Development of locally homogeneous finite element model for simulating the mesoscale structure of asphalt mixture

2021 ◽  
Vol 248 ◽  
pp. 106517
Author(s):  
Cong Du ◽  
Pengfei Liu ◽  
Quan Liu ◽  
Sabine Leischner ◽  
Yiren Sun ◽  
...  
2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Fengjun Zhao ◽  
Yuhang Tang ◽  
Jianjun Wu ◽  
Zhi Huang ◽  
Mingyue Gao ◽  
...  

Traditionally, potholes are mainly paved for maintenance, and the asphalt mixture needs to be compacted. But due to the construction quality problem, the compacting degree of asphalt mixture may not be enough and the void ratio of asphalt mixture may not meet the requirements, resulting in the premature damage of the potholes after repair. If the repair material can be prefabricated, this problem will be well solved. So, based on the structure form of the prefabricated rapid maintenance of asphalt pavement, this paper aims to determine the most unfavorable loading position in pothole repair, which was established by the ANSYS software with the finite element model. The results show that the most unfavorable loading position of tensile stress for patch materials and joint filling material is C1-1 (A2-2) and the most unfavorable loading position of shear stress for joint filling material and leveling layer is B2-1 and C1-5. Subsequently, the influences of the material modulus, size, thickness, and modulus of the old pavement material on the potholes are calculated by using the finite element model under the most unfavorable loading position.


1989 ◽  
Vol 17 (4) ◽  
pp. 305-325 ◽  
Author(s):  
N. T. Tseng ◽  
R. G. Pelle ◽  
J. P. Chang

Abstract A finite element model was developed to simulate the tire-rim interface. Elastomers were modeled by nonlinear incompressible elements, whereas plies were simulated by cord-rubber composite elements. Gap elements were used to simulate the opening between tire and rim at zero inflation pressure. This opening closed when the inflation pressure was increased gradually. The predicted distribution of contact pressure at the tire-rim interface agreed very well with the available experimental measurements. Several variations of the tire-rim interference fit were analyzed.


1996 ◽  
Vol 24 (4) ◽  
pp. 339-348 ◽  
Author(s):  
R. M. V. Pidaparti

Abstract A three-dimensional (3D) beam finite element model was developed to investigate the torsional stiffness of a twisted steel-reinforced cord-rubber belt structure. The present 3D beam element takes into account the coupled extension, bending, and twisting deformations characteristic of the complex behavior of cord-rubber composite structures. The extension-twisting coupling due to the twisted nature of the cords was also considered in the finite element model. The results of torsional stiffness obtained from the finite element analysis for twisted cords and the two-ply steel cord-rubber belt structure are compared to the experimental data and other alternate solutions available in the literature. The effects of cord orientation, anisotropy, and rubber core surrounding the twisted cords on the torsional stiffness properties are presented and discussed.


Sign in / Sign up

Export Citation Format

Share Document