Development of finite element based model for performance evaluation of nano cutting fluids in minimum quantity lubrication

2018 ◽  
Vol 21 ◽  
pp. 75-85 ◽  
Author(s):  
Rukmini Srikant Revuru ◽  
Vamsi Krishna Pasam ◽  
Ismail Syed ◽  
Uday Kumar Paliwal
Keyword(s):  
Finite Element ◽  
Performance Evaluation ◽  
Minimum Quantity Lubrication ◽  
Cutting Fluids ◽  
Minimum Quantity

Workpiece Thermal Distortion in Minimum Quantity Lubrication Deep Hole Drilling—Finite Element Modeling and Experimental Validation

2012 ◽  
Vol 134 (1) ◽  
Author(s):  
Bruce L. Tai ◽  
Andrew J. Jessop ◽  
David A. Stephenson ◽  
Albert J. Shih
Keyword(s):  
Heat Flux ◽  
Finite Element ◽  
Heat Carrier ◽  
Three Dimensional ◽  
Minimum Quantity Lubrication ◽  
Hole Drilling ◽  
Bottom Surface ◽  
Thermal Distortion ◽  
Element Analysis ◽  
Minimum Quantity

This paper presents the three dimensional (3-D) finite element analysis (FEA) to predict the workpiece thermal distortion in drilling multiple deep-holes under minimum quantity lubrication (MQL) condition. Heat sources on the drilling hole bottom surface (HBS) and hole wall surface (HWS) are first determined by the inverse heat transfer method. A 3-D heat carrier consisting of shell elements to carry the HWS heat flux and solid elements to carry the HBS heat flux has been developed to conduct the heat to the workpiece during the drilling simulation. A thermal–elastic coupled FEA was applied to calculate the workpiece thermal distortion based on the temperature distribution. The concept of the heat carrier was validated by comparing the temperature calculation with an existing 2-D advection model. The 3-D thermal distortion was validated experimentally on an aluminum workpiece with four deep-holes drilled sequentially. The measured distortion on the reference point was 61 μm, which matches within uncertainty the FEA predicted distortion of 51 μm.

Sign in / Sign up

Export Citation Format

Share Document