Expansion characteristics of multiple wall jets in cylindrical observation chamber

2017 ◽  
Vol 113 ◽  
pp. 1396-1409 ◽  
Author(s):  
Zhitao Hu ◽  
Yonggang Yu
1998 ◽  
Vol 29 (4-5) ◽  
pp. 218-224
Author(s):  
A. A. Khalatov ◽  
T. A. Zheleznaya ◽  
I. A. Izgoreva

2016 ◽  
Vol 47 (2) ◽  
pp. 159-183 ◽  
Author(s):  
Leonid Aleksandrovich Bendersky ◽  
Dmitriy Aleksandrovich Lyubimov ◽  
Irina Vasilevna Potekhina ◽  
Alena Eduardovna Fedorenko

Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1005
Author(s):  
Viktor I. Terekhov

The study of flows with a high degree of turbulence in boundary layers, near-wall jets, gas curtains, separated flows behind various obstacles, as well as during combustion is of great importance for increasing energy efficiency of the flow around various elements in the ducts of gas-dynamic installations. This paper gives some general characteristics of experimental work on the study of friction and heat transfer on a smooth surface, in near-wall jets, and gas curtains under conditions of increased free-stream turbulence. Taking into account the significant effect of high external turbulence on dynamics and heat transfer of separated flows, a similar effect on the flow behind various obstacles is analyzed. First of all, the classical cases of flow separation behind a single backward-facing step and a rib are considered. Then, more complex cases of the flow around a rib oriented at different angles to the flow are analyzed, as well as a system of ribs and a transverse trench with straight and inclined walls in a turbulent flow around them. The features of separated flow in a turbulized stream around a cylinder, leading to an increase in the width of the vortex wake, frequency of vortex separation, and increase in the average heat transfer coefficient are analyzed. The experimental results of the author are compared with data of other researchers. The structure of separated flow at high turbulence—characteristic dimensions of the separation region, parameters of the mixing layer, and pressure distribution—are compared with the conditions of low-turbulent flow. Much attention is paid to thermal characteristics: temperature profiles across the shear layer, temperature distributions over the surface, and local and average heat transfer coefficients. It is shown that external turbulence has a much stronger effect on the separated flow than on the boundary layer on a flat surface. For separated flows, its intensifying effect on heat transfer is more pronounced behind a rib than behind a step. The factor of heat transfer intensification by external turbulence is most pronounced in the transverse cavity and in the system of ribs.


1983 ◽  
Vol 26 (222) ◽  
pp. 2074-2080 ◽  
Author(s):  
Ryoji KOBAYASHI ◽  
Nobuyuki FUJISAWA

2002 ◽  
Vol 33 (2) ◽  
pp. 351-354 ◽  
Author(s):  
M. Tachie ◽  
R. Balachandar ◽  
D. Bergstrom

1976 ◽  
Vol 98 (3) ◽  
pp. 447-452
Author(s):  
P. North

The performance of many fluid flow devices is limited by the separation of the turbulent boundary layer. This separation may be suppressed or delayed by use of wall jets, raising questions of jet location and strength. A numerical analysis of a single wall jet gave results in close agreement with experiment. The same analysis of a single wall jet gave results in close agreement with experiment. The same calculation procedure indicated that two sequential wall jets, with the same total kinetic energy flux as the single jet, would suppress separation under conditions where the single jet would not. The best two-jet arrangement would be achieved with 63 percent of the total kinetic energy flux in the first jet. It is possible that three-jet arrangements could provide some further improvement.


2021 ◽  
pp. 108174
Author(s):  
J.-H. Thysen ◽  
T. van Hooff ◽  
B. Blocken ◽  
G.J.F. van Heijst
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document