Three-Dimensional Volumetric Filling Ratio Predicts Stress Shielding in Short Stem Anatomic Total Shoulder Arthroplasty

2020 ◽  
Vol 29 (4) ◽  
pp. e163-e166
Author(s):  
Haluk Celik ◽  
Aakash Chauhan ◽  
Cesar Flores-Hernandez ◽  
Daryl D’Lima ◽  
Heinz Hoenecke
2018 ◽  
Vol 27 (1) ◽  
pp. 53-58 ◽  
Author(s):  
Patrick J. Denard ◽  
Matthew P. Noyes ◽  
J. Brock Walker ◽  
Yousef Shishani ◽  
Reuben Gobezie ◽  
...  

2018 ◽  
Vol 100-B (5) ◽  
pp. 603-609 ◽  
Author(s):  
M. Schnetzke ◽  
S. Rick ◽  
P. Raiss ◽  
G. Walch ◽  
M. Loew

Aims The aim of this study was to evaluate the clinical and radiological outcome of using an anatomical short-stem shoulder prosthesis to treat primary osteoarthritis of the glenohumeral joint. Patients and Methods A total of 66 patients (67 shoulders) with a mean age of 76 years (63 to 92) were available for clinical and radiological follow-up at two different timepoints (T1, mean 2.6 years, sd 0.5; T2, mean 5.3 years, sd 0.7). Postoperative radiographs were analyzed for stem angle, cortical contact, and filling ratio of the stem. Follow-up radiographs were analyzed for timing and location of bone adaptation (cortical bone narrowing, osteopenia, spot welds, and condensation lines). The bone adaptation was classified as low (between zero and three features of bone remodelling around the humeral stem) or high (four or more features). Results The mean Constant score improved significantly from 28.5 (sd 11.6) preoperatively to 75.5 (sd 8.5) at T1 (p < 0.001) and remained stable over time (T2: 76.6, sd 10.2). No stem loosening was seen. High bone adaptation was present in 42% of shoulders at T1, with a slight decrease to 37% at T2. Cortical bone narrowing and osteopenia in the region of the calcar decreased from 76% to 66% between T1 and T2. Patients with high bone adaptation had a significantly higher mean filling ratio of the stem at the metaphysis (0.60, sd 0.05 vs 0.55, sd 0.06; p = 0.003) and at the diaphysis (0.65 sd 0.05 vs 0.60 sd 0.05; p = 0.007). Cortical contact of the stem was also associated with high bone adaptation (14/25 shoulders, p = 0.001). The clinical outcome was not influenced by the radiological changes. Conclusion Total shoulder arthroplasty using a short-stem humeral component resulted in good clinical outcomes with no evidence of loosening. However, approximately 40% of the shoulders developed substantial bone loss in the proximal humerus at between four and seven years of follow-up. Cite this article: Bone Joint J 2018;100-B:603–9.


Orthopedics ◽  
2017 ◽  
Vol 40 (4) ◽  
pp. e721-e724
Author(s):  
Bryan M. Saltzman ◽  
Timothy Leroux ◽  
Michael J. Collins ◽  
Thomas A. Arns ◽  
Brian Forsythe

Author(s):  
Heath B. Henninger ◽  
Michael D. Harris ◽  
Kristen R. Petersen ◽  
Robert T. Burks ◽  
Robert Z. Tashjian

Scapular notching is a complication of reverse total shoulder arthroplasty (rTSA) that results in bone loss on the lateral border of the scapula. Notching has been reported in up to 86% of patients at 5 year follow-up [1], and is graded 1–4 as a function of progressive bone loss [2]. Notching may arise from impingement, erosion, periprosthetic osteolysis, stress shielding or a combination of these [1]. Glenosphere position can mitigate notching by limiting hardware impingement [3–5], but may increase the forces required to abduct the arm [6]. Clinicians might optimize patient range of motion and function via implant placement if susceptibility to notching was known a-priori.


2020 ◽  
pp. 175857322090890
Author(s):  
Robert Z Tashjian ◽  
Lindsay Beck ◽  
Irene Stertz ◽  
Peter N Chalmers

Background Computer assisted planning without patient specific instrumentation may be utilized to guide reverse total shoulder arthroplasty baseplate placement. The purpose of this study was to determine the difference between planned and achieved inclination and retroversion correction with three-dimensional preoperative computer assisted planning in reverse total shoulder arthroplasty without patient specific instrumentation with bone grafting for severe glenoid erosion. Methods Preoperative three-dimensional computer assisted planning without patient specific instrumentation was performed on 15 patients undergoing primary reverse total shoulder arthroplasty with glenoid bone grafting for severe glenoid erosion. On preoperative and immediate postoperative computed tomography slices, two-dimensional retroversion and inclination were measured. Preoperative three-dimensional baseline retroversion and inclination and planned postoperative three-dimensional retroversion and inclination were measured. Planned and achieved version and inclination changes were compared. Results The planned and achieved retroversion corrections were 18° and 12°, respectively (p < 0.001). The planned and achieved inclination corrections were 11° and 11°, respectively (p = 0.803). Conclusions Three-dimensional computer assisted planning without patient specific instrumentation in the setting of reverse total shoulder arthroplasty with severe glenoid erosion requiring bone grafting can accurately guide baseplate placement. All cases in which failure to correct retroversion or inclination within 10° of planning occurred in patients with severe erosion (B3 or E3 glenoids), therefore patient specific guides may be warranted in these cases to improve accuracy of implantation. Level of evidence Level IV, retrospective case series.


Author(s):  
Sascha Beck ◽  
Theodor Patsalis ◽  
André Busch ◽  
Florian Dittrich ◽  
Alexander Wegner ◽  
...  

Abstract Introduction Stemmed humeral implants have represented the gold standard in total shoulder arthroplasty (TSA) for decades. Like many other joints, the latest trends in TSA designs aim at bone preservation. Current studies have demonstrated that native proximal humeral bone stresses are most closely mimicked by stemless implants. Nevertheless, there are concerns about the long-term performance of stemless designs. The aim of the present study was to evaluate the long-term radiographic changes at the proximal humerus in anatomical stemless press-fit TSA. Materials and Methods Between 2008 and 2010, 48 shoulders in 43 patients were resurfaced using an anatomic stemless shoulder prosthesis (TESS, Biomet). Thirty shoulders in twenty-five patients who were aged 65.7 ± 9.9 (34 to 82) years were available for clinical and radiographic review at a mean follow-up of 94.0 ± 8.9 (78 to 110) months. Results Radiographic changes of the proximal humerus due to stress shielding were found in 38.4% of the stemless TESS implants. Mild stress shielding accounted for 80% of the observed radiographic changes. Radiographs exhibited stable fixation of the stemless humeral press-fit implant at early and late follow-up. In contrast, radiolucent lines at the glenoid implant were found in 96.1% of the cases. Irrespective of the degree of radiographic changes, clinical scores (VAS, Quick-DASH, Constant score) significantly improved at follow-up. Conclusions The anatomic stemless press-fit implant seems to be favorable in terms of implant-related stress shielding. Clinical outcome was not affected by radiographic changes, demonstrating an 8-year clinical performance that seems to be comparable to conventional stemmed TSA.


2017 ◽  
Vol 26 (8) ◽  
pp. 1477-1483 ◽  
Author(s):  
Birgit S. Werner ◽  
Robert Hudek ◽  
Klaus J. Burkhart ◽  
Frank Gohlke

Sign in / Sign up

Export Citation Format

Share Document