scholarly journals Decreasing the ambulatory knee adduction moment without increasing the knee flexion moment individually through modifications in footprint parameters: A feasibility study for a dual kinetic change in healthy subjects

2020 ◽  
Vol 111 ◽  
pp. 110004
Author(s):  
Baptiste Ulrich ◽  
Killian Cosendey ◽  
Brigitte M. Jolles ◽  
Julien Favre
2016 ◽  
Vol 138 (2) ◽  
Author(s):  
Christopher Ferrigno ◽  
Ina S. Stoller ◽  
Najia Shakoor ◽  
Laura E. Thorp ◽  
Markus A. Wimmer

The objective of this work was to conduct a proof of concept study utilizing auditory feedback from a pressure-detecting shoe insole to shift plantar pressure medially in order to reduce the knee adduction moment (KAM). When compared with normal walking, 32 healthy subjects significantly reduced their peak KAM using feedback (p < 0.001). When compared with medial thrust gait, an established gait modification, walking with pressure-based feedback was equally effective at reducing the peak KAM, yet it successfully mitigated other potentially detrimental gait measures such as the peak knee flexion moment (KFM), knee internal rotation moment (KIrM), and a reduction in speed.


2001 ◽  
Vol 17 (2) ◽  
pp. 69-78
Author(s):  
You-Li Chou ◽  
Jia-Yuan You ◽  
Chii-Jeng Lin ◽  
Fong-Chin Su ◽  
Pei-Hsi Chou

ABSTRACTThis study investigates experimentally the velocity of the center of mass with respect to the base of support while subjects step on slippery flooring. The moments of the joints of both legs are also investigated to gain further insights into the source of any correlation found in reacting to slippery perturbation. Twenty-two healthy subjects dressed with safety harness walked first without and then with slippery perturbation, guided by a metronome at 120 steps/min and 90 steps/min cadence. Data were collected from a motion analysis system and force plates. Subjects falling had distinguishably slower velocity of center of mass with respect to the lead stance foot compared to the subjects maintaining balance at contralateral toe off. Larger knee flexion moment and ankle plantar flexion moment in the perturbed leg were found among subjects regaining balance. Faster velocity of center of mass with respect to base of support is noteworthy in subjects regaining balance from slippery perturbation. The response of lower extremities, especially about the thigh and leg in the lead stance limb, were important to improve the velocity of the center of mass with respect to base of support.


Author(s):  
Richard Allan ◽  
James Woodburn ◽  
Scott Telfer ◽  
Mandy Abbott ◽  
Martijn PM Steultjens

The knee adduction moment is consistently used as a surrogate measure of medial compartment loading. Foot orthoses are designed to reduce knee adduction moment via lateral wedging. The ‘dose’ of wedging required to optimally unload the affected compartment is unknown and variable between individuals. This study explores a personalised approach via three-dimensional printed foot orthotics to assess the biomechanical response when two design variables are altered: orthotic length and lateral wedging. Foot orthoses were created for 10 individuals with symptomatic medial knee osteoarthritis and 10 controls. Computer-aided design software was used to design four full and four three-quarter-length foot orthoses per participant each with lateral posting of 0° ‘neutral’, 5° rearfoot, 10° rearfoot and 5° forefoot/10° rearfoot. Three-dimensional printers were used to manufacture all foot orthoses. Three-dimensional gait analyses were performed and selected knee kinetics were analysed: first peak knee adduction moment, second peak knee adduction moment, first knee flexion moment and knee adduction moment impulse. Full-length foot orthoses provided greater reductions in first peak knee adduction moment (p = 0.038), second peak knee adduction moment (p = 0.018) and knee adduction moment impulse (p = 0.022) compared to three-quarter-length foot orthoses. Dose effect of lateral wedging was found for first peak knee adduction moment (p < 0.001), second peak knee adduction moment (p < 0.001) and knee adduction moment impulse (p < 0.001) indicating greater unloading for higher wedging angles. Significant interaction effects were found for foot orthosis length and participant group in second peak knee adduction moment (p = 0.028) and knee adduction moment impulse (p = 0.036). Significant interaction effects were found between orthotic length and wedging condition for second peak knee adduction moment (p = 0.002). No significant changes in first knee flexion moment were found. Individual heterogeneous responses to foot orthosis conditions were observed for first peak knee adduction moment, second peak knee adduction moment and knee adduction moment impulse. Biomechanical response is highly variable with personalised foot orthoses. Findings indicate that the tailoring of a personalised intervention could provide an additional benefit over standard interventions and that a three-dimensional printing approach to foot orthosis manufacturing is a viable alternative to the standard methods.


1997 ◽  
Vol 2 (3) ◽  
pp. 150-166 ◽  
Author(s):  
Lucie Brosseau ◽  
Michel Tousignant ◽  
Julie Budd ◽  
Nathalie Chartier ◽  
Louise Duciaume ◽  
...  

2020 ◽  
Vol 48 (5) ◽  
pp. 1117-1126 ◽  
Author(s):  
Jonas L. Markström ◽  
Helena Grip ◽  
Lina Schelin ◽  
Charlotte K. Häger

Background: Atypical knee joint biomechanics after anterior cruciate ligament reconstruction (ACLR) are common. It is, however, unclear whether knee robustness (ability to tolerate perturbation and maintain joint configuration) and whole body movement strategies are compromised after ACLR. Purpose: To investigate landing control after ACLR with regard to dynamic knee robustness and whole body movement strategies during sports-mimicking side hops, and to evaluate functional performance of hop tests and knee strength. Study Design: Controlled laboratory study. Methods: An 8-camera motion capture system and 2 synchronized force plates were used to calculate joint angles and moments during standardized rebound side-hop landings performed by 32 individuals with an ACL-reconstructed knee (ACLR group; median, 16.0 months after reconstruction with hamstring tendon graft [interquartile range, 35.2 months]) and 32 matched asymptomatic controls (CTRL). Dynamic knee robustness was quantified using a finite helical axis approach, providing discrete values quantifying divergence of knee joint movements from flexion-extension (higher relative frontal and/or transverse plane motion equaled lower robustness) during momentary helical rotation intervals of 10°. Multivariate analyses of movement strategies included trunk, hip, and knee angles at initial contact and during landing and hip and knee peak moments during landing, comparing ACLR and CTRL, as well as legs within groups. Results: Knee robustness was lower for the first 10° motion interval after initial contact and then successively stabilized for both groups and legs. When landing with the injured leg, the ACLR group, as compared with the contralateral leg and/or CTRL, demonstrated significantly greater flexion of the trunk, hip, and knee; greater hip flexion moment; less knee flexion moment; and smaller angle but greater moment of knee internal rotation. The ACLR group also had lower but acceptable hop and strength performances (ratios to noninjured leg >90%) except for knee flexion strength (12% deficit). Conclusion: Knee robustness was not affected by ACLR during side-hop landings, but alterations in movement strategies were seen for the trunk, hip, and knee, as well as long-term deficits in knee flexion strength. Clinical Relevance: Knee robustness is lowest immediately after landing for both the ACLR group and the CTRL and should be targeted in training to reduce knee injury risk. Assessment of movement strategies during side-hop landings after ACLR should consider a whole body approach.


2020 ◽  
Vol 142 (7) ◽  
Author(s):  
Shannon N. Edd ◽  
Sami Bennour ◽  
Baptiste Ulrich ◽  
Brigitte M. Jolles ◽  
Julien Favre

Abstract The purpose of this study was to determine the effects of modifying stride length (SL) on knee adduction and flexion moments, two markers of knee loading associated with medial-compartment knee osteoarthritis (OA) progression. This study also tested if SL modifications, in addition to foot progression angle (FP) and step width (SW) modifications, provide solutions in more subjects for reducing knee adduction moment (KAM) without increasing knee flexion moment (KFM), potentially protecting the joint. Fourteen healthy subjects (six female) were enrolled in this preliminary study. Walking trials were collected first without instructions, and then following foot placement instructions for 50 combinations of SL, FP, and SW modifications. Repeated measures analysis of variance was used to detect group-average effects of footprint modifications on maximum KAM and KFM and on KAM impulse. Subject-specific dose–responses between footprint modifications and kinetics changes were modeled with linear regressions, and the models were used to identify modification solutions, per subject, for various kinetics change conditions. Shorter SL significantly decreased the three kinetics measures (p &lt; 0.01). Potential solutions for 10% reductions in maximum KAM and KAM impulse without increasing maximum KFM were identified for five subjects with FP and SW modifications. A significantly higher proportion of subjects had solutions when adding SL modifications (11 subjects, p = 0.04). In conclusion, SL is a valuable parameter to modify, especially in combination with FP and SW modifications, to reduce markers of medial knee loading. Future work is needed to extend these findings to osteoarthritic knees.


Author(s):  
Ariel V. Dowling ◽  
Nathan Fenner ◽  
Thomas P. Andriacchi

Decreased symmetry in walking mechanics is common to many conditions associated with falling, such as muscle weakness, poor balance or flexibility, dizziness or vertigo, confusion, and vision problems [1]. Falls and the risk of falls have a substantial impact on the quality of life with aging. More than one in three adults over 65 years experience falls each year, and in half of these cases the falls are recurrent [2,3]. As patients with asymmetric gait are at a greater risk of falling during activities of daily living such as walking [1], conducting experiments on methods to correct gait asymmetries on this cohort can be potentially dangerous. However, experiments conducted with healthy patients that have an induced gait asymmetry during walking would minimize the risk to the unhealthy population while still allowing the researcher to test a subject with a gait asymmetry.


Sign in / Sign up

Export Citation Format

Share Document