Lab experiments on hybridization of managed aquifer recharge with river water via sand column, pre-oxidation, and nanofiltration

The use of stormwater for managed aquifer recharge (MAR) has become one of the most important ways to deal with water shortages and the corresponding environmental geological problems, especially in the north of China. The Fe (III) clogging of porous media is a common and significant problem that influences the effect of the infiltration rate. This paper focuses on the migration characteristics and clogging mechanisms of iron hydroxides in sand columns. The results indicate that the permeability of porous media significantly decreased at the inlet of the fine sand column and inside the coarse sand column. We demonstrated that, when the Fe (III) concentration was higher, a smaller infiltration medium size was produced more rapidly, and there was more significant clogging. More than 80% of the injected Fe (III) remained in the sand column, and more than 50% was retained within 1 cm of the column inlet. The mass retention increased with the decrease in the size of the infiltration medium particles and with the increase in the injected Fe (III) concentration. The main material that caused Fe (III) clogging was iron hydroxide colloids, which were in the form of a granular or flocculent membrane coating the quartz sand. The mechanisms of clogging and retention were blocking filtration and deep bed filtration, adsorption, and deposition, which were strongly affected by the coagulation of Fe (III) colloidal particles.

Download Full-text

Analysis of Potential Risks Associated with Urban Stormwater Quality for Managed Aquifer Recharge

International Journal of Environmental Research and Public Health ◽

10.3390/ijerph16173121 ◽

2019 ◽

Vol 16 (17) ◽

pp. 3121 ◽

Cited By ~ 1

Author(s):

Song ◽

Du ◽

Ye

Keyword(s):

Groundwater Resources ◽

Oxygen Demand ◽

Water Shortage ◽

Managed Aquifer Recharge ◽

Aquifer Recharge ◽

High Concentration ◽

Sand Column ◽

Sustainable Resources ◽

Contamination Risk ◽

Urban Stormwater Quality

Managed aquifer recharge (MAR) can be used to increase storage and availability of groundwater resources, but water resources available for recharge are constrained due to a surface water shortage. Alternative resources, like stormwater, are receiving increasing attention as sustainable resources for reuse in MAR. However, pollutants in stormwater can impact groundwater quality, and cause clogging of the infiltration system. Based on the stormwater data in the literature, the physicochemical stormwater properties of data were analyzed. The results showed that concentrations of pollutants from different underlying surfaces varied widely. The main pollutants of stormwater were as follows: Total suspended particles (TSSs), organic matter represented by the chemical oxygen demand (COD), nutrients (total nitrogen, TN; total phosphorus, TP; and NH3–N), and metals (Zn, Pb, Cu, Cd, Fe, and Mn). Based on the simulation of TOUGHREACT, the contamination risk of pollutants for each type of stormwater was assessed. The risk of contamination was divided into four categories due to the different migration times of ions through the sand column. The iron ion has the highest risk of contamination, followed by Zn and Mn, and the contamination risk of nutrients and other metals (Pb, Cu, and Cd) are relatively low. Besides, the physical, biological, and chemical clogging risk were evaluated. The physical clogging potential of all types of stormwater is very high because of the high concentration of TSS. According to the concentration of TN that can spur the growth of bacteria and algae, the relative risk of biological clogging for stormwater is greenbelt stormwater < road stormwater < roof stormwater. However, only road stormwater has high chemical clogging due to the existence of iron, which can generate precipitation that blocks the pore volume.

Download Full-text