Synthesis, structural, magnetic and electrochemical properties of LiNi1/3Mn1/3Co1/3O2 prepared by a sol–gel method using table sugar as chelating agent

2013 ◽  
Vol 113 ◽  
pp. 313-321 ◽  
Author(s):  
Nilüfer Kızıltaş-Yavuz ◽  
Markus Herklotz ◽  
Ahmed M. Hashem ◽  
Hanaa M. Abuzeid ◽  
Björn Schwarz ◽  
...  
Keyword(s):  
Electrochemical Properties ◽  
Sol Gel ◽  
Chelating Agent ◽  
Gel Method ◽  
Sol Gel Method

Effect of Synthesis Conditions on the Structure and Electrochemical Properties of LiNi1/2Mn1/2O2 by Sol Gel Method

2011 ◽  
Vol 399-401 ◽  
pp. 1447-1450
Author(s):  
Zhi Yong Yu ◽  
Han Xing Liu
Keyword(s):  
Electrochemical Properties ◽  
Sol Gel ◽  
Electrochemical Analysis ◽  
X Ray Diffraction ◽  
Capacity Fading ◽  
Gel Method ◽  
X Ray ◽  
Sol Gel Method ◽  
Synthesis Conditions ◽  
A Current

The layered LiNi1/2Mn1/2O2 cathode materials were synthesized by a sol gel method. The effects of calcination temperature and time on the structural and electrochemical properties of the LiNi1/2Mn1/2O2 were investigated. The prepared samples were characterized by X-ray diffraction (XRD) and electrochemical analysis. The results revealed that the layered LiNi1/2Mn1/2O2 material could be optimal synthesized at temperature of 900°C for 10h. The sample prepared under the above conditions has the highest initial discharge capacity of 151 mAh/g and showed no dramatic capacity fading during 20 cycles between 2.5-4.5V at a current rate of 20mA/g.

Enhancement of electrochemical properties of niobium-doped LiFePO4 /C synthesized by sol-gel method

2018 ◽  
Vol 65 (8) ◽  
pp. 977-981 ◽  
Author(s):  
Ao Jiang ◽  
Xinlu Wang ◽  
Musen Gao ◽  
Jinxian Wang ◽  
Guixia Liu ◽  
...  
Keyword(s):  
Electrochemical Properties ◽  
Sol Gel ◽  
Gel Method ◽  
Sol Gel Method ◽  
Niobium Doped

Improved electrochemical properties of (1 − x)LiFePO4·xLi3V2(PO4)3/C composites prepared by a novel sol–gel method

2015 ◽  
Vol 39 (11) ◽  
pp. 8971-8977 ◽  
Author(s):  
Yuanchang Si ◽  
Zhi Su ◽  
Yingbo Wang ◽  
Ting Ma ◽  
Juan Ding
Keyword(s):  
Electrochemical Properties ◽  
Discharge Capacity ◽  
Sol Gel ◽  
Initial Discharge Capacity ◽  
Gel Method ◽  
Sol Gel Method ◽  
Initial Discharge

0.8LiFePO4·0.2Li3V2(PO4)3/C composites were synthesized by a new sol–gel method, which delivered an initial discharge capacity of 158.7 mA h g−1 at 0.1C.

Fabrication of Bi-2223 Powders Using Sol-Gel Method

2011 ◽  
Vol 412 ◽  
pp. 125-128 ◽  
Author(s):  
Ming Ya Li ◽  
Xiao Yan Wang ◽  
Cheng Li Ye ◽  
Feng Lin Xue
Keyword(s):  
Heat Treatment ◽  
Sol Gel ◽  
Chelating Agent ◽  
Experimental Results ◽  
Main Phase ◽  
Gel Method ◽  
Sol Gel Method ◽  
Dwelling Time ◽  
Metal Nitrates ◽  
Gel Technique

The Bi-2223 powders were fabricated by the sol-gel technique. Metal nitrates were used as starting materials, and ethylenediamineteracetic acid was used as chelating agent. The solution was heated until it turns to gel. Then the organic was removed at a temperature of 240°C, and the nitrite was removed at 500°C. The powder was calcined at different temperature, varying the dwelling time. Experimental results show that the main phase of samples after heat treatment is Bi-2212 phase.

LiV3O8 NANOMATERIAL AS ANODE WITH GOOD CYCLING PERFORMANCE FOR AQUEOUS RECHARGEABLE LITHIUM BATTERIES

2011 ◽  
Vol 04 (04) ◽  
pp. 315-318 ◽  
Author(s):  
L. L. LIU ◽  
W. TANG ◽  
S. TIAN ◽  
Y. SHI ◽  
Y. P. WU ◽  
...  
Keyword(s):  
Electrochemical Properties ◽  
Anode Material ◽  
Lithium Batteries ◽  
Aqueous Electrolyte ◽  
Sol Gel ◽  
Cycling Performance ◽  
Cyclic Voltammograms ◽  
Rechargeable Lithium Batteries ◽  
Gel Method ◽  
Sol Gel Method

LiV3O8 nanorod material was prepared by a simple sol–gel method. The electrochemical properties of the as-prepared LiV3O8 in 0.5 M Li2SO4 aqueous electrolyte were studied through cyclic voltammograms (CV) and discharge–charge measurements. Experiments show that this nanorod material can deliver the capacities of 72, 62 and 53 mAh/g at 20, 50, 100 mA/g, respectively. After 50 cycles, it can maintain 64, 47 and 40 mAh/g, corresponding to 88%, 76% and 77% of the initial capacities, which suggest that this nanorode material presents good cycling performance as anode material for aqueous rechargeable lithium batteries.

Sign in / Sign up

Export Citation Format

Share Document