Microstructure evolution and coercivity mechanism of hydrogenation-disproportionation-desorption-recombination (HDDR) treated Nd-Fe-B strip cast alloys

Author(s):  
Bin Ma ◽  
Xiaoqian Bao ◽  
Aizhi Sun ◽  
Jiheng Li ◽  
Xuexu Gao
2002 ◽  
Vol 49 (12) ◽  
pp. 1094-1097
Author(s):  
Koichiro Morimoto ◽  
Kenichi Kato ◽  
Kazunori Igarashi ◽  
Ryoji Nakayama

2020 ◽  
Vol 20 (5) ◽  
pp. 3119-3130 ◽  
Author(s):  
Bin Ma ◽  
Xiaoqian Bao ◽  
Aizhi Sun ◽  
Jiheng Li ◽  
Shuai Cao ◽  
...  

2009 ◽  
Vol 50 (3) ◽  
pp. 479-482 ◽  
Author(s):  
Takashi Hattori ◽  
Nana Fukamachi ◽  
Ryota Goto ◽  
Nobuki Tezuka ◽  
Satoshi Sugimoto

1992 ◽  
Vol 7 (12) ◽  
pp. 3235-3241 ◽  
Author(s):  
Y.F. Cheng ◽  
V. Hansen ◽  
J. Gj⊘nnes ◽  
L. Reine Wallenberg

The precipitation behavior, especially the early nucleation stages, of the industrial strip-cast Al3003 alloys was investigated by using transmission electron microscopy (TEM). An icosahedral quasicrystalline phase was found as secondary particles in these strip-cast alloys after heat treatment for a few seconds. Three different nucleation paths are proposed based on the TEM observations. They have the same origin, viz. (Mn, Fe)-containing Mackay icosahedra, and are governed by the composition of alloys, especially the Mn and Si content.


2014 ◽  
Vol 775-776 ◽  
pp. 534-537 ◽  
Author(s):  
João Pedro Tosetti ◽  
Gilberto Alvares da Silva ◽  
Jorge Otubo

Ni-Ti-Nb system alloys show wide shape memory hysteresis, suitable for assembly applications. The microstructure is composed by NiTi matrix (with some dissolved Nb) and Nb dispersed particles (with some Ni and Ti content). These particles are to cause the hysteresis widening. This work evaluates the microstructure evolution during wire fabrication process of equiatomic Ni and Ti alloys with increasing Nb content (1.5, 3.0, 6.0 and 9,0%at.). It is shown that as-cast alloys with up to 9% at.Nb and near equiatomic Ni:Ti relation show three main microconstituents: NiTi matrix phase, interdendritic eutectic phase (NiTi + β-Nb) and Ti3(Ni,Nb)2 compound precipitates. It was observed that NiTi matrix phase and eutectic phase (NiTi + β-Nb) have ductile behavior while Ti3(Ni,Nb)2 compound have fragile behavior. There was not much hardness variation during hot swaging (200-300 HV) due to recovery and recrystallization processes. Mechanical hardening prevailed as the mechanism for increase hardness of cold worked samples from 200 to 450 HV.


2020 ◽  
Vol 499 ◽  
pp. 166256 ◽  
Author(s):  
Yuanxiang Zhang ◽  
Xiang Lu ◽  
Guo Yuan ◽  
Yang Wang ◽  
Feng Fang ◽  
...  

2002 ◽  
Vol 396-402 ◽  
pp. 101-106 ◽  
Author(s):  
X.F. Yu ◽  
Tong Guang Zhai ◽  
X.M. Cheng ◽  
X.Y. Wen ◽  
Jiantao Liu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document