Experimental investigation of the global cavitation dynamic behavior in a venturi tube with special emphasis on the cavity length variation

2017 ◽  
Vol 89 ◽  
pp. 290-298 ◽  
Author(s):  
Xinping Long ◽  
Junqiang Zhang ◽  
Jiong Wang ◽  
Maosen Xu ◽  
Qiao Lyu ◽  
...  
1984 ◽  
Vol 28 (02) ◽  
pp. 90-106
Author(s):  
Jacques Verron ◽  
Jean-Marie Michel

Experimental results are given concerning the behavior of the flow around three-dimensional base-vented hydrofoils with wetted upper side. The influence of planform is given particular consideration so that the sections of the foils are simple wedges with rounded noses. Results concern cavity configuration, the relation between the air flow rate and cavity pressure, leading-edge cavitation, cavity length, pulsation frequency, and force coefficients.


2000 ◽  
Vol 43 (2) ◽  
pp. 283-292 ◽  
Author(s):  
Shuji NISHIYAMA ◽  
Norio UESUGI ◽  
Toru TAKESHIMA ◽  
Yuji KANO

2020 ◽  
Vol 21 (5) ◽  
pp. 504
Author(s):  
Qiang Li ◽  
Wei Li ◽  
Jian Zhang ◽  
Dezhi Ming ◽  
Weiwei Xu ◽  
...  

Hydraulic cavitation, as an important and complex hydrodynamic phenomenon, has long drawn attention. In this paper, the ZGB (Zwart-Gerber-Belamri) cavitation model is improved and the effect of NCG (noncondensable gas) on cavitation in water is studied by numerical simulation. The influence of NCG on the cavity length, the temperature of the cavities and the mixed viscosity of the cavities is investigated through the improved ZGB cavitation model. In addition, experiments on hydrodynamic cavitation produced by a Venturi tube are used to validate the improved ZGB cavitation model. The results show that NCG not only shortens the length of the cavity but also reduces the volume fraction of the vapor. The existence of NCG decreases the viscosity in the cavity of the Venturi tube but increases the viscosity at the sidewall of the tube. In addition, the temperature in the cavities increases with increasing NCG. Regardless of whether air is injected, the volume fraction of the vapor in the cavities increases first and then decreases with increasing temperature. However, the transition temperature decreases somewhat after injecting air. Therefore, the influence of NCG on hydraulic cavitation is significant, and the role of NCG should be considered in industry.


2011 ◽  
Vol 69 (1) ◽  
pp. 91-97 ◽  
Author(s):  
Zhan-yuan Zhu ◽  
Xian-zhang Ling ◽  
Zi-yu Wang ◽  
Qing-rui Lu ◽  
Shi-jun Chen ◽  
...  

2011 ◽  
Vol 1 (3) ◽  
pp. 032004 ◽  
Author(s):  
Xianfeng Chen ◽  
Yin Zhang ◽  
Qingming Zhang ◽  
Shaofeng Ren ◽  
Jianxing Wu

Sign in / Sign up

Export Citation Format

Share Document