Intermittently aerated EMMC-Biobarrel (entrapped mixed microbial cell with Bio-barrel) process for concurrent organic and nitrogen removal

2007 ◽  
Vol 84 (3) ◽  
pp. 257-265 ◽  
Author(s):  
E.S. Cho ◽  
J. Zhu ◽  
P.Y. Yang
2004 ◽  
Vol 49 (5-6) ◽  
pp. 281-288 ◽  
Author(s):  
S.J. Kim ◽  
P.Y. Yang

A two-stage entrapped mixed microbial cell (2SEMMC) process which separates nitrification and denitrification phases by the installation of the anoxic and oxic EMMC reactors packed with EMMC carriers was operated with 6, 4, 3, and 2 hours of hydraulic retention time (HRT) using simulated domestic wastewater. The activated sludge was immobilized using cellulose acetate for the EMMC carriers. Similar soluble chemical oxygen demand (SCOD) removal efficiencies of 90-97% were observed for all HRTs (SCOD loading rate of 0.84-2.30 g/L/d) applied. In order to achieve more than 80 % of TN removal efficiency, the HRT should be maintained higher than 4 hours (less than 0.24 g/L/d of TN loading rate). Denitrification was a rate-limiting step which controlled overall TN removal efficiency at TN loading rate of 0.15-0.31 g/L/d although nitrification efficiencies achieved 97-99 %. The effluent TSS of less than 25 mg/L in the 2SEMMC process was maintained at the SCOD loading rate of less than 1.23 g/L/d with back-washing intervals of 5 and 10 days in the anoxic and oxic EMMC reactors, respectively. The minimum HRT of 4 hours is required for high removal efficiencies of organics (average 95.6 %) and nitrogen (average 80.5 %) in the 2SEMMC process with 3 times of recirculation ratio.


1990 ◽  
Vol 22 (3-4) ◽  
pp. 343-350 ◽  
Author(s):  
P. Y. Yang ◽  
M. L. Wang

The primary goal of the research is to develop and evaluate a biological treatment system in which mixed microbial populations are physically immobilized by entrapment. The immobilized system was evaluated initially for its ability to remove simple benzene-based compounds from a synthetic wastewater as a model for treating pesticide-containing waters. Cellulose triacetate was used as the preparation of monocarrier and combined cellulose triacetate and calcium alginate were used for the preparation of bi-carrier. Phenol was used as substrate to test the entrapped mixed microbial cell process. Process performance including steady state, shock load and comparison of entrapped microbial cell process with and without entrapped microbial cell was investigated. It was concluded that the critical loading rate for phenol synthetic wastewater appeared to be 9 g COD/L/day. The COD removal efficiency could be maintained higher than 90%. Because of the low effluent suspended solid concentration, conventional-secondary-settling tanks could be eliminated. Also, the process could take both concentration and hydraulic shock loads of phenol synthetic wastewater successfully without the need of external sludge recycling. The equalization and external sludge recycling facilities equipped in the conventional wastewater treatment plant could be eliminated. When the process is operated only at low COD loading rate (less than 1.3 g/L/day), entrapped cells might not be required. However, when operated at higher loading rate, combined adsorbed and entrapped cells appeared to remove phenol more efficiently. For the application, mono-carrier (cellulose triacetate) is preferable to bi-carrier (cellulose triacetate and calcium alginate), since it is easier to prepare and the operational performance is better. Therefore, the application of packed-entrapped mixed microbial cell process for treatment of small-toxic-organic wastewater holds great potential.


2013 ◽  
Vol 52 (22-24) ◽  
pp. 4462-4468 ◽  
Author(s):  
Chug-Chun Liu ◽  
Kok-Kwang Ng ◽  
Chien-Ju Wu ◽  
Cheng-Fang Lin ◽  
Pui-Kwan Andy Hong ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document