Electrical Resistivity and Induced Polarization signatures to delineate the near-surface aquifers contaminated with seawater invasion in Digha, West-Bengal, India

CATENA ◽  
2021 ◽  
Vol 207 ◽  
pp. 105596
Author(s):  
Prashant Kumar ◽  
Prarabdh Tiwari ◽  
Anand Singh ◽  
Arkoprovo Biswas ◽  
Tapas Acharya
2021 ◽  
Author(s):  
Okechukwu Donald Nnebedum ◽  
Ogbonnaya Igwe ◽  
Stanley Ikenna Ifediegwu

Abstract Inhomogeneity caused by fractures can constitute real problems in foundation soils which consequently can lead to structural failure. 2D Electrical Resistivity Tomography (ERT) has been exceedingly popular in mapping near surface discontinuities that can possibly affect engineering structures. The effectiveness of using Induced Polarisation Tomography (IPT) in mapping subsurface fractures was explored. Using the same field way out for both ERT and IPT, investigations were carried out at a failed structure with foundational inhomogeneity in the Nsukka area, Southeastern Nigeria. Four Electrical Resistivity Tomography (ERT) and four Induced Polarisation Tomography (IPT) were carried out. Electrical Resistivity Tomography for profile line one (ERT1) and that of the opposite section, ERT3, revealed a fault trending NNW- SSE. This anomaly was also observed on the Induced Polarization Tomography for profile line one (IPT1) as well as that of profile line three (IPT3) at the same offset distances, delineating the same fracture zone. A second fault trending in NE-SW was mapped by the Electrical Resistivity Tomography for profile line two (ERT2) and Electrical Resistivity Tomography for profile line four (ERT4). The fault was also visible in the Induced Polarization counterparts, IPT2 and IPT4. Field validation along mapped trends recorded subtle cracks on the foundation along the same trend detected by the IPT as well as the ERT.


Water ◽  
2020 ◽  
Vol 12 (5) ◽  
pp. 1394
Author(s):  
Agathe Defourny ◽  
Frédéric Nguyen ◽  
Arnaud Collignon ◽  
Patrick Jobé ◽  
Alain Dassargues ◽  
...  

CO 2 -rich mineral groundwaters are of great economic and touristic interest but their origin and circulation paths in the underground are often poorly understood. A deeper understanding of the system plumbery and the development of non—to minimally—invasive near-surface geophysical methods for the prospection of potential productive areas is therefore of great interest to manage future supply. The objective of this contribution is to assess the ability of the time-domain induced polarization (TDIP) method, combined with the electrical resistivity tomography (ERT) method, to make the distinction between CO 2 -rich groundwater from non-gaseous groundwater. Three combined ERT/TDIP tomographies were performed above known uplift zones in the south-east of Belgium where thousands of CO 2 -rich groundwater springs exist. On all profiles, important contrasts in both electrical resistivity and chargeability distributions were observed in the vicinity of the upflow zone, also reflected in the normalized chargeability sections computed from the measured data. Low resistivity vertical anomalies extending in depth were interpreted as a saturated fracture network enabling the upflow of deep groundwater to the surface. High chargeability anomalies appearing directly close to the CO 2 -rich groundwater springs were inferred to metallic oxides and hydroxides precipitation in the upper part of the aquifer, linked to pressure decrease and changing redox conditions in the up-flowing groundwater approaching the land surface. The combined interpretation of electrical resistivity and induced polarization datasets provides a very promising method for a robust prospection of CO 2 -rich groundwater.


2020 ◽  
Author(s):  
Agathe Defourny ◽  
Thomas Kremer ◽  
Arnaud Collignon ◽  
Patrick Jobé ◽  
Alain Dassargues ◽  
...  

<p>CO<sub>2</sub>-rich mineral groundwaters have been exploited for centuries for both bottling and thermal activities. The detection and understanding of productive areas is therefore of great interest to manage future supply in a sustainable way. CO<sub>2</sub>-rich mineral water systems are complex since they usually involve an intricated network of water bearing fractures enabling the uplift of CO<sub>2</sub>-rich groundwater to the surface, a process that is still poorly understood. Geophysical prospection is crucial to detect potential uplift zones and to address corresponding uncertainties before drilling operations.</p><p>In this context, non - to minimally - invasive near-surface geophysical methods can prove to be efficient. The objective of this contribution is to assess the ability of the induced polarization method, combined with the electrical resistivity technique, to make the distinction between CO<sub>2</sub>-rich groundwater from non-gaseous groundwater.</p><p>Several combined electrical resistivity and induced polarization tomography profiles were performed in the Ardennes (Belgium) where thousands of CO<sub>2</sub>-rich groundwater springs are observed. The profiles were all set immediately above known uplift zones. Inversion results were consistent between all profiles and important contrasts in both electrical resistivity and chargeability distributions in the vicinity of the uplift zone were observed, which were also reflected in the normalized chargeability sections computed on the basis of the measured data.</p><p>Low resistivity vertical contrasts extending in depth were observed and interpreted as saturated fractures enabling the uplift of deep groundwater to the surface. In addition, high chargeability anomalies appeared directly close to the CO<sub>2</sub>-rich groundwater resurgence. Those anomalies are thought to be associated to the presence of metallic oxides and hydroxides, as a result of dissolved metallic species precipitation in the upper part of the fractured aquifer due to the pressure decrease and change in redox conditions in up-flowing groundwater towards the land surface.</p><p>We conclude that the combined interpretation of electrical resistivity and induced polarization datasets is a very promising method for a more robust prospection of naturally sparkling groundwater.</p>


2021 ◽  
Author(s):  
Riccardo Scandroglio ◽  
Till Rehm ◽  
Jonas K. Limbrock ◽  
Andreas Kemna ◽  
Markus Heinze ◽  
...  

<p>The warming of alpine bedrock permafrost in the last three decades and consequent reduction of frozen areas has been well documented. Its consequences like slope stability reduction put humans and infrastructures at high risk. 2020 in particular was the warmest year on record at 3000m a.s.l. embedded in the warmest decade.</p><p>Recently, the development of electrical resistivity tomography (ERT) as standard technique for quantitative permafrost investigation allows extended monitoring of this hazard even allowing including quantitative 4D monitoring strategies (Scandroglio et al., in review). Nevertheless thermo-hydro-mechanical dynamics of steep bedrock slopes cannot be totally explained by a single measurement technique and therefore multi-approach setups are necessary in the field to record external forcing and improve the deciphering of internal responses.</p><p>The Zugspitze Kammstollen is a 850m long tunnel located between 2660 and 2780m a.s.l., a few decameters under the mountain ridge. First ERT monitoring was conducted in 2007 (Krautblatter et al., 2010) and has been followed by more than one decade of intensive field work. This has led to the collection of a unique multi-approach data set of still unpublished data. Continuous logging of environmental parameters such as rock/air temperatures and water infiltration through joints as well as a dedicated thermal model (Schröder and Krautblatter, in review) provide important additional knowledge on bedrock internal dynamics. Summer ERT and seismic refraction tomography surveys with manual and automated joints’ displacement measurements on the ridge offer information on external controls, complemented by three weather stations and a 44m long borehole within 1km from the tunnel.</p><p>Year-round access to the area enables uninterrupted monitoring and maintenance of instruments for reliable data collection. “Precisely controlled natural conditions”, restricted access for researchers only and logistical support by Environmental Research Station Schneefernerhaus, make this tunnel particularly attractive for developing benchmark experiments. Some examples are the design of induced polarization monitoring, the analysis of tunnel spring water for isotopes investigation, and the multi-annual mass monitoring by means of relative gravimetry.</p><p>Here, we present the recently modernized layout of the outdoor laboratory with the latest monitoring results, opening a discussion on further possible approaches of this extensive multi-approach data set, aiming at understanding not only permafrost thermal evolution but also the connected thermo-hydro-mechanical processes.</p><p> </p><p> </p><p>Krautblatter, M. et al. (2010) ‘Temperature-calibrated imaging of seasonal changes in permafrost rock walls by quantitative electrical resistivity tomography (Zugspitze, German/Austrian Alps)’, Journal of Geophysical Research: Earth Surface, 115(2), pp. 1–15. doi: 10.1029/2008JF001209.</p><p>Scandroglio, R. et al. (in review) ‘4D-Quantification of alpine permafrost degradation in steep rock walls using a laboratory-calibrated ERT approach (in review)’, Near Surface Geophysics.</p><p>Schröder, T. and Krautblatter, M. (in review) ‘A high-resolution multi-phase thermo-geophysical model to verify long-term electrical resistivity tomography monitoring in alpine permafrost rock walls (Zugspitze, German/Austrian Alps) (submitted)’, Earth Surface Processes and Landforms.</p>


2012 ◽  
Vol 10 (6) ◽  
pp. 453-468 ◽  
Author(s):  
Andreas Kemna ◽  
Andrew Binley ◽  
Giorgio Cassiani ◽  
Ernst Niederleithinger ◽  
André Revil ◽  
...  

2017 ◽  
Vol 43 (4) ◽  
pp. 1962
Author(s):  
G. Vargemezis ◽  
P. Tsourlos ◽  
I. Mertzanides

The most common geophysical method widely used in hydrogeological surveys concerning deep investigations (150-300m of depth) is the resistivity method and particularly the Vertical Electric Sounding (VES) using the Schlumberger array. VES interpretations assume 1D geoelectrical structure yet it is obvious that such an interpretation assumption is not valid in many cases where 2D and 3D geological features exist. In such cases the application of geoelectrical techniques which can provide both vertical and lateral information concerning the resistivity variations is required. Techniques such as the electrical resistivity tomography, mostly used for the 2D and 3D geoelectrical mapping of near surface applications can be adapted to be used for larger investigation depths provided that modified equipment (viz. cables) is used. In the present paper, the application of deep electrical resistivity tomography (ERT) techniques is applied. ERT array of 21 electrodes, at a distance of 50 meters between them (total length 1000 meters) has been used in several studied areas located in the prefecture of Kavala (North Greece). In several cases near surface structure has been compared with VLF data. The aim of the survey was to study in detail the geological-hydrogeological structure the area of interest in order to suggest the best location for the construction of hydrowells with the most promising results. The 2D images of the geological structure down to the depth of at least 200 meters allowed the better understanding of the behaviour of layered geological formations, since in several cases resistivity values have been calibrated with data from pre-existing boreholes.


2004 ◽  
Vol 3 (4) ◽  
pp. 1215-1229 ◽  
Author(s):  
D. Cornacchiulo ◽  
A. C. Bagtzoglou

Sign in / Sign up

Export Citation Format

Share Document