A detailed statistical study of heterogeneous, homogeneous and nucleation models for dissolution of waste concrete sample for mineral carbonation

Energy ◽  
2018 ◽  
Vol 158 ◽  
pp. 580-591 ◽  
Author(s):  
Muhammad Faisal Irfan ◽  
Muhammad Rashid Usman ◽  
Ajaz Rashid
2017 ◽  
Vol 166 ◽  
pp. 869-878 ◽  
Author(s):  
Alia Ben Ghacham ◽  
Louis-César Pasquier ◽  
Emmanuelle Cecchi ◽  
Jean-François Blais ◽  
Guy Mercier

2015 ◽  
Vol 163 ◽  
pp. 70-77 ◽  
Author(s):  
Alia Ben Ghacham ◽  
Emmanuelle Cecchi ◽  
Louis-César Pasquier ◽  
Jean-François Blais ◽  
Guy Mercier

Geosciences ◽  
2018 ◽  
Vol 8 (9) ◽  
pp. 342 ◽  
Author(s):  
Louis-César Pasquier ◽  
Nassima Kemache ◽  
Julien Mocellin ◽  
Jean-François Blais ◽  
Guy Mercier

Concrete is a major constituent of our world. Its contributes to building society but is also an important contributor to the global CO2 emissions. The combination of waste concrete recycling and greenhouse gas abatement is obviously an interesting approach. Mineral carbonation is the methodology that allows the use of calcium oxide within the concrete and transform it into carbonates with the CO2. Following previous results, carbonation experiments were performed using concrete paste extracted from a waste concrete sample after aggregate separation. The latter was performed after crushing and attrition followed by sieving to obtain three fractions. The coarser one composed of aggregates, the second of sand and the last, a fine powder of waste concrete paste (MCF). The MCF is then used in carbonation experiments in an 18.7 L stirred reactor with a diluted source of CO2 following previously optimized conditions. Different S/L ratios were experimented. The results show that 110 kg of CO2 can be stored per ton of MCF obtained after separation. Using the mass balance obtained from the experiments, an economic evaluation was performed on both aggregate separation and carbonation. While the first step can be profitable, using the MCF as a material for industrial flue gas abatement is less evident, both on the applicability and the feasibility.


1976 ◽  
Vol 32 ◽  
pp. 675-683
Author(s):  
Keiichi Kodaira

SummaryExcess of [m1] index of Am stars, relative to normal stars, is statistically found to be correlated with rotation velocity; the coefficient is estimated at ∆׀m1׀ /∆V(km/sec) ˜ - 0.0007 among Am stars. This result supports the general view that slow rotation is essential for Am phenomena.


Skull Base ◽  
2009 ◽  
Vol 19 (01) ◽  
Author(s):  
Mario Giordano ◽  
Wolf Luedemann ◽  
Lennart Stieglitz ◽  
Karsten Wrede ◽  
Laura Columbano ◽  
...  

TAPPI Journal ◽  
2009 ◽  
Vol 8 (1) ◽  
pp. 20-26 ◽  
Author(s):  
PEEYUSH TRIPATHI ◽  
MARGARET JOYCE ◽  
PAUL D. FLEMING ◽  
MASAHIRO SUGIHARA

Using an experimental design approach, researchers altered process parameters and material prop-erties to stabilize the curtain of a pilot curtain coater at high speeds. Part I of this paper identifies the four significant variables that influence curtain stability. The boundary layer air removal system was critical to the stability of the curtain and base sheet roughness was found to be very important. A shear thinning coating rheology and higher curtain heights improved the curtain stability at high speeds. The sizing of the base sheet affected coverage and cur-tain stability because of its effect on base sheet wettability. The role of surfactant was inconclusive. Part II of this paper will report on further optimization of curtain stability with these four variables using a D-optimal partial-facto-rial design.


1980 ◽  
Vol 42 (4) ◽  
pp. 665-669 ◽  
Author(s):  
Satoshi DEKIO ◽  
Yoshiko MAEHAMA ◽  
Reiko YAMASAKI ◽  
Kazuko HAMANAKA ◽  
Sanae IKEDA

Sign in / Sign up

Export Citation Format

Share Document