Can density functional theory make use of experimentally determined ground-state electron densities via the Dirac density matrix for molecules of biological interest?

2007 ◽  
Vol 360 (6) ◽  
pp. 665-668 ◽  
Author(s):  
N.H. March ◽  
S. Suhai
2015 ◽  
Vol 17 (47) ◽  
pp. 31472-31479 ◽  
Author(s):  
Thomas L. Beck

A novel stochastic approach aimed at solving for the ground-state one-particle density matrix in density functional theory is developed.


2018 ◽  
Vol 33 (1) ◽  
pp. 71
Author(s):  
Ali Hashem Essa ◽  
A. F. Jalbout

The structural and electronic properties of 1-(5-Hydroxymethyl - 4 –[ 5 – (5-oxo-5-piperidin- 1 -yl-penta- 1,3 -dienyl)-benzo [1,3] dioxol- 2 -yl]- tetrahydro -furan-2 -yl)-5-methy l-1Hpyrimidine-2,4dione (AHE) molecule have been investigated theoretically by performing density functional theory (DFT), and semi empirical molecular orbital calculations. The geometry of the molecule is optimized at the level of Austin Model 1 (AM1), and the electronic properties and relative energies of the molecules have been calculated by density functional theory in the ground state. The resultant dipole moment of the AHE molecule is about 2.6 and 2.3 Debyes by AM1 and DFT methods respectively, This property of AHE makes it an active molecule with its environment, that is AHE molecule may interacts with its environment strongly in solution.


2009 ◽  
Vol 5 (4) ◽  
pp. 902-908 ◽  
Author(s):  
John P. Perdew ◽  
Adrienn Ruzsinszky ◽  
Lucian A. Constantin ◽  
Jianwei Sun ◽  
Gábor I. Csonka

Materials ◽  
2020 ◽  
Vol 13 (18) ◽  
pp. 3979
Author(s):  
Constantinos Simserides ◽  
Andreas Morphis ◽  
Konstantinos Lambropoulos

We investigate hole transfer in open carbynes, i.e., carbon atomic nanowires, using Real-Time Time-Dependent Density Functional Theory (RT-TDDFT). The nanowire is made of N carbon atoms. We use the functional B3LYP and the basis sets 3-21G, 6-31G*, cc-pVDZ, cc-pVTZ, cc-pVQZ. We also utilize a few Tight-Binding (TB) wire models, a very simple model with all sites equivalent and transfer integrals given by the Harrison ppπ expression (TBI) as well as a model with modified initial and final sites (TBImod) to take into account the presence of one or two or three hydrogen atoms at the edge sites. To achieve similar site occupations in cumulenes with those obtained by converged RT-TDDFT, TBImod is sufficient. However, to achieve similar frequency content of charge and dipole moment oscillations and similar coherent transfer rates, the TBImod transfer integrals have to be multiplied by a factor of four (TBImodt4times). An explanation for this is given. Full geometry optimization at the B3LYP/6-31G* level of theory shows that in cumulenes bond length alternation (BLA) is not strictly zero and is not constant, although it is symmetrical relative to the molecule center. BLA in cumulenic cases is much smaller than in polyynic cases, so, although not strictly, the separation to cumulenes and polyynes, approximately, holds. Vibrational analysis confirms that for N even all cumulenes with coplanar methylene end groups are stable, for N odd all cumulenes with perpendicular methylene end groups are stable, and the number of hydrogen atoms at the end groups is clearly seen in all cumulenic and polyynic cases. We calculate and discuss the Density Functional Theory (DFT) ground state energy of neutral molecules, the CDFT (Constrained DFT) “ground state energy” of molecules with a hole at one end group, energy spectra, density of states, energy gap, charge and dipole moment oscillations, mean over time probabilities to find the hole at each site, coherent transfer rates, and frequency content, in general. We also compare RT-TDDFT with TB results.


2019 ◽  
Vol 151 (13) ◽  
pp. 134102 ◽  
Author(s):  
Olajumoke Adeyiga ◽  
Olabisi Suleiman ◽  
Naveen K. Dandu ◽  
Samuel O. Odoh

2018 ◽  
Vol 71 (4) ◽  
pp. 295 ◽  
Author(s):  
Dylan Jayatilaka ◽  
Kunal K. Jha ◽  
Parthapratim Munshi

Formulae for the static electronic polarizability and hyperpolarizability are derived in terms of moments of the ground-state electron density matrix by applying the Unsöld approximation and a generalization of the Fermi-Amaldi approximation. The latter formula for the hyperpolarizability appears to be new. The formulae manifestly transform correctly under rotations, and they are observed to be essentially cumulant expressions. Consequently, they are additive over different regions. The properties of the formula are discussed in relation to others that have been proposed in order to clarify inconsistencies. The formulae are then tested against coupled-perturbed Hartree-Fock results for a set of 40 donor-π-acceptor systems. For the polarizability, the correlation is reasonable; therefore, electron density matrix moments from theory or experiment may be used to predict polarizabilities. By constrast, the results for the hyperpolarizabilities are poor, not even within one or two orders of magnitude. The formula for the two- and three-particle density matrices obtained as a side result in this work may be interesting for density functional theories.


Sign in / Sign up

Export Citation Format

Share Document