hence the characteristics of these compounds become important when assessing post-treatment systems to remove the residual COD. The molecular weight (MW) distribution and the identification of SMP in the effluents from three different anaerobic reactors will be presented. It has been found that the bulk of SMP lies in the low MW range, though compounds with MW as high as 300 kDa were also present in all anaerobic effluents. Preliminary results on the identification of such compounds using GC/MS surprisingly revealed the presence of long chain alkenes (C12–C24) and alkanes (C12–C16), as well as some aromatic compounds. These compounds that likely come from cell lysis and endogenous decay may not be easily biodegradable, hence their presence in the effluent is likely to cause the residual COD.


2014 ◽  
Vol 936 ◽  
pp. 1597-1602
Author(s):  
Xue Yang ◽  
Ze Quan Liu ◽  
Qiang Zhang

This paper reveals the development and significance of size exclusion chromatograph/multi-angle laser light scattering(SEC-MALLS) for determination of the molecular weight and characterization of the molecular weight distribution. This technque has been applied in many aspects, such as biology, polymer and carboxylate surfactant. It has made a big contribution to study the property of macromolecular substances.


2012 ◽  
Vol 518-523 ◽  
pp. 1808-1812
Author(s):  
Lei Zhang ◽  
Wei Guang Li ◽  
Duo Ying Zhang ◽  
Ke Wang ◽  
Guang Zhi Wang

A large amount of soluble chemical oxygen demand (COD) exists in the effluent from anaerobic treatment of wastewater at methophilic temperature, which consists of considerable portion of soluble microbial products (SMP). As the anaerobic treatment of wastewater was significantly influenced by temperature, it is great of importance to investigate the SMP from anaerobic reactors operated at low temperature in order to improve the performance. In this study, two lab-scale UASB reactors were performed to treat synthetic glucose and acetate wastewater respectively at an initial concentration of 1000 mg-COD/L at 15 °C. The SMP was found in the effluent from the glucose-fed UASB, and it was 6% of the influent COD concentration. The SMP did not accumulate in the acetate-fed UASB. The average aerobic biodegradability of the SMP was 90% and it was further enhanced by membrane separation of X100 (membrane with 100 k da molecular weight cut-offs). The anaerobic biodegradability of the SMP was 60%, and it was 100% for the fraction in which the molecular weight (MW) was lower than 10 k da. The fraction of low MW (lower than 10 k da) mainly consisted of 31.7% long chain alkanes and 13.6% esters. The aerobic polishing step is an available polishing step for the anaerobic treatment of wastewater at low temperature.


Sign in / Sign up

Export Citation Format

Share Document