The detection of hazardous gases at different concentration levels at low and room temperature is still an actual and challenging task. In this paper, Al-doped ZnO thin films are synthesized by the electrochemical deposition method on the gold electrodes of AT-cut quartz resonators, vibrating at 10 MHz. The average roughness, surface morphology and gas sensing properties are investigated. The average roughness of Al-doped ZnO layers strongly depends on the amount of the doping agent Al2(SO4)3 added to the solution. The structural dependence of these films with varying Al concentrations is evident from the scanning electron microscopy images. The sensing properties to ethanol and ammonia analytes were tested in the range of 0–12,800 ppm. In the analysis of the sensitivity to ammonia, a dependence on the concentration of the added Al2(SO4)3 in the electrochemically deposited layers is also observed, as the most sensitive layer is at 3 × 10−5 M. The sensitivity and the detection limit in case of ammonia are, respectively, 0.03 Hz/ppm and 100 ppm for the optimal doping concentration. The sensitivity depends on the active surface area of the layers, with those with a more developed surface being more sensitive. Al-doped ZnO layers showed a good long-term stability and reproducibility towards ammonia and ethanol gases. In the case of ethanol, the sensitivity is an order lower than that for ammonia, as those deposited with Al2(SO4)3 do not practically react to ethanol.
Influence of Al Doping on the Morphological, Structural and Gas Sensing Properties of Electrochemically Deposited ZnO Films on Quartz Resonators
