Renewable diesel via hydrothermal liquefaction of oleaginous yeast and residual lignin from bioconversion of corn stover

2019 ◽  
Vol 233-234 ◽  
pp. 840-853 ◽  
Author(s):  
James R. Collett ◽  
Justin M. Billing ◽  
Pimphan A. Meyer ◽  
Andrew J. Schmidt ◽  
A. Brook Remington ◽  
...  
2019 ◽  
Author(s):  
Wan-Ting (Grace) Chen ◽  
Zhenwei Wu ◽  
Buchun Si ◽  
Yuanhui Zhang

This study aims to produce renewable diesel and biopriviliged chemicals from microalgae that can thrive in wastewater environment. <i>Spirulina</i> (SP) was converted into biocrude oil at 300ºC for a 30-minute reaction time via hydrothermal liquefaction (HTL). Next, fractional distillation was used to separate SP-derived biocrude oil into different distillates. It was found that 62% of the viscous SP-derived biocrude oil can be separated into liquids at about 270ºC (steam temperature of the distillation). Physicochemical characterizations, including density, viscosity, acidity, elemental compositions, higher heating values and chemical compositions, were carried out with the distillates separated from SP-derived biocrude oil. These analyses showed that 15% distillates could be used as renewable diesel because they have similar heating values (43-46 MJ/kg) and carbon numbers (ranging from C8 to C18) to petroleum diesel. The Van Krevelan diagram of the distillates suggests that deoxygenation was effectively achieved by fractional distillation. In addition, GC-MS analysis indicates that some distillates contain biopriviliged chemicals like aromatics, phenols and fatty nitriles that can be used as commodity chemicals. An algal biorefinery roadmap was proposed based on the analyses of different distillates from the SP-derived biocrude oil. Finally, the fuel specification analysis was conducted with the drop-in renewable diesel, which was prepared with 10 vol.% (HTL10) distillates and 90 vol.% petroleum diesel. According to the fuel specification analysis, HTL10 exhibited a qualified lubricity (<520 µm), acidity (<0.3 mg KOH/g) and oxidation stability (>6 hr), as well as a comparable net heat of combustion (1% lower), ash content (29% lower) and viscosity (17% lower) to those of petroleum diesel. Ultimately, it is expected that this study can provide insights for potential application of algal biocrude oil converted via HTL.


2020 ◽  
Vol 313 ◽  
pp. 123639 ◽  
Author(s):  
Lauren T. Cordova ◽  
Beena C. Lad ◽  
Sabah A. Ali ◽  
Andrew J. Schmidt ◽  
Justin M. Billing ◽  
...  

BioResources ◽  
2020 ◽  
Vol 15 (3) ◽  
pp. 4898-4911

Lignin has been shown to be a recalcitrance factor in many biomass conversion studies. To better understand the effects of lignin on cellulose conversion, different lignin fractions were extracted from the same dilute acid pretreated corn stover by three sequential isolation methods, namely ethanol extraction, dioxane extraction, and enzyme purification. The physicochemical properties of each lignin fraction including molecular weight distribution, surface area, surface charge, and other structural features varied, depending on the isolation methods. All three lignin fractions had negative surface charges, and ethanol-extracted lignin carried the highest surface charges, followed by dioxane-extracted lignin and cellulase-purified residual lignin. These physicochemical properties of lignin fractions also resulted in different extent of inhibitory effects on enzymatic hydrolysis of microcrystalline cellulose (MCC). Dioxane-extracted lignin exhibited the highest inhibitory effect on glucose release from MCC, followed by the cellulase-purified residual lignin fraction and ethanol-extracted lignin. Furthermore, lignin fractions with higher contents of syringyl (S) substructure and β-O-4 aryl ether interunit linkages showed a stronger negative effect on cellulase hydrolysis of MCC.


2015 ◽  
Vol 8 (1) ◽  
Author(s):  
Umakanta Jena ◽  
Alex T. McCurdy ◽  
Andrew Warren ◽  
Hailey Summers ◽  
Rhesa N. Ledbetter ◽  
...  

2018 ◽  
Vol 1 (11) ◽  
pp. 702-710 ◽  
Author(s):  
Wan-Ting Chen ◽  
Yuanhui Zhang ◽  
Timothy H. Lee ◽  
Zhenwei Wu ◽  
Buchun Si ◽  
...  

2021 ◽  
Vol 14 (1) ◽  
Author(s):  
Markus Alahuhta ◽  
Qi Xu ◽  
Eric P. Knoshaug ◽  
Wei Wang ◽  
Hui Wei ◽  
...  

AbstractConsolidated bioprocessing using oleaginous yeast is a promising modality for the economic conversion of plant biomass to fuels and chemicals. However, yeast are not known to produce effective biomass degrading enzymes naturally and this trait is essential for efficient consolidated bioprocessing. We expressed a chimeric cellobiohydrolase I gene in three different oleaginous, industrially relevant yeast: Yarrowia lipolytica, Lipomyces starkeyi, and Saccharomyces cerevisiae to study the biochemical and catalytic properties and biomass deconstruction potential of these recombinant enzymes. Our results showed differences in glycosylation, surface charge, thermal and proteolytic stability, and efficacy of biomass digestion. L. starkeyi was shown to be an inferior active cellulase producer compared to both the Y. lipolytica and S. cerevisiae enzymes, whereas the cellulase expressed in S. cerevisiae displayed the lowest activity against dilute-acid-pretreated corn stover. Comparatively, the chimeric cellobiohydrolase I enzyme expressed in Y. lipolytica was found to have a lower extent of glycosylation, better protease stability, and higher activity against dilute-acid-pretreated corn stover.


2021 ◽  
pp. 100625
Author(s):  
Katelyn M. Shell ◽  
Dylan D. Rodene ◽  
Vinod Amar ◽  
Anuj Thakkar ◽  
Bharathkiran Maddipudi ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document