Sustainable use of municipal solid waste incinerator bottom ash and the treated industrial wastewater in self-compacting concrete

2021 ◽  
Vol 297 ◽  
pp. 123814
Author(s):  
Abolfazl Taherlou ◽  
Gholamreza Asadollahfardi ◽  
Amir Masoud Salehi ◽  
Ali Katebi
2020 ◽  
Vol 11 (1) ◽  
pp. 107
Author(s):  
B. Simões ◽  
P. R. da Silva ◽  
R. V. Silva ◽  
Y. Avila ◽  
J. A. Forero

This study aims to evaluate the potential of incorporating fly ash (FA) and municipal solid waste incinerator bottom ash (MIBA) as a partial substitute of cement in the production of self-compacting concrete mixes through an experimental campaign in which four replacement levels (i.e., 10% FA + 20% MIBA, 20% FA + 10% MIBA, 20% FA + 40% MIBA and 40% FA + 20% MIBA, apart from the reference concrete) were considered. Compressive and tensile strengths, Young’s modulus, ultra-sonic pulse velocity, shrinkage, water absorption by immersion, chloride diffusion coefficient and electrical resistivity were evaluated for all concrete mixes. The results showed a considerable decline in both mechanical and durability-related performances of self-compacting concrete with 60% of substitution by MIBA mainly due to the aluminium corrosion chemical reaction. However, workability properties were not significantly affected, exhibiting values similar to those of the control mix.


2021 ◽  
Vol 11 (14) ◽  
pp. 6396
Author(s):  
Joel R. Simões ◽  
Pedro R. da Silva ◽  
Rui V. Silva

With the objective of establishing a viable alternative to the use of cement, the main objective of this study is to verify the possibility of using municipal solid waste incinerator bottom ash (MIBA) as a partial cement replacement, thereby reducing the environmental impact associated with the use of concrete as a building material. To this end, self-compacting concrete (SCC) binary mixes of cement and MIBA were evaluated in their fresh and hardened state (i.e., self-compactability, mechanical and durability related performance). Four SCC mixes were produced to cover a wide range of replacement levels of cement with MIBA, namely: 20%, 30%, 40% and 50%. A fifth SCC mix, without MIBA, was produced with 30% fly ash to carry out a comparative analysis with composites with well-established performance. The results showed that the use of bottom ash from municipal solid waste incinerators caused an overall decline in the performance of self-compacting concrete. Apart from the smaller number of reactive phases in the bottom ash when compared with fly ash, which led to a slower rate of strength development, the decline was also caused by the increased porosity from the oxidation of aluminium particles. Nevertheless, the results showed promising indicators regarding the durability of mixes with 20% MIBA, with values very similar to those of reference concrete.


RSC Advances ◽  
2018 ◽  
Vol 8 (67) ◽  
pp. 38701-38705
Author(s):  
Qingna Kong ◽  
Jun Yao ◽  
Qian Yang ◽  
Dongshen Shen ◽  
Yuyang Long

A new approach including weathering treatment and nano-silica filling was employed to promote the engineering properties of municipal solid waste incinerator (MSWI) bottom ash.


Proceedings ◽  
2018 ◽  
Vol 2 (11) ◽  
pp. 651 ◽  
Author(s):  
Jakub Raček ◽  
Natalia Anferova ◽  
Petr Hluštík ◽  
Petr Hlavínek

Sludge disposal is becoming an issue at the municipal solid waste incinerator (MSWI), especially for environmental and economic reasons. This paper describes a case study of the optimization of the sludge management (SM) system at the MSWI in the Czech Republic. The original concept of SM at MSWI was designed as waste-free. However, the present operation indicates that there is a need to carry out regular extraction and disposal of sludge settling at the bottom ash tank and the bottom of the retention basin. The current status of SM causes problems not only in terms of operation but it also entails significant financial costs given the necessary regular cleaning of tanks. The aim of the applied research presented in this paper is SM optimization by a mobile sludge dewatering (DW) press unit with optimal polymer combination for DW.


2009 ◽  
Vol 166 (2-3) ◽  
pp. 1102-1108 ◽  
Author(s):  
Gaëlle Ducom ◽  
Daniela Radu-Tirnoveanu ◽  
Christophe Pascual ◽  
Belkacem Benadda ◽  
Patrick Germain

Sign in / Sign up

Export Citation Format

Share Document