After a piezoelectric inkjet printhead jets the first droplet, the actuating membrane still vibrates, creating residual vibrations in the ink channel, which can degrade the inkjet printhead performance. For suppressing these vibrations, an optimized actuating voltage waveform with two pulses must be obtained, of which the first pulse is used for jetting and the second pulse is used to suppress the residual vibrations. In this study, the pressure history within the ink channel of a recirculating piezoelectric inkjet printhead was first acquired using lumped element modeling. Then, for suppressing residual vibrations, a bipolar voltage waveform was optimized via analysis of the tuning time (tt ), dwell time (td2), rising time (tr2), falling time (tf2), and voltage amplitude of the second pulse. Two voltage waveforms, Waveform 01 and Waveform 02, were optimized thereafter. In Waveform 01, tt=2 μs, td2=2 μs, and tr2 and tf2=1 μs were finalized as the optimal parameters; in the case of another waveform, the optimal parameters of td2, tr2, and tf2 were found to be 4, 1, and 1 μs, respectively. The optimal voltage amplitude of the second pulse was found to be 1/3 the amplitude of the first pulse. On the basis of our analysis, the tuning time in Waveform 01 is the most sensitive parameter, and the performance yielded is even poorer than that yielded by standard waveform, if not optimized. Therefore, the other waveform is recommended for the suppression of residual vibrations.
B-PO03-125 ADJUSTING ENDOCARDIAL UNIPOLAR VOLTAGE CUTOFFS BASED ON ENDOCARDIAL BIPOLAR VOLTAGE AMPLITUDE TO BEST IDENTIFY EPICARDIAL VT SUBSTRATE IN NONISCHEMIC CARDIOMYOPATHY (NICM)
